Clamping With The MH Penis Clamp, Points Clarified

"they can suck it" you're funny. I like your pitch of the device, but I feel like it covers too much area for me to do my bends good<:(.

I'm getting better at doing wall presses though, one thing I enjoy is pressing on a bend. After I did a few downwards bends near the base, and midshaft ill press while bent around the top shaft.
This opens up that part real good, and gives a sort of square/flat texture. And a cool thing is after one intense session my cock was temporarily downwards bent in half-erect mode!

I'm having more expansion after using your methods brahs thanks.
 
I feel like it does enlarge because the plastic puts a strain on that spot causing deformation, but bends combined with your wall press cause a even greater strain.
 
seems much easier, i flippin hate the damn cable clamps, its so hard to get the shut properly with wrap and also the damn things break all the time.
i really like the mechanics and sizing of the MH clamp, but unfortunately i like to clamp very tight, to the point where even if i were to squeeze my dick as hard as i can, no blood would get out.
i dont think it would be possible with the MH, hows the clamp power with this?
 
I guess you didn't take notes in class ;) This device can be tightened much more than a 'cable clamp'. Thanks to the design, as well as the wing nut tightening system. The pressure is therefor greater. Ever use two clamps at the base? Big step up in pressure potential. It's almost as wide as 3 clamps, but not quite. I actually built the skeleton around a cable clamp for the original design. The latest design shown in the videos is the redesigned/improved version which is now injection molded vs hand poured.

I actually shared how I made the original version here:

Penis Clamp Gen 1 Design Creation
 
Damn almost three clamps? That's a turn-off for me I think, and today I was really struggling to get in that last click too XD
 
I already get alot of pressure bras. The thing that turns me off is that I can't effect that covered portion of the cock <:(. Plus you're very creative bras by the time I need to upgrade to your product you'll probably have the version three.
 
Yeah it enlarges because of the deformation going on when the edge of the clamps presses down on the tunica. Check out the graphic to see why lesser area is for better strain on the shaft.
103iovl.jpg
 
that'll go away quick with a couple jelqs after, and regardless, the stretched shaft above will automatically cause that crushed shaft to get thicker aswell.
 
The pressure differential causes the tunica to deform at the edges of the clamp. Not underneath it; there's virtually nothing going on there.
 
Well, I have yet to see anyone report their girth under the clamp did not get bigger along with the rest of the shaft. Even long before this device was created. I have known men including myself who used multiple clamps stacked at the base and farther up the shaft, without uneven girth development.
 
Yeah I'm probably over thinking it. Also last night ananon said to me that if I don't get a slight burning sensation while declamping then I'm not getting a good session. What do you know about this declamping? When I hold a good bend ill start to get a slight burning, but I don't know what he meant with declamping.
 
It simply means removing your clamp device. A slight burning sensation is not really indicative of anything other than that blood flow is returning to the skin. It's like when your hand falls asleep and after you're done using it like a strangers', you let it wake back up. That sensation returning is blood flow returning to normal.
 
No dude its actually a sign of electricity asanon just explained me it. And yeah I know you invented the 'weed eater' masturbation technique there's no need to ventilate that here
 
You must log in or register to reply here.
Help Users

You haven't joined any rooms.

    You haven't joined any rooms.
    Back
    Top