Bathmate and Newbies, How to Make Huge Gains Fast!

doublelongdaddy;694839 said:
You are going to get red spots with girth work, it is almost unavoidable but they are temporary and will fade over 24 hours. Using your BathMate I would stick with the SRT 5x5x3 routine and if this is too much you can trim time from it. As far as length goes, if you do not have the time to stretch you will want a SizeGenetics or Phallosan to do the work for you. Please look at the SRT thread and let me know if I can help further.
Click to expand...

Ok then I guess I can continue to pump. One thing I noticed.... I had a slight penile curvature prior to pumping (about 10-15°) and after 2 months I noticed that the curve is now around 25°.... Is it normal? That's why I'm planning to buy the extender, to help with the curvature but I heard that in order to be effective, you must were the device for 6-8h/day.... Is it true and how effective the extender is? Because I've been pumping since march and also do some stretching but I don't see any results at all beside the curvature.
 
split98;695065 said:
Ok then I guess I can continue to pump. One thing I noticed.... I had a slight penile curvature prior to pumping (about 10-15°) and after 2 months I noticed that the curve is now around 25°.... Is it normal? That's why I'm planning to buy the extender, to help with the curvature but I heard that in order to be effective, you must were the device for 6-8h/day.... Is it true and how effective the extender is? Because I've been pumping since march and also do some stretching but I don't see any results at all beside the curvature.
Click to expand...

The SizeGenetics was first created as a tool to straighten the penis in cases of peyronies disease. After it was released they realized it not only straightened the penis but it also made it longer. So yes, the SG is very effective with both length and straightening. I am not so sure that the BathMate is causing this curvature, usually, when curvature is desired men are directed to jelq, erect in the direction of the curve they desire. Could this be from jelqing do you thing?
 
split98;695515 said:
thanks. Here's the pics of my purple dots. What do you think?

View image: 2016 05 29 16 19 54
View image: 2016 05 29 16 22 46
View image: 2016 05 29 16 22 39
Click to expand...

Spotting and very normal. This can be reduced by warming up and down but in most cases, after a good session you will see temporary spotting. I was expecting a large bruise. These dots should fade within 24 hours. It is important to understand that in PE we are dealing with massive blood pressure against very thin skin, spotting will happen.
 
hey, i have had the bathmate for a long time now but just recently it has been working. Some days my balls get sucked in and i keep getting uncomfortable so i stop and try again for hours before just doing it again the next day. I'm trying to figure out how to get my cock swole efficiently and quickly, its been a goal of mine to reach for quite some time. I'm trying to follow your newbie technique with the stretches and pumping and kegels. how do i do this with no ball suction? please if you could be specific because I'm not really sure how to tie my balls or w.e.?
 
DesireB94;696819 said:
hey, i have had the bathmate for a long time now but just recently it has been working. Some days my balls get sucked in and i keep getting uncomfortable so i stop and try again for hours before just doing it again the next day. I'm trying to figure out how to get my cock swole efficiently and quickly, its been a goal of mine to reach for quite some time. I'm trying to follow your newbie technique with the stretches and pumping and kegels. how do i do this with no ball suction? please if you could be specific because I'm not really sure how to tie my balls or w.e.?
Click to expand...

This happens with some men and the best solution is to tie back the scrotum using ace. This will keep the balls out of the way and the penis in the tube. Some men opt for a bigger pump and pump the whole package, Redzulu came up with this method and had some good success.
 
doublelongdaddy;697235 said:
This happens with some men and the best solution is to tie back the scrotum using ace. This will keep the balls out of the way and the penis in the tube.
Click to expand...

Best solution, especially when doing Hardcore Stretches :)!
 
There's also one more way to get by the ball sucking effect. Doc Johnson TitanMen Cock Cage. (Can be found with titanmen cock cage search on google.)

I bought several of those and so far have cut one in half. A good fit for me to keep the balls away further away. I've also used a half inside the pump as a cock ring.
If cut in half, one could use one for balls and other for cock. Easy to slip on and off. I also use the half for after pump constriction.

Happy pumping!
 
Munto;697434 said:
Best solution, especially when doing Hardcore Stretches :)!
Click to expand...

Good to know men are using this method.
 
I've been using the bathmate for probably 3 months now. I've noticed by foreskin has grown a significant amount, also it feels thicker and is darker in color. What can I do to stop any more foreskin growth.

I do the 3x5x5 bm routine with ssq in between. I always get water retention no matter what especially with the vac u vin. I think the extra foreskin has made the retntion easier to get in my case. I use lube most times but that allows more foreskin to bunch up in the tube and made the foreskin eventually grow more. If I don't use lube then the skin on my shaft or scrotum will get caught on one edge of the the tube and causecpain.

I have tried tying the scrotum back using pump sleeves with and without lube, latex gloves. Overall I need to avoid any more foreskin growth which I really don't need.
 
You can pull down the foreskin and tape it down with sports prewrap before pumping. That should keep the area from expanding with fluid
 
Big Schwanz Acht;698209 said:
or you can cut the tip off a condom and roll it down as far as you wish to prevent WR
Click to expand...

Cheap and smart. There are also finger condoms in various sizes that may work a treat.
 
I received the X40 earlier this week, but quickly returned it for a refund as I think it was faulty. It leaked air bubbles even after adjusting the valve and other things mentioned on this site (cleaning etc.). I noticed that the part of the valve that holds the black pip is a small amount larger in diameter compared to my X30.

On the x40 I received the pip can move a small amount when inserted, I'm guessing that caused the air bubbles to seep in. On my x30 the pip can barely move at all when inserted meaning a completely air tight seal. I'm not sure whether that's an intentional design choice or whether it was a manufacturing error. So for now I've gone back to my x30 and am unsure whether I should get an x40 again as it may have the same problem. As the process of packaging it up and returning it is a hassle.
 
Spare;699853 said:
I received the X40 earlier this week, but quickly returned it for a refund as I think it was faulty. It leaked air bubbles even after adjusting the valve and other things mentioned on this site (cleaning etc.). I noticed that the part of the valve that holds the black pip is a small amount larger in diameter compared to my X30.

On the x40 I received the pip can move a small amount when inserted, I'm guessing that caused the air bubbles to seep in. On my x30 the pip can barely move at all when inserted meaning a completely air tight seal. I'm not sure whether that's an intentional design choice or whether it was a manufacturing error. So for now I've gone back to my x30 and am unsure whether I should get an x40 again as it may have the same problem. As the process of packaging it up and returning it is a hassle.
Click to expand...

I would ask for a new X40, that is what the Brotherhoods warranty is about, you busy here we take care of you.
 
I've been using my new x40 for 2 days now. At my max length expansion I can reach 7.5 inches on the gauge label, that's after using the vacu vin pump. For girth I have a lot of space width wise (maybe 1cm each side) but either the underside of my shaft or penis gland will touch the sides as my penis is curved upwards like a "U". No matter what angle I pump some part of my penis will touch the sides on the x40 surprisingly. Is the x40 suitable for me with these stats, as on the x30 I had a very small amount of space for girth and got pretty much the most gaiter bite you can possibly get (360 degrees) from my excess foreskin around the base and balls. At that 7.5inch mark the empty space above concerns me. I don't want to go overboard with the vacuvin as that has led to blood droplets appearing on various occasions.
 
Spare;700301 said:
I've been using my new x40 for 2 days now. At my max length expansion I can reach 7.5 inches on the gauge label, that's after using the vacu vin pump. For girth I have a lot of space width wise (maybe 1cm each side) but either the underside of my shaft or penis gland will touch the sides as my penis is curved upwards like a "U". No matter what angle I pump some part of my penis will touch the sides on the x40 surprisingly. Is the x40 suitable for me with these stats, as on the x30 I had a very small amount of space for girth and got pretty much the most gaiter bite you can possibly get (360 degrees) from my excess foreskin around the base and balls. At that 7.5inch mark the empty space above concerns me. I don't want to go overboard with the vacuvin as that has led to blood droplets appearing on various occasions.
Click to expand...

You can go with the VinVac but do not go so intense. You can even pump without it if that feels better. The main goal is expansion, so any way you can get expansion without issues.
 
I've had a drop of blood appear in the chamber on several occasions...it always occurred after a couple of days away from PE. My solution is to ramp-up slowly after any break longer than 24 hours, (it's just hard to be disciplined enough to not go straight to you personal best and beyond every session).
 
Big Schwanz Acht;700741 said:
I've had a drop of blood appear in the chamber on several occasions...it always occurred after a couple of days away from PE. My solution is to ramp-up slowly after any break longer than 24 hours, (it's just hard to be disciplined enough to not go straight to you personal best and beyond every session).
Click to expand...

Thats it my Brother, slowly ramp it up. When starting something new or attempting something where the results were less than satisfying, give yourself a lot of time to experiment and go progressively from gentle to intense. There are many steps in between these two states and there is where the progressiveness should be.
 
Big Schwanz Acht;700741 said:
I've had a drop of blood appear in the chamber on several occasions...it always occurred after a couple of days away from PE. My solution is to ramp-up slowly after any break longer than 24 hours, (it's just hard to be disciplined enough to not go straight to you personal best and beyond every session).
Click to expand...

Dude, that's like enhancement 101. Do EVERYTHING gradually, and if you see a problem slow down. Don't rush or overdo things or you can cause more harm than good.
 
You must log in or register to reply here.

Similar threads

B
Length stretches in Bathmate Hydromax
2 3
Replies
41
Views
3K
DLD
DLD
DLD
K
A beginner - ok routine?
Replies
3
Views
216
DLD
DLD
DLD
squirt_inducer_man
  • Sticky
Equipment modification Modifications to Bathmate® HydroXtreme models
Replies
7
Views
927
squirt_inducer_man
squirt_inducer_man
squirt_inducer_man
O
  • Sticky
Equipment modification Modification to Bathmate HydroXtreme 7 with a pressure gauge
2
Replies
26
Views
1K
O
oldandlively
O
A
What can i expect with this newbie routine
2
Replies
30
Views
840
T
TWIST&PULL
T
Back
Top Bottom