length

0
Registered
Joined
Feb 19, 2014
Messages
95
if I was trying to achieve length gains from pumping with a thin cylinder, would it be more useful to pump with high pressure (about 10-15Hg) spiking higher to lower for about a 30 minute session (2x15 min sets) or would I gain length better if I pumped for 1 hour (3x 20 min sets) at around the 3-5 hg mark (7 hg at most for a matter of seconds). what are your guys thoughts? or if neither is optimal for length gains what do you think I should do?
 
I'm not sure what your setup is, but I would try longer sets @ lower pressure and alternative up a bit higher if you can, then down.
Do you know what stretch length you get in the tube?

Seen that you posted on kings thread, he goes a bit over dynamic stretching: http://www.mattersofsize.com/forum/...-with-the-dp-4000-digital-maximizer-pump.html
He goes a bit higher though, not sure if you took any ideas from that thread, but just posting it again in case not.
 
Yea, there are only 2 pumps that I know of that can do this actually (have manual control over the instensity of the session)

1-The DP4000 (the one smerc mentioned)
2-The massage pump youknowme uses as a pump ( http://www.mattersofsize.com/forum/...12-vacuum-pumping-video-best-way-to-pump.html )

Though, this is a pretty interesting question- we may come up with a lot of useful stuff if we knew this.... Maybe if we make an experiment of about 10 of us and post our results... Any other 9 people to volunteer? :)
 
Zambrodom3;616979 said:
Maybe if we make an experiment of about 10 of us and post our results... Any other 9 people to volunteer? :)

Yeah. If you're paying :cool: I'll play guinea pig.
 
smerc;616983 said:
Yeah. If you're paying :cool: I'll play guinea pig.

Same here, that DP4000 costs a lot of money, but if someone wants to send me one for free I would love to do a review.
 
doublelongdaddy;616992 said:
Same here, that DP4000 costs a lot of money, but if someone wants to send me one for free I would love to do a review.

The Mr. Fantastic pump is also nice.

I'm going to try the DIY method in the future.
 
Zambrodom3;617009 said:
...Me too.... but this can be done with a BM as well...

For a fraction of the cost.
 
doublelongdaddy;616992 said:
Same here, that DP4000 costs a lot of money, but if someone wants to send me one for free I would love to do a review.
I think I will get that pump next month but don't think I can swing one for you also lol
 
Jdcsd;617132 said:
I think I will get that pump next month but don't think I can swing one for you also lol

You might try looking @ the one noted above. It's cheaper, but you might like the functions of the DM better.

You can also read up on the aquarium mod. The aquarium/hydroponic air pump mod.
The air pumps push air out to create oxygenated bubbles for the water (plants/fish).
You basically reverse the flow so it sucks rather than pushes. Then you have valves that measure pressure and open/close valves.

At least that's the gist of it.
 
I think short sessions work for me I used to do long sessions but got a dounut in the pass
9 1/2 7 girth
how do you put
your (mesuremens) in your post? Brain fart again sorry for the misspell words.
 
Last edited:
rlue11;617366 said:
I think short sessions work for me I used to do long sessions but got a dounut in the pass

@ what hG though?
 
rlue11;617368 said:
I do not know but i guest it is how much presure you do

I think you're referring to the bathmate and not air pumping. Unless it's a pump w/o a gauge. NVM.
 
I am referring to a airpump wich has good suction to I have one of thos 12inch pumps.
9inches with a fat pad and 7inch girth
 
Last edited:
Back
Top Bottom