Jamammoth;639746 said:
That's how you're supposed to do them. Be careful of how much pressure you apply.

lol:):):)
 
matko;639872 said:
From now on I will read everything from top to the bottom word after word :) my bad :p

Just playful banter:)
 
hellcock;468704 said:
my cock would break light switch covers. I actually broke these games. i need something harder.
and yeah, i think if i continue with it i should have a fater cock. i've only done it 3 times and i have seen some difference.


What a tragedy, the TMNT game is a classic.


For those of you video game enthusiasts out there who are looking to try this exercise, try this method:

x1 cable clamp
x2 N64 cartridges
x2 thick rubber bands
x6 large rubber bands [the size that usually goes around your newspaper]

This is like the standard frendo, only you're replacing the tiles with N64 cartridges and the clamps that keep them in place with rubber bands.


Start off with an erection. Clamp at the base, then get back to maximum engorgement.
Take two n64 cartridges and place them under and above the shaft respectively, leaving room for your glans to be exposed. Then take a large rubber band and stretch it over the end of one side of the cartridge sandwich, and do the same for the other side. Repeat this process again, and use the thick large rubber band as well. Then use two [or three] large rubber bands and stretch them over the cartridges horizontally.

You'll get an extreme pressure that you can safely control. These won't damage your cartridges either, so you can go back to playing another round of GoldenEye and Mario Kart after you're done. All you need to do is take the rubber bands off and then the clamp. It's recommended to do a warmup/warmdown before and after [preferably with a heating pad, moist/wet heat will most likely ruin the games, you want to do this dry.]


I managed to do this for a 15 minute and 30 minute session today for a total of 45 minutes of intense girth work. As always use caution when performing this method, but it's a nice alternative to tiles/extra clamps and definitely temporarily expands your width.
 
The rubberbands is actually a good idea and if you want more intensity you could add more rubber bands. But perhaps when doing this method one should have scissors nearby in case they need to cut the rubber bands and exit the compression quickly.
 
Last edited:
superman05xx;642550 said:
The rubberbands is actually a good idea and if you want more intensity you could add more rubber bands. But perhaps when doing this method one such have scissors nearby in case they need to cut the rubber bands and exit the compression quickly.

And be careful not to cut your cock:)
 
Again with the video game carts, come on?! While it was amusing to see those NES cartridges being used and still a bit funny to see a post about N64 cartridges, I just think it shouldn't be too expensive to acquire few pieces of clear strong see-through plastic plate. I mean, heck, I did and I don't even do this exercise very often!

So, guys, while it is a way to go around, stick those games to the machines, don't slap them on your cock, if anyway possible. For one thing; it's casing and hellcock mentioned he broke the NES cartridges. Under that cartridge is a gameboard, which can shatter if the casing breaks. No fun!
Another thing; you can't see through. Isn't that dull? For me it is. And it's also a safety thing, to monitor the color and intensity of the workout. It's very demanding workout after all!

Just my thought and opinion. I don't say your method doesn't create results, it seems very effective, just like Frendo's original exercise.
Lots of ways to do penile exercises. I'd just rather not see games being used for such, even though it can be necessary in the time of an invention.

Anyhow, keep on clamping!
 
arkailija;642978 said:
Again with the video game carts, come on?! While it was amusing to see those NES cartridges being used and still a bit funny to see a post about N64 cartridges, I just think it shouldn't be too expensive to acquire few pieces of clear strong see-through plastic plate. I mean, heck, I did and I don't even do this exercise very often!

So, guys, while it is a way to go around, stick those games to the machines, don't slap them on your cock, if anyway possible. For one thing; it's casing and hellcock mentioned he broke the NES cartridges. Under that cartridge is a gameboard, which can shatter if the casing breaks. No fun!
Another thing; you can't see through. Isn't that dull? For me it is. And it's also a safety thing, to monitor the color and intensity of the workout. It's very demanding workout after all!

Just my thought and opinion. I don't say your method doesn't create results, it seems very effective, just like Frendo's original exercise.
Lots of ways to do penile exercises. I'd just rather not see games being used for such, even though it can be necessary in the time of an invention.

Anyhow, keep on clamping!

Good advice...I love me some NES
 
arkailija;642978 said:



I can understand your concerns but I disagree with them.



"Again with the video game carts, come on?! "


This can be said about anything. "Again with the lengthmaster/power assist/size genetics/bathmate/clamps/rolling pins/toilet seats/hands, come on?!" I mean, really? If you found another method of using a household item or any object for PE and someone complained about it you'd be like: "What the fuck? Okay, I'll just enjoy my wide dick then. Thanks for reminding me that I shouldn't share any information whatsoever."


"I just think it shouldn't be too expensive to acquire few pieces of clear strong see-through plastic plate."

n64 cartridges aren't expensive either, vintage market dealers who specialize in them practically give them away. So many copies of sports games that nobody wants to own are just waiting for that dick. Besides, if you already own these items then you may as well use them, right? The GoldenEye/Mario Kart thing was a joke. What you really want is Super Mario 64 and Smash Bros.


"So, guys, while it is a way to go around, stick those games to the machines, don't slap them on your cock, if anyway possible. For one thing; it's casing and hellcock mentioned he broke the NES cartridges. Under that cartridge is a gameboard, which can shatter if the casing breaks. No fun! "


Hellcock used those big clamps to place a lot of pressure on the cartridges to the point where even in the pictures they looked like they were going to snap. That isn't the point of the n64 cartridge method. If I still had a camera I'd post a picture, but there's no way the rubber bands are creating enough pressure to snap the cartridges at all, and you can safely remove them with your hands.

"Another thing; you can't see through. Isn't that dull? For me it is. And it's also a safety thing, to monitor the color and intensity of the workout. It's very demanding workout after all!"


Three counterpoints:

1) You're still only doing this for a few minutes, this isn't one of those "Set It And Forget It" type deals. Of course you're gonna be monitoring your progress. You can even pull the cartridges in opposite directions, readjust the shaft and let the cartridge-sandwich push down on the clamped shaft again.


2) You can twist the shaft as if you're doing a bundle, and have the cartridges facing you vertically instead of horizontally. You'll be able to see the color of your shaft, and be able to touch it to feel whether or not it's turning cold.


3) n64 cartridges aren't that big anyway so there's definitely going to be some skin exposed, you're really working on the midshaft width as the base has the clamp on it and you want to leave about an inch of space before the glans.


"Lots of ways to do penile exercises. I'd just rather not see games being used for such"


That's a really weird gripe, man. Next thing you know you're gonna be yelling at DLD for telling people to use the toilet seat for his Toilet Compressors, especially since you can't see through them. "They're meant for people to sit on, that's why they were invented."


But hey if you feel uncomfortable attempting this then nobody is pointing a NES Zapper at you. Just kinda funny to see a response that both dismisses and encourages the idea without any attempt at the method. Of course it's stupid, when you think about it all PE is generally a stupid, sili thing and yet we do it anyway.
 
superman05xx;642550 said:
The rubberbands is actually a good idea and if you want more intensity you could add more rubber bands. But perhaps when doing this method one such have scissors nearby in case they need to cut the rubber bands and exit the compression quickly.


I feel like a few rubber bands is enough to do the trick. You want a certain amount to keep the device in place, and then a few more for that right amount of pressure that starts to flatten the girth on its own over a period of a few minutes.

Let's say this is the cartridge, [ ] and these are the rubber bands: | - & _

You'd want the first two rubber bands to go like this:


[| |]


Then this:


[|--|]

[||--||]

[||_-_-||]


placing maybe one or two more rubber bands over the first initial rubber band for the pressure.



So then you have this:

....O
....i i
[||==||]
...._


Which you can easily remove without pinching your skin or having to worry about getting it off in an emergency.
 
Great ideas, great discussion and great arguments TreasureHunter & arkailija.
DLD too ; D
The Originator DLD said:
And be careful not to cut your cock :)

Thoroughly enjoyed all those posts on this page.
I look forward to when I've finalised my length so I may 'beef up' the girth in earnest: 7"+ base to a 6.5-6.25 tip. Just what the sex doctor ordered.
 
The Originator's was one of the first groups JayZ worked with/
 
this Shane Diesel & Shorty mac width secret exercise, how much gain in width are we talking about in 6 month time ? any success storys ?
 
Commodore;644086 said:
this Shane Diesel & Shorty mac width secret exercise, how much gain in width are we talking about in 6 month time ? any success storys ?

Very old exercises but are still used in many routines. I am not sure how much anyone has gained alone with the exercises though.
 
superman05xx;650658 said:
I tried it the other day with the current length master and I couldnt get it to work

It can work if you use flat plates on both sides of the chamber that fit between the screw set. You could use any type of flat rigid plastic.
 
Back
Top Bottom