VSG,
Bigger,
I hope I have got this quote reply thing sweet otherwise this post will end up messy.
To VSG, I hope I don't confuse you but I just wish to drive in here and ask Bigger a question or two.
http://www.mattersofsize.com/forum/newreply.php?do=newreply&p=162779#OT,
Right. You will probably feel an entirely different hang with the added wrap and new hanger adjustments. Remember to tighten more, keeping the correct top gap, but adjust to where you are still able to tighten more during the first part of a set.
>And no my hex nuts havent been touched , i find it weird haven decent girth when erect but flaccid is a different story Thanks for you help bib , much appreciated .<
I thought you would not have been able to use the hex nut adjustments. The larger WFG will make a big difference. You will be able to try toeing-out, and other things. During this period of experimentation, think about just going with say ten minute sets, making small adjustments for each set, and see how you like the different settings.
Oscillate,
>As always, be sure your top gap when fully tighened, is smaller than the bottom gap."
Please explain the reason for this.<
This is because of the way the hanger was designed. I wanted the majority of the direct pressure to be on the top sides of the two major chambers, rather than on the dorsal veins/nerves, or the CS and urethra. The top sides of the two major chambers is a much safer area to grasp with great pressure.
As seen from the back, looking down through the shaft well, when tightened, the inner fingers of the hanger should look like this, / \, rather than l l, or \ /.
usly blood flow will be more restricted. The outflow occurs in the dorsal vein. If the top of the shaft receives too much hanger pressure, then return of twenty minute sets.
Bigger,
You advise VSG to increase his WFG by increasing his lenght og wrap. You then advised him to open his bottom screwes both front and back to 5/16 inch. If I am understanding your advice this was to give him room to move the adj. nuts front and back, in and out to allow VSG to achieve the / \ shape when viewed from behind.
This increase in WFG and bottom adj. of nuts also allows him to vary his top teeth gap, or I called it sometimes the amount of mess of the top teeth. Now VSG has room to tighten more if he feels it is needed.
My present hanging journery has me with the / \ shape already and hex nut gap on the bottom of about 13mm front and back. Also you may recall that I am now rolling the wrap up before wrapping and trying to wrap tighter then previously before. The result now is for the same wrap lenght I am achieving a smaller WFG then before. Now which is a more better way to achieve correct top teeth mesh in my case? Is it by now increesing my wrapping lenght hence increasing my WFG and stay and the same hanger settings. In thoery this should have the effect of giving me more top teeth meshing adj.
OR
Should I leave the wrapped lenght the same and hence have the same new smaller WFG BUT adj. my bottom hex nuts in alittle giving my the same result with the top teeth amount of mesh. I.E I can tighten more at the top wing nut.
I feel I now need to achive a tighter hanger grip on the shaft now I am wrapping tighter. SO in Summary is it better to increase the WFG or adj the hex nuts closer to achieve a firm grip on the shaft?
I hope I have not messed this reply with quote up Bigger.
I am sure you will let me now if it does not make sense.
Thanks as always
GMJ