Ok guys. First tie is behind me. Long story short - I've put sewing thread with sewing needle in my dong's frenulum last saturday. After two days with no visible effects I thought it's too loose - Fortunately I got surgical stitches with 0.25mm single nylon thread, then I cut old stitch, and put new one in place. I've tied is as hard as I could - for few hours it was a little bit sore, but then it stopped. On thursday evening it started to pinch a little bit from time to time. Few hours ago it started to be pretty painfull when I pulled foreskin back to put my dong in a hot water. When I checked it closer(after 15minutes in hot saline) I could see frenulum clearly cut, but the stitch was still hanging on some "meat". I've grabbed an icecube, cooled down the area("great" anaestethic), and with gentle, but firm pull, I could rip stitch loop from flesh - pinched a bit (biggest pain of whole procedure, but still within reasonable level, like 4 or 5/10). The tie loop is 0.5mm in inner diameter.
Any tips for you?
1. Sterilise your equipment :
-I used 95% ethanol, 20minutes bath, dried it, and then used octenisept spray; isopropyl alcohol is good too (buy yourself good IPA , something like 99% pure). If you can't get yourself surgical sutures - use nylon fishing line - something close to 0.25mm (12kg stuff) will be good - smaller could rip during tying, bigger won't cut as fast;
2. Buy two surgical needle holders - it will help you to tie your stitches really tight - you won't get even close to that force and precision with bare hands (or with gloves); practice tying with your "new" toys before trying it on your "meat";
3. Clean area of surgery - use octenisept, or even better iodine based stuff;
4. Keep your dong clean - not only while tie works its way through(especially then), but always!
5. 4-5 times a day - hot saline bath - use medical saline, or make your own - big glass of hot water, 2 pinches of salt (or for folks with scales - make 0.9% NaCl solution), 10 - 15 minutes is good, after that go to point six:
6. Disinfect 4-5 times a day your dong while it has stitches, after disinfection - put some betadine ointment;
/saline bath, then disinfection, then put betadine ointment, and let it rest till next "bath"/
7. If you need to fap with the stitch on your dong - go ahead, but for biggus dickus sake, clean, and I mean CLEAN it afterwards, and disinfect for a good measure - why cleaning is so important after jerking off? Your cum contains a lot of proteins, and "rotting" proteins close to open/barely closed wound is the last thing you want do deal with!
8. Numb yourself - no pain mean better precision/accuracy, less stress, less shaking hands, and tighter stitch. If you are lucky, you can get EMLA, if you are less lucky, use some "joint pain relief" gel - aim for highest diclofenac content, and no additional cooling/heating ingredient, apply for two hours before procedure, then right before stitching put icecube for 30seconds, push needle through, and before finally tightening the suture, put that icecube again for 30 seconds. You can numb yourself (and your stress level) with some "soft" oral opioids like tramadol, codeine, etc. but forget about oral NSAIDs - it wont help much during procedure.
My first tie was finished after 6,5 days (two days into procedure, I had to replace first tie). I might post some photos tommorow.
Sorry for my bad english - I'm not native speaker.
Hope this will help someone.