I started a new girth routine in January that featured low-pressure pumping. After about three months, the jury's still out on my progress. The pumping, however, is definitely getting a little old. Sessions are not quite as intense or productive as they used to be. So I took a little time off last week and just resumed today with 20 minutes of clamping (2 x 10 minute sets, 5 min jelq warm-up). I think I'll continue to mix things up the next few months, but emphasize clamping again. I may cycle back onto a routine that features pumping at the end of the three months.
But the question still remains: Is all of this $#&% making a difference? In lieu of measuring girth, I've subjected my dick to the "roll test" in order to establish a bencHydromaxark for future "tests." The first shot below shows me immediately after placing on the clamp for my first set. The second shot shows me attempting to slide the roll on during this first set. I could get in on over my dickhead, but couldn't slide it any further down the shaft (I have the proverbial tapered dick, thickest at the base and thinning out toward the head). The third shot shows me wearing a ring with a hardon at the end of the workout. The last shot was taken a few minutes later and shows the unit and ring, at rest.
But the question still remains: Is all of this $#&% making a difference? In lieu of measuring girth, I've subjected my dick to the "roll test" in order to establish a bencHydromaxark for future "tests." The first shot below shows me immediately after placing on the clamp for my first set. The second shot shows me attempting to slide the roll on during this first set. I could get in on over my dickhead, but couldn't slide it any further down the shaft (I have the proverbial tapered dick, thickest at the base and thinning out toward the head). The third shot shows me wearing a ring with a hardon at the end of the workout. The last shot was taken a few minutes later and shows the unit and ring, at rest.