I leave it with a lot of weight for 10 minutes. I do 2 sections a day and I find it gives me a better pump than jelqing or uling. I realize that it might be dangerous but I haven't been bruised or feeling anything suspicious. And I've seen pictures of dicks here with red holes in them(SWM), I haven't experienced anything like that so I don't think it's a big deal.
I've been high hanging fully erect
S
stillwantmore
Guest
Red holes?? You mean spots? Well, be careful. Dont be suprised when you experience a tunicae rupture and need to go to the E.R. though. Good luck.
- Joined
- Oct 20, 2004
- Messages
- 1,105
Approximately how erect would you need to be to get a tunicae rupture SWM? In %. I sometimes stretch with say 40-50% erection. Any more than this and I don't think I get as good a stretch anyway. Do you think that this is ok? Any advice would be appreciated.
- Joined
- Oct 20, 2004
- Messages
- 1,105
I had the same problem whilst hanging. I think you need to tighten your hanger a bit more so that it holds on to the inner structures of the penis instead of just pulling on the head. I did this and found it too painfull so I've gone back too manual stretching which I find much more comfortable. I'm uncut. Either way good luck with your routine.
I find that if I use a half erection to hold the hanger, the hanger slips down a bit and forces all of the blood on the head and it hurts much more. If I have a full erection on, the hanger stays high and the pressure goes through the lenght of the penis and the shaft and it's a lot less painful.
I didn't know about that razor cut, thanks for explaining.
I didn't know about that razor cut, thanks for explaining.
You simply mount the hanger incorrectly if it slips off your shaft.
You have to make sure to tighten all three screws - and first of all you need to wrap correctly. Maybe you wrap too little - I wrap almost 5 times around my skaft before I mount the hanger.
I've made some girth gains and now I only have to wrap 3-4 around my shaft.
How big is your girth and are you using the starter or the traditional hanger from BIB ?
I startet out being 4,5-4,6" flaccid girth and now I've worked myself up to around 5,5-5,6" flaccid girth.
You have to make sure to tighten all three screws - and first of all you need to wrap correctly. Maybe you wrap too little - I wrap almost 5 times around my skaft before I mount the hanger.
I've made some girth gains and now I only have to wrap 3-4 around my shaft.
How big is your girth and are you using the starter or the traditional hanger from BIB ?
I startet out being 4,5-4,6" flaccid girth and now I've worked myself up to around 5,5-5,6" flaccid girth.
- Joined
- Jun 3, 2003
- Messages
- 20,066
I myself have openly talked about oneday doing clamped hanging, but I dunno when.
However with alot of danger expertise under my bealt I feel I know what to look for before it happens, i.e injury.
It is however VERY DANGEROUS and RISKY [Erect hanging] but I think it could be a good method to get erect gains, better than the standard flaccid hanging....with the more blood being stretched and all, yet this X100 the risk...so be VERY careful.....I know I will.
However with alot of danger expertise under my bealt I feel I know what to look for before it happens, i.e injury.
It is however VERY DANGEROUS and RISKY [Erect hanging] but I think it could be a good method to get erect gains, better than the standard flaccid hanging....with the more blood being stretched and all, yet this X100 the risk...so be VERY careful.....I know I will.
Similar threads
- Sticky
Equipment modification
Modification to Bathmate HydroXtreme 7 with a pressure gauge