For injecting into the tunica you would want to push the needle in and stop before it goes right through the tunica - easier said than done. When I was first injecting pge 1 I kept missing the cc I would feel a lot of pressure trying to push the plunger down on the slin pin. Yeah you would probably need 2 or 3 injections. I'm currently hanging in the downward fulcrum position using a rice sock with duct tape so the stress is mainly on the top side of my penis, therefore I probably only need to inject at the top. I will exhaust gains in this position then change to hanging over my shoulder with the rice sock on my pubic fat pad, this will create stress on the bottom of my penis. I don't know if this will work but I'm willing to give it a try in the hopes that I can come up with a quicker way to create length gains.
With the sub c injections I just pinch the skin on my penis an push the needle in a little bit, aspirate and then push the plunder down slowly. I'm thinking that this method will effect the very outside layers of the tunica.
I'll be trying an intra tunica injection today and will update later on if I was successful. I'll probably only try it in two positions - half way between the center and the side of my penis at the base on both the left and right sides. I might go for 300 mcg of tb4 into the penis and not bother with my scalp today.
To ensure that the PGE1 and tb4 is mixed evenly in the pin I will draw out 5 mcg of PGE1 then 150 of tb4 then 5 of PGE1 and finally another 150 of tb4. That way I can use the same syringe to pin both the left and right sides while ensuring that I get and equal amount of both chems into both sides.
With the sub c injections I just pinch the skin on my penis an push the needle in a little bit, aspirate and then push the plunder down slowly. I'm thinking that this method will effect the very outside layers of the tunica.
I'll be trying an intra tunica injection today and will update later on if I was successful. I'll probably only try it in two positions - half way between the center and the side of my penis at the base on both the left and right sides. I might go for 300 mcg of tb4 into the penis and not bother with my scalp today.
To ensure that the PGE1 and tb4 is mixed evenly in the pin I will draw out 5 mcg of PGE1 then 150 of tb4 then 5 of PGE1 and finally another 150 of tb4. That way I can use the same syringe to pin both the left and right sides while ensuring that I get and equal amount of both chems into both sides.