Re-read the product guide. I dont know what your flaccid size is man but, the product guide recommends what size hanger to buy based on your flaccid size. If you bought it based on what was recommended on the hanger site....you should be able to get it to work fine for ya. Worst case scenario...you might have to make a basic home made BIB hanger and work with it until you've gotten a little longer. Just do like I advised above and, experiment with your settings. Your glans should never sit inside the hanger. When adjusted/tightened properly...your glans will be outside the hanger. When you pull forward on the hanger, the hanger should "seat" itself just behind the glans or slightly farther back. You should not feel a lot of pressure in your glans when hanging. If you do feel pressure in there and/or your glans is hard while hanging (should be soft), you either have the hanger to far forward or too much blood is still in the glans and you need to loosen the hanger and squeeze you glans for a few seconds then, re-tighten. The tendency is to want to crank down too tightly on the front bottom wingnut and then in turn, end up with too much pressure on the glans. Also, I know youre excited and ready to get hanging but, dont rush right into it. You are starting a new type of Penis Enlargement and, need to give yourself a couple weeks to really get it down. You will thank yourself in the long run if you give yourself the time needed to really learn how to hang properly and, safely.