AF3

0
Registered
Joined
Jun 16, 2011
Messages
358
The SizeGenetics seems damn effective and it seems like a really great device. I just wish I could wear it for more than 25 minutes at a time without the pain in my glands being so bad that I can't think straight (this is actually my litmus test.) It's fine for the first ten minutes, I start to notice it after about fifteen, and then by the time 25 rolls around the head of my dick is a mixture of pain and numbness when I take off the SG.

I've bought the Tugger. My lack of foreskin makes it currently unusable.

I've used the Velcro Mod. I've used both soft and hard Velcro for the Velcro mod.

I've tried wrapping with all of the following when I use the Velcro Mod:

Ace Bandage
Cotton
A sock!
Cloth

I've used many of these wraps in combination with each other and I still get the same result.


I just want a solution that will work so I can wear the thing for at least 40 minutes at a time without feeling like my dick is going to fall off. I honestly feel like I've tried everything with the SG and I'm kind of stuck. In no way am I giving up, but I'm really at a loss for what to do.

I know that Supra suggested the canister method for the Tugger. I appreciate the help, but given that I've spent about an hour per day for the last two weeks just trying out different methods and wraps with the SG (in addition to buying the Tugger), there's just no way
I'm going to buy this and the extra SG bars I would have to buy with it at the moment.



AF
 
Well, this might not be the direction you wanna take, but have y'ever thought of a light coat, (dab or two) of some good ol' Oragel around the affected area(s) ?
Might not be a permanent solution but could just ya help muscle through a tough spot while yer gettin' used to the thing.
 
I mean my main concern is that only wearing the SG for 20-25 minutes at a time will reduce it's effectiveness. If I had to go in 20 minute cycles with a one minute break to BTC stretch and then reapply, I would be willing do this 30 times a day if that's what it took to get the required time under tension. Do you think that would be effective?


20 Minutes in SG
BTC Stretch 2 x 30 Seconds
Repeat
 
I'm looking up what you suggested now. It's an interesting idea, but wouldn't applying something like Oragel run the risk of reducing sensitivity over the long haul?
 
By the way I just realized what's causing the pain. It's the Velcro Strap pushing into the base of my glans as the stretch wears on if that makes sense. Should I just apply the headpiece lower down my shaft and take a reduction in the length I can stretch with the SG for now?
 
Damn glad you found the cause, I've never worn an SG so you'd have to go find somebody with real experience.
I DO know, however, that a lot of guys have had the same complaint about pain and finding the right wrap technique and fabric always seems to be the key to best comfort.

Search on here for fedora.
He did some damn fine work and some damn good documentation of it.
 
AF3;527547 said:
The SizeGenetics seems damn effective and it seems like a really great device. I just wish I could wear it for more than 25 minutes at a time without the pain in my glands being so bad that I can't think straight (this is actually my litmus test.) It's fine for the first ten minutes, I start to notice it after about fifteen, and then by the time 25 rolls around the head of my dick is a mixture of pain and numbness when I take off the SG.

I've bought the Tugger. My lack of foreskin makes it currently unusable.

I've used the Velcro Mod. I've used both soft and hard Velcro for the Velcro mod.

I've tried wrapping with all of the following when I use the Velcro Mod:
Ace Bandage
Cotton
A sock!
Cloth

I've used many of these wraps in combination with each other and I still get the same result.


I just want a solution that will work so I can wear the thing for at least 40 minutes at a time without feeling like my dick is going to fall off. I honestly feel like I've tried everything with the SG and I'm kind of stuck. In no way am I giving up, but I'm really at a loss for what to do.

I know that Supra suggested the canister method for the Tugger. I appreciate the help, but given that I've spent about an hour per day for the last two weeks just trying out different methods and wraps with the SG (in addition to buying the Tugger), there's just no way
I'm going to buy this and the extra SG bars I would have to buy with it at the moment.



AF

You can make the canister out of a film case and then bend a hanger wire to act as the hook. Then all you need is tape. Get the whole project done for less than $10

http://www.tlctugger.com/downloads/UsingtheCanisterMethod.pdf
http://tlctugger.com/prodCK.htm
 
Thanks Supra. I just applied the headpiece lower down the shaft and that seems to have solved the problem.
 
Yeah I was really pushing hard to stretch past EL and when I would get into the device with that many rods on, the strap would end up right beneath my glands. As the stretch wore on the base of my glans would end up pushing into the strap and the friction would get unbearable. Ideally you're supposed to be strap in about an inch below where the glans start, correct?

AF
 
Are you putting something softer on first under all these wraps? Foam pad that came with it, theraband, thin sheet of silacone? Every wrap you mentioned would be painful without something under it. I use the foam cylinder that came with sg and wrap ace bandage around that and I go hour and a half no problem
 
Thanks Jdscd, I think I was just being too ambitious with the length to be honest. When I dial it back there's no pain from my dick trying to slip out of the stretch.
 
AF3;527733 said:
Thanks Jdscd, I think I was just being too ambitious with the length to be honest. When I dial it back there's no pain from my dick trying to slip out of the stretch.

Yah you problem were just wrapping too high which causes pain in the glans. I've seen a lot of people do that in pics cause they want as many bars on as possible even if it isn't on right. It's prob good you figured out to take it down a notch
 
Problem and solution before I even got to read! Good work men!
 
doublelongdaddy;527808 said:
Problem and solution before I even got to read! Good work men!

Well not quite. I really thought that would solve it, but now I'm about half an hour in on a length that really shouldn't cause any pain, and I'm still getting pain in my glans. The problem seems to be that the head of my dick slowly starts slipping out of the extender over time, and this causes the gase of the glans to start pushing into the strap. I really don't know what to do.
 
feedo91;527879 said:
Dear friends I wanna ask something. If I order through the link displayed on matters of size website I would be able to buy the size genetics extender for $165. is this true?
also, are there any hidden charges. I just registered as a member on the MOS forum, am I able to avail this offer. please reply. Also if a guest applies through the size genetics link of $165, are they going to look for any verification because it says that its exclusive only for MOS member. Thank you.
here's my email feedo91@gmail.com
please reply soon.

Yes, the special is $165, order it through my signature. There are no hidden charges, just a great deal.

Click here to order SizeGenetics at $165.00
 
Yah I just said this to you in another thread but you need to wrap a longer piece of ace around you to thicken you up so you don't slip out. If I use an 8in piece it's not thick enough and I slip out. I use a 12 in piece and no slippage. The comfort strap has a design flaw in that it takes more girth to use than is even possible to put through it. You need like 6in girth to stay in it and prob 9in girth to have it on its loosest setting which isn't even possible. So anyways thicken yourself up with more wrap of self ashesive ace and I guarantee you won't slip
 
Last edited:
Jdcsd;528109 said:
Yah I just said this to you in another thread but you need to wrap a longer piece of ace around you to thicken you up so you don't slip out. If I use an 8in piece it's not thick enough and I slip out. I use a 12 in piece and no slippage. The comfort strap has a design flaw in that it takes more girth to use than is even possible to put through it. You need like 6in girth to stay in it and prob 9in girth to have it on its loosest setting which isn't even possible. So anyways thicken yourself up with more wrap of self ashesive ace and I guarantee you won't slip

Thanks Jd, I redid the Velcro Mod and it seems to work a whole lot better this time. Now just to find the right wrap. I'll try the Ace Bandage again. I'm not using the comfort strap or foam wring, mine broke, just t-shirt material and the Ace. At least this thread has taught me that slippage is what causes the majority of problems with the SG.
 
I'm gonna get that vac attachment I told you about in the next couple weeks. I'll let you know how it works out. People have said they can go 2+ hrs in it. If that's the case I can probably add an hour or 2 a day of time in which would be great
 
Back
Top Bottom