So far I haven't hacked the [words=http://TLCTugger.com/MOS]vlc[/words] [words=http://TLCTugger.com/MOS]tugger[/words]. I have been in communication with Ron and the customer service had been pretty good but what he has suggested so far hasn't worked so I have not been able to start reviewing the product.
OK SO GUYS I MADE A HUGE MISTAKE. Previously here in my log I thought I had hacked the [words=http://www.mattersofsize.com/forum/showthread.php?83577-Length-master-official-order-thread-now-shipping-06-16-2014!!!]lengthmaster[/words] by combining the [words=http://www.phallosan.com/shop/catalog/default.php?z=eNortjIxtVKyL0pNszWxMFcrSSxKTy2JL0hMT7U1UisoykyxtbBQSy4tLsnPjS8uKcrMS7dVsgZcMMpbEbo%2C]phallosan[/words] and the [words=http://www.mattersofsize.com/forum/showthread.php?83577-Length-master-official-order-thread-now-shipping-06-16-2014!!!]lengthmaster[/words]. It works somewhat but there is too much glan pressure to actually get a good stretch. So I went back to the drawing board and honestly the [words=http://www.mattersofsize.com/forum/showthread.php?83577-Length-master-official-order-thread-now-shipping-06-16-2014!!!]lengthmaster[/words] hadn't been getting any use for quite awhile until this morning. I figured it out finally.
Ok so I am going to uplad some pictures of my setup and then explain how I use the [words=http://www.mattersofsize.com/forum/showthread.php?83577-Length-master-official-order-thread-now-shipping-06-16-2014!!!]lengthmaster[/words]:
View attachment 31041
View attachment 31042
View attachment 31043
Ok so I'm not a huge fan of wrapping ... In fact I hate it. It takes too much time to put on and generally for me it it slides off. Yea, I could use some sports wrap and all other kinds of stuff but for me it makes more sense to do a wrap for the [words=http://www.mattersofsize.com/forum/showthread.php?83577-Length-master-official-order-thread-now-shipping-06-16-2014!!!]lengthmaster[/words]. So that's what I did. I found some foam around the house and wrapped it around the [words=http://www.mattersofsize.com/forum/showthread.php?83577-Length-master-official-order-thread-now-shipping-06-16-2014!!!]lengthmaster[/words] and made sure I got the edges. I know previously in this log I had mentioned wrapping the [words=http://www.mattersofsize.com/forum/showthread.php?83577-Length-master-official-order-thread-now-shipping-06-16-2014!!!]lengthmaster[/words] with [words=http://www.mattersofsize.com/forum/showthread.php?44-Ace-Strapped-Jims-Joint]ace bandage[/words]; however, the rubbing of the [words=http://www.mattersofsize.com/forum/showthread.php?44-Ace-Strapped-Jims-Joint]ace bandage[/words] against the skin feels terrible! I used duck tape on my wrap on just the edges so that there was not contact with my penis and the ducktape. In the last picture I showed using duck tape to keep the screws in their set position so that I wouldn't have to worry about turning them to make sure they were in the little square.
Applying the [words=http://www.mattersofsize.com/forum/showthread.php?83577-Length-master-official-order-thread-now-shipping-06-16-2014!!!]lengthmaster[/words]: SO Previously I thought you just slap the [words=http://www.mattersofsize.com/forum/showthread.php?83577-Length-master-official-order-thread-now-shipping-06-16-2014!!!]lengthmaster[/words] on and start pulling; however, what I found is that it is best to pull the slack out of your shaft skin and attach the [words=http://www.mattersofsize.com/forum/showthread.php?83577-Length-master-official-order-thread-now-shipping-06-16-2014!!!]lengthmaster[/words] close to your base (pelvic regions). If there is slack in the skin, the [words=http://www.mattersofsize.com/forum/showthread.php?83577-Length-master-official-order-thread-now-shipping-06-16-2014!!!]lengthmaster[/words] will likely slide off. For me attaching close to the base gives me more protection against the [words=http://www.mattersofsize.com/forum/showthread.php?83577-Length-master-official-order-thread-now-shipping-06-16-2014!!!]lengthmaster[/words] sliding off but interestingly enough attaching that low doesn't mean it stays there. When I attach low and tighten the [words=http://www.mattersofsize.com/forum/showthread.php?83577-Length-master-official-order-thread-now-shipping-06-16-2014!!!]lengthmaster[/words] down really good, I guess skin still has enough elasticisty that it goes maybe an inch under the glans and really locks in. I pulled for around two hours this morning, doing all the angles with the [words=http://www.mattersofsize.com/forum/showthread.php?83577-Length-master-official-order-thread-now-shipping-06-16-2014!!!]lengthmaster[/words], focused on bundled stretches and that sucker didn't slide off.
Well I guess now that I have figured out what works for me with the [words=http://www.mattersofsize.com/forum/showthread.php?83577-Length-master-official-order-thread-now-shipping-06-16-2014!!!]lengthmaster[/words], I will finally get around to making that review lol. Look out for it guys.