Dorsay;434977 said:
Thanks for all the advice my friend! It has been very helpful to me. I haven`t had time to buy velcro strips yet, but I`ll do it. How do you increase the tension without taking the head piece off? It says in the manual to slowly push the elongation bars but it doesn`t go...

You can increase tension in 2 ways:
1 slide the outer bars forward one notch like they talk about, one at a time til it clicks into the next hole.
2 move the head piece forward one notch on the outer bars.

Either way, you do need the outer bars out 2 or more notches on the inner bars to get any spring effect. So you either start with them at 2 or more notches out, or move them out once head piece is attached. Otherwise you get no spring. Then to add tension, you use one of the two methods (or both) above.
 
Did a measurement today also-with little expectation due to my fucking up the whole last week lol.

I was right: No gain on length, but I guess at least I didn't lose any.... I'm still at 6.5" NBPenis EnlargementL

However.... I've gotten good GIRTH GAINS!! I measured in at 5.75" MSEG at maybe 90% erection.

So I'm really pleased with that-that's a 1/2" MSEG Gain in just 3 months. From what I've read, that's pretty good and fortunate. So I can't whine about the lack of length gain too much-but hopefully I'll get more determined on the extender!!
 
K I did adequate yesterday finally... and I do think that week of fucking around cost me as I've had no increase in length and am probably lucky I didn't lose some of my previous gains (still at 6.5" NBPenis EnlargementL).

Did 400 jelqs in the morning, but tried to do longer ones, like 3 seconds instead of fast jelqs. They strike me as more dangerous and I did get a red spot. So I think I'll keep mixing it up.
Also 3 Ulis

Extender:

3 sessions @ 1.5H each for a total of 4.5H
2400g
7.5" for first 2, finally got back to 8.0" on 3rd session.


About an hour after the last session I also did some half assed clamping for 10 minutes with my jelly cock ring-it looked purty.
The fact that the SL went down also tells me that I lost gains. I was up to 8.25" the week before, and dropped all the way down to 7.5" SL... I'm sure there is SOME correlation between EL and SL, has to be. That kind of sucks as you can waste your gains if you don't keep consistent. Hopefully I don't fuck up for more than 2 days from now on
 
6/2/11:

500 wet jelqs, 3 ULIs

1 1/2 HR in extender
7.75"
@2400g

6/3/11

500 wet jelqs, 3 ULIs

4H in extender
2400g
7.5" - 8.0"


Kind of in a rush, so no commentary for this two days :)
 
Well when things are Blue I do not worry but when things are red I get a bit of anxiety:)
 
just 2 pieces of gauze. one soft for the inside, maybe 4-5 wraps, it's very thin. Then thick gauze on 2nd layer, maybe 1 1/2 around.
 
Nothing to report for the last 2 days. It was basically a long work out, I'm thinking I probably better take a day off.
 
K, still recovering from last weekend and the first Penis Enlargement I've done since was some light jelqing this morning.

On the bright side-my wife and I have been talking to this girl we might hook up with. And the wife was talking to her and they were trading pics and she showed her some pics of my cock. The girl was saying it was huge and so forth and now the girl is calling me "mr. big". Gotta like that, and it inspires me to keep going :)
 
K, I'm starting fresh again tomorrow. But I think I'm going to end the daily part of the log as it's basically just me talking to myself lol. It might as well just be private on my computer.
I'll just go back to posting measurements once a month or something.
 
Hi Crazy_doc, hows the progress going...been following your blog on the Male edge since i also have one but seem "stuck" at 7inch extended stretched lenght.....stretched at 2000g in the male edge about 4 - 6hrs per day 4days a week. Will incorporate some jelqing maybe that will "raise the bar" hehe!
 
Hi Crazy Doc. Been a bit of a while since I posted here asking about the wrapping issue with this device (due to a huge lack of routine in my life the past few months, which is going to stop!) and I was wondering about this velcro mod you were talking about. You couldn't share a link with me where you found out how to do this could you?

Homeslice x
 
homeslice;437787 said:
Hi Crazy Doc. Been a bit of a while since I posted here asking about the wrapping issue with this device (due to a huge lack of routine in my life the past few months, which is going to stop!) and I was wondering about this velcro mod you were talking about. You couldn't share a link with me where you found out how to do this could you?

Homeslice x

Hi Homeslice, you can find 2 versions of it.
One by J1L here (this is the original and was for SG)
http://www.mattersofsize.com/forum/attachment.php?attachmentid=23277&d=1296242378

And here is the one I modified off J1L's design, and it was for the Male Edge. Between the 2 diagrams, you should be able to get it going.
In mine, you'll find steps to do it with pictures in posts 30 and 32:
http://www.mattersofsize.com/forum/...ion-Velcro-Strap-by-J1L&highlight=velcro++j1l
 
Haven't done any extending lately-just haven't felt well and it takes some focus and determination that I'm lacking. Have continued to jelq though and continue to see gains.

I recently measured again and I'm at
MSEG: 6.0"
And I also hit 2.0" in diameter...

I was wondering... so how do I "cement" or at least maintain jelqed girth gains like this? I'm going to keep going and try to hit 6.5" MSEG and then I better stop before it won't fit in a mouth anymore :)
 
cocky_r;437694 said:
Hi Crazy_doc, hows the progress going...been following your blog on the Male edge since i also have one but seem "stuck" at 7inch extended stretched lenght.....stretched at 2000g in the male edge about 4 - 6hrs per day 4days a week. Will incorporate some jelqing maybe that will "raise the bar" hehe!

I got up to 8.25" (I'm at 6.5" NBPenis EnlargementL, so I stretch about 1.75" past my EL). 4-6 hours is tough isn't it?? Especially at high tension. The only thing I did different, was that I was taking zero days off (well, not completely true, but maybe at most 1 day off per week and only by necessity not design) and also was doing 2400g on average. So if you're stuck on stretched length, I'd quit taking days off or cut it down to 2 days and not 2 days in a row, so like 3 on 1 off, repeat. And I'd increase the tension a bit if you can. I also noticed variances though, sometimes it would be smaller, other times a recent ejaculation would cut down the length as well. But overall, consistently led to a more consistent increased stretched length. Hope that helps!
 
thanks for the advise crazy doc. also experienced not being able to stretch to the point pre ejaculation. found that i need to wait a couple hrs to get a good stretch. can testify that this traction stretching gives me wood like none. hard not to wank off hehe

will follow your advise on increasing tension and taking less days off....will report back. thanks again for a very informative post.
 
hey crazydoc. Firstly I'd like to say thanks for the velcro mod. It's awesome! Unfortunately though I have managed to break part of the male edge by the look of things. I pushed the teloscopic tubes towards my body when it wasnt attached to my penis and the measurement bit is completely stuck in the tubes. Any suggestions as to how to fix this?
 
On the side of the inner tube, you'll see a little dot (clear plastic) and you have to push that in to get the inner rod to come off of the clear plastic piece. These can stick a little but what happened to you didn't happen to me yet. But sounds like something might have gotten torqued. Try releasing the inner rod like I said, by pushing the dot in (maybe you have to push it in on both sides (there's a dot on both sides) I forget-but if you can get it off, I bet you can fix the problem

Glad you're enjoying the velcro mod :)
 
Back
Top Bottom