rocky1243;743038 said:
I wish... i wish my dick was the size it is in the tube. That would be plenty for me.

Yeah, right!
 
Todays routine

10 min pump in 1.75" Cylinder at 7 hg
edge 3 mins
10 min pump in 1.75" Cylinder at 10 hg
edge 3 mins
10 min pump in 2" Cylinder at 7 hg
edge 3 mins
clamp 10 mins
cock ring for dayzzzzzzzzzzzzzz

thats it
 
rocky1243;743142 said:
Todays routine

10 min pump in 1.75" Cylinder at 7 hg
edge 3 mins
10 min pump in 1.75" Cylinder at 10 hg
edge 3 mins
10 min pump in 2" Cylinder at 7 hg
edge 3 mins
clamp 10 mins
cock ring for dayzzzzzzzzzzzzzz

thats it

#RockyRoutineRocks :)
 
Big Schwanz Acht;743216 said:
I'm curious to see your pump-cylinders...snap a pic
4t7ryd.jpg

Its just a tube nothing special to it... never really understood why people spend $100.00 plus on cylinders maybe theres something I don't know. But I would think properly picking the right size of a tube is more important than brand... Anyways these are cheap and the build quality is solid, better than Leluvs.

Today I was lurking a penis pumping forum looking into routines or ways to maximize the gains from pumping. To my surprise I came a accross a thread by Kingsnake on that forum dated back to 2013 and then on that same thread there were several replies by the head dude on that forum regarding pumping describing his method, I believe his name was prelude99. This dude is in fact huge, perhaps not the most aesthetically pleasing dick but nonetheless if you look at his unpumped photos (which are hard to find) he did grow fairly proportional. Anyhow he did stress the need to use a tube just the right size to do his method called "Overpacking".

Essentially what you do in "overpacking" is pump in a tube where it would take you about 30 mins to fully pack (the girth). Then spend half the amount of time or the same amount of time at a lower pressure in the same tube completely packing it. The idea behind it is that once you pack the tube the stress will start to concentrate on the inner penis and push out the fluids from the skin. That stress in the inner penis is what will cause the penis to grow. I hope I explained that well, I am not entirely sure what he means or what the inner penis truly is. And none of us are scientist, but considering this dude has made insane gains it is worth a try.

So my routine today went like this, this is all using my 1.75" tube:

Edge 2 mins
10 mins 7-10 hg
Edge 2 mins
10 mins 7-10 hg (tube almost fully packed at this point)
Edge 2 mins
10 mins 7-10hg (tube fully packed)
Edge 2 mins
15 mins 5 hg (overpacking)
Cock ring

Thats it
 
Last edited:
maybe what he's trying to do by overpacking is convert the dermal expansion (what we associate as temporary gains) into tissue gains by virtue of constricting. I could logically see how that makes sense...the very nature of pumping w/air would require a remedy of some kind due to the uneven pressure and lack of density. We gotta have an egg-head scientist on here to perhaps give this 'overpacking' some credence, n'est pas?
 
Big Schwanz Acht;743230 said:
maybe what he's trying to do by overpacking is convert the dermal expansion (what we associate as temporary gains) into tissue gains by virtue of constricting. I could logically see how that makes sense...the very nature of pumping w/air would require a remedy of some kind due to the uneven pressure and lack of density. We gotta have an egg-head scientist on here to perhaps give this 'overpacking' some credence, n'est pas?

I mean the dude has been at it some 10 years or so and has made insane gains so that speaks for itself. I don't fuck with PEGym at all or Thunderfags, but this forum the people are actually friendly and helpful. Some a little gay though... Hopefully this info I reported from "the otherside" is good and can be of use to [words=http://www.mattersofsize.com/join-now.html]MOS[/words].

By the way I am not too sure about the unevenness of the pressure the dick does seem to expand proportionally filling up the tube simultaneously as it expands on the 1.75" tube. On the larger tube it is very uneven though, it expands at the base and tries to creep up. The size of tube definitely has something to do with it, maybe the tapering of the tube has something to do with it too.

I just wanna be like BSA when I grow up you know.... the old man got like 2 inches on me.

EDIT: I was casually touching macawk and the inner penis is actually pretty stiff and tender.
 
Last edited:
rocky1243;743229 said:
4t7ryd.jpg

Its just a tube nothing special to it... never really understood why people spend $100.00 plus on cylinders maybe theres something I don't know. But I would think properly picking the right size of a tube is more important than brand... Anyways these are cheap and the build quality is solid, better than Leluvs.

Today I was lurking a penis pumping forum looking into routines or ways to maximize the gains from pumping. To my surprise I came a accross a thread by Kingsnake on that forum dated back to 2013 and then on that same thread there were several replies by the head dude on that forum regarding pumping describing his method, I believe his name was prelude99. This dude is in fact huge, perhaps not the most aesthetically pleasing dick but nonetheless if you look at his unpumped photos (which are hard to find) he did grow fairly proportional. Anyhow he did stress the need to use a tube just the right size to do his method called "Overpacking".

Essentially what you do in "overpacking" is pump in a tube where it would take you about 30 mins to fully pack (the girth). Then spend half the amount of time or the same amount of time at a lower pressure in the same tube completely packing it. The idea behind it is that once you pack the tube the stress will start to concentrate on the inner penis and push out the fluids from the skin. That stress in the inner penis is what will cause the penis to grow. I hope I explained that well, I am not entirely sure what he means or what the inner penis truly is. And none of us are scientist, but considering this dude has made insane gains it is worth a try.

So my routine today went like this, this is all using my 1.75" tube:

Edge 2 mins
10 mins 7-10 hg
Edge 2 mins
10 mins 7-10 hg (tube almost fully packed at this point)
Edge 2 mins
10 mins 7-10hg (tube fully packed)
Edge 2 mins
15 mins 5 hg (overpacking)
Cock ring

Thats it

Killing it as usual Rocky
 
beautiful

i do somewhat a bit of overpacking but only during my [words=https://officialhydromaxpump.com/?uid=6&oid=2&affid=98 ]BM[/words] breaks no more than 1-2 minutes between sets. the low pressure is usually my break. but i would think 30mins of overpacking in a low pressure would probably contribute to girth gains because similar to a cock-ring after a girth session you are prolonging an expanded state.

the [words=https://officialhydromaxpump.com/?uid=6&oid=2&affid=98 ]BM[/words] doesn't have a gauge, but i hold it at about 40% intensity, but i can't say if doing it for a few minutes between sets is enough to cause more gains, i just do it for suction purposes

so far i would attribute my girth gains, EQ gains and skin expansion to the 90%-max intensity routine along with the number of sets, although overpacking sounds like a decent possibility for more gains
 
Today's Routine

First on the 1.75" diameter tube

2 mins edge
15 mins 6-7 hg
2 mins edge
15 mins 6-7 hg
2 mins edge
30 mins 3 hg
2 mins edge
30 mins 3 hg

then I moved up to the 2" diameter tube anf almost fully packed it

2 mins edge
15 mins 5 hg
2 mins edge
15 mins 5 hg
2 mins edge
15 mins 2 hg

Cock ring for dayzzzz
 
hey Rock, just curious...have you ever attempted hanging while inside one of your cylinders and using the suction to stay 'attached'? If someone was able to create an 'anchor-point' on my [words=https://officialhydromaxpump.com/?uid=6&oid=2&affid=98 ]BM[/words] where I could hang some weights, I'd give it a go...I'm imagining those baseball bat donuts/weights but for my [words=https://officialhydromaxpump.com/?uid=6&oid=2&affid=98 ]BM[/words].
 
Big Schwanz Acht;743461 said:
hey Rock, just curious...have you ever attempted hanging while inside one of your cylinders and using the suction to stay 'attached'? If someone was able to create an 'anchor-point' on my [words=https://officialhydromaxpump.com/?uid=6&oid=2&affid=98 ]BM[/words] where I could hang some weights, I'd give it a go...I'm imagining those baseball bat donuts/weights but for my [words=https://officialhydromaxpump.com/?uid=6&oid=2&affid=98 ]BM[/words].

I have not tried hanging, I do feel I definitely get enough suction to do it I just wonder how to attach the weights to the tube. Also if you did that idk if you are gripping the "inner penis" or just stretching the skin. Thats why I am not sold on vacuum hangers, I imagine it pulls your dick from the skin instead of truly gripping it as a compression hanger would.
 
rocky1243;743472 said:
I have not tried hanging, I do feel I definitely get enough suction to do it I just wonder how to attach the weights to the tube. Also if you did that idk if you are gripping the "inner penis" or just stretching the skin. Thats why I am not sold on vacuum hangers, I imagine it pulls your dick from the skin instead of truly gripping it as a compression hanger would.

good point, but doing expressive stretches while in the cylinder are essentially the same thing as hanging and I definitely feel an 'inner stretch' doing those
 
Big Schwanz Acht;743474 said:
good point, but doing expressive stretches while in the cylinder are essentially the same thing as hanging and I definitely feel an 'inner stretch' doing those

Gotcha, I milk my tube (pulling it away from the body) to maintain an erection. And I do feel the pull, but I still stand by my opinion. Compression hangers is the way to go.
 
Todays routine:

Used only my 1.75" tube

edge 2 min
15 min 5 hq packed 85%
edge to min
15 min pulse 5-15 hq - tube packed 95% theres some spots I dont think I will ever get to, particularly near the base under part.
edge 2 min
30 min 3 hq (overpacking at this point)
edge to min
15 min 3 hq (still overpacking)
cockring

my eq has just sky rocketed, my expansion feels solid... not as solid as a boner but not too far off and this only comes after the overpacking portion before that it is kinda mushy. Low pressure fully packed tube for longer periods of time is where the magic happens.

I am excited, I can actually see the progress with pumping. So I will do this for a month and report results. Pumping only routine, testing this "Overpacking" theory out in the name of science of course.

My starting measurements as of Friday was 4.75" mid shaft erect girth and 6.125" none bone pressed erect length. I am calling the official start date 10/20/2017 which is where I really started over packing and had my pumping routine down. Lets see what happens in a month!
 
Last edited:
Todays routine:

Used only my 1.75" tube

edge 2 min
15 min 5 hq packed 85%
edge to min
15 min pulse 5-15 hq - tube packed 95% theres some spots I dont think I will ever get to, particularly near the base under part.
edge 2 min
30 min 3-5 hq (overpacking at this point)
edge to min
30 min 3-5 hq (still overpacking)
cockring
 
Looking really good Rocky! Updates are awesome and some really hard work. I hope to see some incredible numbers in your future.
 
doublelongdaddy;743608 said:
Looking really good Rocky! Updates are awesome and some really hard work. I hope to see some incredible numbers in your future.

Thanks DLD I hope so too, I just want to get bigger than BSA now. It fucking ticks me off that the old man has a bigger dick than me.
 
Help Users

You haven't joined any rooms.

    You haven't joined any rooms.
    Back
    Top