rarely discussed: width-depth-ratio and width/depth-girth-ratio

Hey boys,
this subject has occupied me for a while now, since I'm under the impression that my width of 2" (MSEG) doesn't correspond very well with my overall girth, which is 6". Furthermore the horizontal diameter (width from my POV) is smaller at the base and the area just above it (about 1,75" and a girth of 5,6">fucking bat!), while the "depth" or the vertical diameter of my penis seems to be very big. So to get comparative parameters, I'd be very interested in your measurements (width/girth and if possible also depth, though I have to concede that I never measured myself because it seems very difficult) and want to invite you to further discussions of the topic such as: best exercises to catch up with width (alternatives to clamping exercises would be very welcome) and depth, advantages of a big width/depth with respect to sex and so on.
cheerz

Redzulu had a lot of ideas in this area, routines and exercises so he is definetly worth looking up and researching.

As far as my exercises are concerned the DLD Bends are an incredible width exercise as well as Isolated Compression Squeezes. I have to say that, above these exercises, that were specifically created for width, the Slow Squash Jelqs are King with not only girth but width and in a very general or highly isolated way.

C'mon guys, is really nobody interested in this stuff besides me?
btw: thx for your reply, DLD. Is there a thread with a good explanation of the DLD bend?

Satyr;567651 said:

C'mon guys, is really nobody interested in this stuff besides me?
btw: thx for your reply, DLD. Is there a thread with a good explanation of the DLD bend?

Click to expand...

Yes sir, the DLD Bends are HERE. You should also look at some of Redzulus work too as I stated, here is the forum dedicated to Redzulu and his work: Redzulu's Clamping Universe Good luck on your journey and I think it is smart to attack width in the enlargement process, a wide penis looks mean as hell!

wish I would have seen this thread as I am trying to increase my width.I gain on the top and bottom of my shaft but not in the width department.

Bump