clampers look in please

With the other ones I buy at Walmart (Look exactly the same.) ya gotta use Medium. I'm assuming its the same way with these. Small is TINY.

Go with the mediums.
 
Small is too small, med should be alright.
Remember you will have some wrapping on as well.
I think the medium size was 46-50mm diam.
 
Not to be a ... dick ... but I've been meaning to complain about the mediums being a little small. They need to have more area when not in lock-mode. The locking arm should curve out a little wider and hit the latch at a different angle ... that'd give it more throat when you unlatch it, but still be very similar when locked-in.

While I'm at it .... they should have rounded-over edges so it'd possible to use them without a cushioning material (once you built up to it). Might need just a bit of lotion or etc at your base for this, but the way they are now using a cushioning material seems 100% necessary.

Anyway, .... yeah those clamps you linked look identical to the ones commonly available at walmarts.

One more thing, .... are the Orange ones tougher than the Red ones?

You'd think it's just a different color of plastic dye, but I've broken two reds (at the arm for the latching tooth) and never broken an orange.

One --more-- thing, .... the little finger-grip off to one side digs into you, that oughta go away in favor of flattened grip areas on both sides.

And one last thing, ... there should be two different models with either the detents or the latches in slightly different distances. If you couldn't get the perfect fit from one style, you could switch to the other style for a while until you gain, and then switch back to the other one again to the next detent on it. The two different styles should probably be called 1 and 2 or A and B, etc, so you could tell the styles apart and know which one you needed to replace if one breaks.

*
 
Asanon said:
Not to be a ... dick ... but I've been meaning to complain about the mediums being a little small. They need to have more area when not in lock-mode. The locking arm should curve out a little wider and hit the latch at a different angle ... that'd give it more throat when you unlatch it, but still be very similar when locked-in.

While I'm at it .... they should have rounded-over edges so it'd possible to use them without a cushioning material (once you built up to it). Might need just a bit of lotion or etc at your base for this, but the way they are now using a cushioning material seems 100% necessary.

Anyway, .... yeah those clamps you linked look identical to the ones commonly available at walmarts.

One more thing, .... are the Orange ones tougher than the Red ones?

You'd think it's just a different color of plastic dye, but I've broken two reds (at the arm for the latching tooth) and never broken an orange.

One --more-- thing, .... the little finger-grip off to one side digs into you, that oughta go away in favor of flattened grip areas on both sides.

And one last thing, ... there should be two different models with either the detents or the latches in slightly different distances. If you couldn't get the perfect fit from one style, you could switch to the other style for a while until you gain, and then switch back to the other one again to the next detent on it. The two different styles should probably be called 1 and 2 or A and B, etc, so you could tell the styles apart and know which one you needed to replace if one breaks.

*
Click to expand...

Sure, but these things aren't designed with penises in mind. lol
 
prince Albert said:
There cheaper in b&q mate
Click to expand...
have they got them in b&q man. were would they be in the store do you know? lol i hate asking shop assiants for things.
 
ive been after a cable clamp for ages but they only seem to sell in USA! lol

Might have to take a trip to B&Q then! at the mo im using a tiw cock ring, its still good!
 
http://www.lovehoney.co.uk/product.cfm?cat=43&id=2788

ive been using this for my clamp for the mean time. my girth gets to about 5.4ish when clamped. and not clamped it is about 5.0

when do you think i will get 5.4eg. i clamp 3 x 10min seesions a day when will i get my girth the size of my clamp size. as thats near my goal.

yeh bulc i couldnt find any anywhere but ive emailed the guy regarding a load of mediums so if i get a load i'll sort ya out for a few dude. ;)

i'll keep you updated on the situtation bro
 
no man we do the likes of bandq budget etc etc.

no home depot or wallmart etc. :( i wish we did. saved me buying over the net lol.

well i ordered the ones of ebay. 3small which will be no good. a 1 medium.

i emailed the guy as well and asked him if he could get hold of more mediums. awaiting reply
 
just picked up some from wallmart, a pack of 2 mediums and 2 small (small won't fit )...well, the mediums fit ok, but I need to put some type of padding because it pinches my skin and my girth is just a little under a desirable seal...The clamp gives me great expansion without me having to use my hands...so now I can do bends or just leave it be...this is interesting:cool: any suggestions for workouts?
 
ive just finished 2 10min clamp sessions. i wrapped more than usual. and i actually felt a lot fuller i think before when i clamped i didnt wrap enough and i clamped to hard restricting complete blood flow to the penis which was not good. as my clamp session there my girth was pretty dam big than usual ;)

so anyone clamping id advise to wrap a lot. ;)

my routine today i did was.

am (wake up)
3 10min roughly clamped session
dry jelqing

pm (midday)
30mins stretching - up/so/down/btc
15mins jelq - low erection level 20-50%

pm (evening)
2 10min clamp session
dry jelqing between

felt good today hopefully will be able to do this again tomorrow and sun. :D
 
icecam said:
ive just finished 2 10min clamp sessions. i wrapped more than usual. and i actually felt a lot fuller i think before when i clamped i didnt wrap enough and i clamped to hard restricting complete blood flow to the penis which was not good. as my clamp session there my girth was pretty dam big than usual ;)

so anyone clamping id advise to wrap a lot. ;)

my routine today i did was.

am (wake up)
3 10min roughly clamped session
dry jelqing

pm (midday)
30mins stretching - up/so/down/btc
15mins jelq - low erection level 20-50%

pm (evening)
2 10min clamp session
dry jelqing between

felt good today hopefully will be able to do this again tomorrow and sun. :D
Click to expand...

thats good to hear...I just finished like a crazy clamped session and my girth is friggin crazy...while clamped, my girth increased by .5 inch, then after the clamp my erect girth was .25 larger...hopefully this fills in the gap for my girth routines to put an end to the others because my girth is comming along slowly.
 
Sure, but these things aren't designed with penises in mind.
Click to expand...

Exactly !

I"m over 6" in base girth and the mediums work great for me.
Click to expand...

We're in the same range.

Yeah they work great, but they won't come off.

If the curve started out wider there'd be more room between the hinge and the other end so you don't have to go "Ow!, - Fucker!" after opening it and trying to get it off.

I don't know how the big guys do it. If I go much further I'm going to make one myself for penises.

Since the thing requires a padding layer anyway, maybe the whole adjustable arm section could be a flexible material (a strap) instead of solid.

*
 
Three thoughts .....

1) you'd need more padding with those ... but no big deal ...

2) they might take too long to remove, ... when I'm done - I've had it - and want it off that very second. That could be planned around though and just start to take it off a bit sooner. (Also you'll need a tool to take them off ... which besides being a hassle means anyone Penis Enlargement-ing on the DL is more likely to get busted in the ultra-fat and highly visible clamped position before they could get it off.)

3) they might be less efficient (versus a cableclamp) from being completely circular. I've tried the cableclamp in different positions to keep that stupid side projection from digging into me and (for me) its clamping power is off about 50% in other orientations. I think it being semi-flat against the sides of the penis is half of its charm and turned in other directions it doesn't clamp as well. Maybe other people's mileage would vary.
 
icecam said:
have they got them in b&q man. were would they be in the store do you know? lol i hate asking shop assiants for things.
Click to expand...

There's a brand called "Cable Cuff" - it's all the same thing, but if you ask for "cable clamp" they'll send you to the electric area, which isnt what you want.

In the US I go to Home Depot and buy the medium for a tad less than 2 bucks each (1.70, or something like that, with gas at 2.70 other prices just dont bother me as much ;p)
 
You must log in or register to reply here.

Similar threads

Egghead1
The Importance of Heat Wrapping and a cooldown after an intense senssion
Replies
14
Views
2K
H
huge-girth
H
B
Jelqing Injury, did I go too hard and overdo it ? - PLEASE HELP !!!
Replies
15
Views
2K
DLD
DLD
DLD
C
after 1 year of PE i must still be a noob-no gains,no curve correction! HELP
Replies
17
Views
3K
DLD
DLD
DLD
I
i want to permanently enlarge my glans
2 3
Replies
49
Views
7K
DLD
DLD
DLD
S
Guys who made good length gains, question about your routine
2
Replies
32
Views
4K
DLD
DLD
DLD
Back
Top Bottom