How to ALL DAY stretch COMFORTABLY without loss of circulation!!!

Ive been waiting to post this for some time, partly due to the fact that I want to see if it would hold and not fall off and then I lost my digital cam(still havent found that bastard). This pic is taken with my phone, so Im hoping the quality is good enough.

Most ADS devices go on the principle of holding by constriction or compression to hold on. As we all know this can cut off the circulation and cause comfort issues. I took a different method of holding on, I thought if I could use friction it would be alot more comfortable and not cause issues.

Parts you will need and websites to get them.

Cock sleeve, I used the colt stroker $16
http://www.babeland.com/page/TIB/CTGY/men-sleeves
Can also be used for wrap under a cable clamp, works beautifully. Ive tried many wraps and this one buy far worked the best, especially for comfort. Cut off a section a little over one inch long, cut off the knobs and strap it on, then throw on the cable clamp.



Shaft collar from www.mcmaster.com $15 Weighs about 2 lbs
Before buying one of these you need to figure out what your flaccid girth is and then convert that to a diameter in order to purchase the correct size. To do this just measure your flaccid girth(mine is between 5 and 5.25) then measure that out on a piece of paper, then roll up the paper and measure from edge to edge. This will give you the inner diameter for the shaft collar. I bought mine as close to that size as I could, going slightly over vs slightly smaller. If you screw this part up and order the wrong size it is easier to fix it if you buy the shaft collar slightly larger than slightly smaller.

Here is what I did, I took the colt sleeve and cut it into sections .5-1 inch longer than the width of the shaft collar. I cut off the knobs and the colt sleeve, but you dont want to do that just in case you need extra holding support because of inaccurate sizing of the shaft collar. Then put this section of the colt sleeve on the middle of your cock and then put the shaft collar on it.

Nothing slips, Ive never had it come off. Circulation is ALWAYS good. I can pee with it on. You can wear it almost anywhere if your activity level is on the low end. I dont wear underwear with it and wear khakis and you cant tell Im wearing it.

You can also wear two and this gives you a real good pull. Almost 5 lbs pulling all day is pretty good weight. I havent ventured out wearing two just yet. I usually do this around the house. It stays just fine but it makes me nervous if I were to go out with both on.

PS This is the first pic of me.

That is very cool... i'm gonna order mine today.

That is an awesome idea! Your flaccid girth also looks huge man! Did you order the "set screw shaft collar" ? What size did you get?

philadelph said:

That is an awesome idea! Your flaccid girth also looks huge man! Did you order the "set screw shaft collar" ? What size did you get?

Click to expand...

Thanks Philly! I ordered the two piece clamp on shaft collar, not the set screw shaft collar. Sik, glad you like it, love to hear what you guys think after you try it.

Part number 6433K17 2-Piece Large Bore Cast Iron Clamp-On Collar 1-1/2" Bore, 3" Outside Diameter, 1" Width $12.68

I think this would be easier to walk around with and wear in public than my Penimaster. With the PM down the leg of my jeans it is hard to walk around properly.

I realy like the look of these,im gonna order!thanks jakb!

philadelph said:

I think this would be easier to walk around with and wear in public than my Penimaster. With the PM down the leg of my jeans it is hard to walk around properly.

Click to expand...

It is very easy to walk around in public with it on! I wouldnt go running with it on though.

August-
Before you order it make sure to get the right size.

Interesting post jakb.
I have been wearing a stainless steel weight for 12-14 hours a day and currently use a piece of self adhesive bandage to stop it from slipping off but this will like you said eventually cut off circulation.

The cock sleeve looks like something I would like to try out, all I need to do is find one available from the UK.
If anyone knows of a UK supplier please let me know.

questions guys....was it me,or was there a stretching device on the colt sleeve page that had like 2-3 levels that you could stretch your dick in????? please tell me i wasnt dreaming. < if there was,where did it go?

I have moved this into the alternative section, it wasnt posted in the wrong section but as its a alternative idea it will help better in there where we all know its for that purpose.

Jakb:

Thanks For A Great Post. I've Been Considering The Circle Device Since My Pm Is Hard To Wear In Public. Besides, Yours Is A Lot Cheaper To Make. I Will Order It Right Away. Thanks Again!!!!!!!!
Rpg

RPG said:

Jakb:

Thanks For A Great Post. I've Been Considering The Circle Device Since My Pm Is Hard To Wear In Public. Besides, Yours Is A Lot Cheaper To Make. I Will Order It Right Away. Thanks Again!!!!!!!!
Rpg

Click to expand...

Glad I could help!

Wow, this looks great. You have worn this for hours at a time without any problems?

nickynine said:

Wow, this looks great. You have worn this for hours at a time without any problems?

Click to expand...

I wore it for about 7 hours this past Saturday with no problems. I even wore two of the shaft collars without any real issues. Had one fall off once, but that was because I didnt put it on tight enough. User error. It felt like I had done an intense hanging session my ligs started to fatigue and slightly burn(positive burn). It works really well.

exellent, I hope you see great gains with this freind.

jakb said:

Ive been waiting to post this for some time, partly due to the fact that I want to see if it would hold and not fall off and then I lost my digital cam(still havent found that bastard). This pic is taken with my phone, so Im hoping the quality is good enough.

Most ADS devices go on the principle of holding by constriction or compression to hold on. As we all know this can cut off the circulation and cause comfort issues. I took a different method of holding on, I thought if I could use friction it would be alot more comfortable and not cause issues.

Parts you will need and websites to get them.

Cock sleeve, I used the colt stroker $16
http://www.babeland.com/page/TIB/CTGY/men-sleeves
Can also be used for wrap under a cable clamp, works beautifully. Ive tried many wraps and this one buy far worked the best, especially for comfort. Cut off a section a little over one inch long, cut off the knobs and strap it on, then throw on the cable clamp.

Shaft collar from www.mcmaster.com $15 Weighs about 2 lbs
Before buying one of these you need to figure out what your flaccid girth is and then convert that to a diameter in order to purchase the correct size. To do this just measure your flaccid girth(mine is between 5 and 5.25) then measure that out on a piece of paper, then roll up the paper and measure from edge to edge. This will give you the inner diameter for the shaft collar. I bought mine as close to that size as I could, going slightly over vs slightly smaller. If you screw this part up and order the wrong size it is easier to fix it if you buy the shaft collar slightly larger than slightly smaller.

Here is what I did, I took the colt sleeve and cut it into sections .5-1 inch longer than the width of the shaft collar. I cut off the knobs and the colt sleeve, but you dont want to do that just in case you need extra holding support because of inaccurate sizing of the shaft collar. Then put this section of the colt sleeve on the middle of your cock and then put the shaft collar on it.

Nothing slips, Ive never had it come off. Circulation is ALWAYS good. I can pee with it on. You can wear it almost anywhere if your activity level is on the low end. I dont wear underwear with it and wear khakis and you cant tell Im wearing it.

You can also wear two and this gives you a real good pull. Almost 5 lbs pulling all day is pretty good weight. I havent ventured out wearing two just yet. I usually do this around the house. It stays just fine but it makes me nervous if I were to go out with both on.

PS This is the first pic of me.

Click to expand...

hey I just wanted to say I just ordered these too and the same part number, thanks for hooking us up, what I was wondering is do you think there could be any benefit from buying two that are two separate metals in hopes of getting some sort of voltage from them like the ROP does?

Cleaner13 said:

hey I just wanted to say I just ordered these too and the same part number, thanks for hooking us up, what I was wondering is do you think there could be any benefit from buying two that are two separate metals in hopes of getting some sort of voltage from them like the ROP does?

Click to expand...

They arent touching your skin so there wouldnt be any form of conduit for the electricity to flow through. So no I dont think it would help. Let me know what you think of it though.

Hey Jakb:

I ordered the parts and since my girth is like yours yet, I am wearing double stroker and it's working great (although it's a little tight, I have to take it off to go pee). The first day, I wore it for about 4 hours (that was Apr 8th) Today, I can wear it for at least 8 hours with ease. I think this is going to speed up my gains!! Thanks again for such a wonderful post!!!!!!!!

It's me again.

I am able to wear my ADS device for 12 hours a day, no problem!!! I will let you know of my gains pretty soon.

RPG

Alright, so in normal circumstances this thing sounds like a Godsend, but I've a question: What happens if the wearer were to get an erection while wearing this? It would seem to me that the rather narrow, and inflexable diameter of the weight could do some damage to the penis.