Sounds good. I can relate to that nervousness. It's like the penis doesn't like to be measured.
My balls sack wasn't loose enough and my erection was shit. My penis wasn't fully erect.
Sounds good. I can relate to that nervousness. It's like the penis doesn't like to be measured.
Okey.My balls sack wasn't loose enough and my erection was shit. My penis wasn't fully erect.
Oh I misunderstood your measurements. In that case, CONGRATULATIONS on the gains brother!! How awesome!!
So no stretching at all now? Isn’t it risky to suddenly stop it right away? I mean I’ve heard about people loosing gains that way but maybe the girth work will prevent that. Perhaps 1-2 length sessions a week will secure your length and don’t forget to keep wrapped up as well.
Yes go ahead and measure in centimeters, should be easier. It seems we have very similar measurements now, both length and girth, how cool! We should push each other to new levels brother! My goal is now 9” BPEL x 6.5” MSEG (maybe I’ll change it to 7”, girth seems to come easier for me I think)
It's 5 15/16. 1/16 more and he's at 6".
So 0.15875 centimeters more?
((1/16)/0.3937007874) = 0.15875 cm == 1.5875 millimeter ~ 1.6 millimeter left.
1 cm = 0.3937007874 inches
That's not much left until 6 inches
That's awesome.3 months of girth work will put me at 6 inches mid shaft.
I believe in you3 months of girth work will put me at 6 inches mid shaft.
I believe in you
AlwaysThank Boss. I appreciate that.
I think the water pump hardcore stretches are going to do the trick with girth.I will be doing 20 mins of jelqs right before my pumping session and I will be doing mityvac hardcore stretches for 10 minutes.
Even if I decide not to do any length work anymore, I will still gain a little more length let's say 0.25 from all the girth gains. I won't be wrapping my penis anymore. Instead, I will try to wear my cock ring for up to 3 hours with SSJs after every 1 hour of cock ring use.
My length measurement is over 8 inches. The tape measurement is not accurate for me. I need to measure my length again with a ruler and use one hand to straighten my penis while measuring. My last length measurement in 2020 was 8.25 inches and at that time, I was only gettting to 7.5 inches inside the bathmate. When I started using the mityvac, I was still at 7.5 inches inside as at January 2023 but now I'm at 7.75 inside the mityvac so there is no way my length will still be 8.25.
I've had sex this year with a mother of two kids. I like using loose pussy to test my length potential. I bottomed out in all positions but she took it all including temporary expansion from girth work. Since that night of sex, that lady has been on my neck asking for a rematch but I ghosted her.
I will start training tomorrow morning Wednesday 14th June 2023.
Girth work with mityvac hardcore stretches only with 20 mins of jelqs only henceforth.
I like SSJs because of the squeeze it causes to the entire area.I think the water pump hardcore stretches are going to do the trick with girth.
I think the water pump hardcore stretches are going to do the trick with girth.
For me it is a dual type exercise.Hardcore stretches is a length exercise.
AlwaysThank you!
Is there a video of these?Hardcore stretches is a length exercise.
Yes on the DVD in the main forumIs there a video of these?
Are they called Hardcore Stretches?Yes on the DVD in the main forum
They should beAre they called Hardcore Stretches?
For me it is a dual type exercise.
Any time I have used hardcore stretches it also increased temporary girth, so I think it might hit girth too.
Pp
Sometimes I have put on a cock ring and then done the hardcore stretches and gotten a good pump, plus you can just leave the ring on for a bit.
Just my thoughts on the exercise
Are they called Hardcore Stretches?
Gotcha. I've been doing these. Just didn't know what they're called. I pump it up to 35 kPa. Anything less and I'll pull it off. Found that was the magic number to keep it on there.It is very easy to perform the hardcore stretches. Get yourself erect and put your erect penis inside the pump. Pump to a high pressure and grab the pump, pull it like you are trying to pull it away from your body without reducing the suction.
Pull it straight out, to the left and right. It's easy.
Have you done behind the cheeks (behind ass) stretches with lengthmaster?I have the lengthmaster and bathmate and am 8x6.3 wanna get to to 9x7 any suggestions about a routine
I have the lengthmaster and bathmate and am 8x6.3 wanna get to to 9x7 any suggestions about a routine
I have the lengthmaster and bathmate and am 8x6.3 wanna get to to 9x7 any suggestions about a routine
I have done whole package pumping in the past, years ago before I knew a whole world of PE existed.
I have done whole package pumping in the past, years ago before I knew a whole world of PE existed.
What I remember though is that the whole ligament area really got pulled on and had I known about the hardcore stretches, I certainly would have used them.
I think like with any exercise though build up to it since your balls are also in the cylinder.
Happy growing brother!
I'm just curious @hugh-girth, are you still going for 9 Inch BPEL?
Okay awesome.Yes I am. I gifted my length master out. I hope to get a new one before the end of January.
@huge-girth, have done any training since July 1st?
Are you on a decon-break?I stopped training around 10th October. I intend to resume in January.
Are you on a decon-break?
ThanksYes brother.
Thanks
Great some else is going to get bigger whit the LM3..Yes I am. I gifted my length master out. I hope to get a new one before the end of January.
Great some else is going to get bigger whit the LM3..
He has gained over one inch in length ever since I gifted the length master to him.
That's funny, do guys buy extra Lengthmasters for themselves?Wonder if a member Mos member got an extra Lm3 to give away hehe
If the chamber broke you can get a replacement (by the Lifetime Warranty).I had one but the chamber got broken i only use it as a power assist.id like to buy one this coming year
As @squirt_inducer_man stated, Step up and take advantage of the Life-Time Warranty, you paid for it. It was built in the price of the product. Get the replacement part, you're "entitled" to it.I had one but the chamber got broken i only use it as a power assist.id like to buy one this coming year