Vacuum Hangers: How to Prevent Water Blisters
- Joined
- Aug 24, 2006
- Messages
- 2,152
Ok, I have an even better method. Instead of placing it around the whole glands(including the corona), just wrap it right above the corona, and you won't get any irritation or raw skin. It's very nice and works great.
- Joined
- Jul 25, 2004
- Messages
- 337
10inchadvantage said:
I've got an even better idea. I tried using the co-flex wrap but that didn't work for me SO I decided to start out slow and work my way up in time and weight. I started using my Max-Vac again on 12/28/06 without anything covering the glans. I used the no hand pump method by placing a sheath over my shaft and one draped over the MV cylinder. Anyway, I started out with two 30 minute sessions per day at 3-4 pounds. I am now up to 5 pounds for two 1.5 hour sessions per day with almost no fluid buildup and absolutely no blistering of any kind. I hope to eventually ADS and ANS but that will take a while. Meanwhile, I normally go 5-7 days at a cetain time and weight, then I move up 30 minutes per set at the same weight. IOW, in a few days I will start doing two 2-hour sessions at 5 pounds. Then 2.5 hour sessions at 5 pounds, then 3 hour sessions at 5 pounds, etc. until I can go all day at 5 pounds without a problem.
- Joined
- Aug 24, 2006
- Messages
- 2,152
Yes, as I said I never experienced any problems until I hit 10 lbs, so I never had to wear it until then. Once you start jacking up weight and start pushing the envelope you should wear the wrap just for protection. I'd rather be safe than sorry. Btw, I hung almost 3 hours yesterday with 15 lbs, felt great!
im amid my conditioning phase with my Monkeybar and currently hanging 8 1/2 lbs for no more than 30mins, 4-5 times a day.
the ace wrap reduces fluid build up ten fold and i will continue to test variations of position and wrapping technique. i'll add that im not sure that its the material that counters the build up, or simply the tightness and ristriction of the gland when wrapped(the Monkebar constriction sleeve is a weak, thimble of shit... does nothing for me)
the above said, im still getting minor build up on the tip and can't seem to figure a way of tackling it. i sqeezed the excess ace wrap to a nib but it did nothing. i also layered a strip underneath the wrap(on the head before i wrapped around it) but this failed... has anyone got any suggestions to how i might prevent the fluid in the tip?
and is there a link to a pic of a water blister and fluid build up from hanging? so i can reference where im at?
10inch -
how far in the cylinder is ur dick in theGRIP?... maybe i'll get one someday.
with the Monkeybar my head is prone to slipage, coz where the sheath drapes over the cylinder it leaves a gap where the first part connects with the shaft(duno if that made sense)
keep pushing
the ace wrap reduces fluid build up ten fold and i will continue to test variations of position and wrapping technique. i'll add that im not sure that its the material that counters the build up, or simply the tightness and ristriction of the gland when wrapped(the Monkebar constriction sleeve is a weak, thimble of shit... does nothing for me)
the above said, im still getting minor build up on the tip and can't seem to figure a way of tackling it. i sqeezed the excess ace wrap to a nib but it did nothing. i also layered a strip underneath the wrap(on the head before i wrapped around it) but this failed... has anyone got any suggestions to how i might prevent the fluid in the tip?
and is there a link to a pic of a water blister and fluid build up from hanging? so i can reference where im at?
10inch -
how far in the cylinder is ur dick in theGRIP?... maybe i'll get one someday.
with the Monkeybar my head is prone to slipage, coz where the sheath drapes over the cylinder it leaves a gap where the first part connects with the shaft(duno if that made sense)
keep pushing
- Joined
- Aug 24, 2006
- Messages
- 2,152
steve53 said:
Yes, dude, all you need to do is use electrical tape on the outside to keep it from slipping. It WILL slip without tape after 8 lbs.
Reber187 said:
Nothing? not even blister pics?
[insert tension building voice over]
"will Reber have to neck a pint of brave juice and infiltrate �other forum� to aquire the pics that will expose this hindrance? tune in next week to REBER in colour."
keep pushing
- Joined
- Aug 20, 2006
- Messages
- 128
FUCKEN A>
I took 3 weeks off from hanging with my max vac , and i hung 10 ponnds OTS for 1 hour , and i got my first blister , it popped and its hurtin like a mutha!
what should i put on it as far as creams go?
I took 3 weeks off from hanging with my max vac , and i hung 10 ponnds OTS for 1 hour , and i got my first blister , it popped and its hurtin like a mutha!
what should i put on it as far as creams go?
- Joined
- Aug 24, 2006
- Messages
- 2,152
JKISINEFFECT said:FUCKEN A>
I took 3 weeks off from hanging with my max vac , and i hung 10 ponnds OTS for 1 hour , and i got my first blister , it popped and its hurtin like a mutha!
what should i put on it as far as creams go?
I know this might hurt, but urine does clean it out. I didn't have a choice the last blister that I got (which was before I started wrapping), since it was right by the meatus (piss hole) and everytime I pissed it would burn since the urine would get in it.
Just put some anti-bacterial shit on it and keep it dry and wrapped up. Ironically, the way I "fixed" the pain of an open blister was by wearing a sheath that caused the blister while hanging. The sheath blocks the blister-to-material contact of skin and clothes so that you don't say "ouch" everytime your dick swings back and forth when you walk with a blister. Also, I found I could still hang and ADS carefully while I had a blister. I made sure that I wrapped correctly and I was in very controlled movements.
10inch and all, can you please again explain how to wrap one's head with the athletic tape to provent water blisting.
I tryied it today with my Vacu-Hanger and Iam not sure I did it right.
I cut a piece of 2 inch wide tape (bought at CVS) about 10 inches long.
I started about 1 inch below the head, on the staft, and wrapped it forward until i reached the tip of the head.
I had about 1/2 inch of the tape left over. I push down the tape alread wrapped around the tip and then folded the 1/2 inch tape back around the tip end of the head and over the top.
It seemed there was a lot of tape bunched up at the tip end of the head.
I had a small blister develped from yesterdays hanging. I never used a wrap before to provent blistering.
I hung for 1 hr with 10lbs. No new blisters, yesterday's blister filled up with a little fluid but did not get larger, which it would have if i did not use tape.
It did take about 1 minute to pull the tape off. The tape stuck to the skin and it hurt like a mother bear.
Please advise.
Scott
I tryied it today with my Vacu-Hanger and Iam not sure I did it right.
I cut a piece of 2 inch wide tape (bought at CVS) about 10 inches long.
I started about 1 inch below the head, on the staft, and wrapped it forward until i reached the tip of the head.
I had about 1/2 inch of the tape left over. I push down the tape alread wrapped around the tip and then folded the 1/2 inch tape back around the tip end of the head and over the top.
It seemed there was a lot of tape bunched up at the tip end of the head.
I had a small blister develped from yesterdays hanging. I never used a wrap before to provent blistering.
I hung for 1 hr with 10lbs. No new blisters, yesterday's blister filled up with a little fluid but did not get larger, which it would have if i did not use tape.
It did take about 1 minute to pull the tape off. The tape stuck to the skin and it hurt like a mother bear.
Please advise.
Scott
Last edited:
- Joined
- Aug 24, 2006
- Messages
- 2,152
devass said:
First of all 10 inches long is way too much. You want to cut maybe 4" long at the most, as it is elastic and does stretch out. You want to wrap around the head ABOVE the coronal ridge, otherwise the wrap will rub the corona raw. All the "extra" at the top, just fold it over and bunch it up, that's what I do.
- Joined
- Aug 24, 2006
- Messages
- 2,152
Need2more said:
I'll get to this along with the pics of the key reel setup.
Well, I applied the tape to the head during my hanging for a couples a days and on the third day I got 2 huge blisters under the tape. What I noticed is the tape does not fold down well around the tip of the head and the tape pulled away from the skin around the tip. That is where the blisters formed.
I waited 2 weeks for healing and now I placed one piece of tape from bottom to top, then one piece around the head, and then another from side to side.
All of the skin was in good contact with the tape. Quanity of 2 -1hr 10lb hanging sessions and no blisters. I hope this works. I so tired of blisters.
Wish me luck.
I waited 2 weeks for healing and now I placed one piece of tape from bottom to top, then one piece around the head, and then another from side to side.
All of the skin was in good contact with the tape. Quanity of 2 -1hr 10lb hanging sessions and no blisters. I hope this works. I so tired of blisters.
Wish me luck.
Last edited:
- Joined
- Jun 3, 2003
- Messages
- 20,066
The Silicap helps to prevent blisters
- Joined
- Jun 3, 2003
- Messages
- 124,461
Clever bump ?
- Joined
- Dec 30, 2018
- Messages
- 244
and @DLD
No they don`t. I`ve gotten countless blisters while using the caps, it helps with nothing. To much pressure and or too long in the tube gives you blister no matter if you use a cap or not. I`ve been using too much pressures, and too long in the bathmates, so It`s my own fault, but caps don`t prevent it if you pump to long, and or use too much pressure. I`ve struggled with blisters for years now, and its my own fault, and there is nothing I can do to reverse it. I am extremely prone to blisters for almost nothing now, so I have nearly, basically destroyed my glands abillity to be able to pump.
Fuck me, I hate myself for it.
I agree, protector caps don't help if the pressure is too much and using for long(I don't know about the pumping, but I got blisters with stretching).
Anyway, have you tried 'New Skin liquid bandage'? have seen couple of people talking its preventing the blisters for them.
Blister Prevention
Hello Newbie to Posting, My First Post! So if I say something wrong or post in wrong Forum? Sorry- I really don't care. I am Body Builder 5' 10" 245 Pounds- Strong Strong I am Avid PE - 9.5" BPEL 9" NBPEL 7.25" Girth But in the last 6 months - I was really struggling with Blisters...
mattersofsize.com
Last edited:
