Advise on how to overcome

D

Demon7

0
Ive asked this question before many moons ago. Have started pumping again in addition to my DLD beginners routine.

I started off with [words=https://officialhydromaxpump.com/?uid=6&oid=2&affid=98]Bathmate[/words] in shower and well the experience was quite disappointing and so I have moved onto a VT tube and pump.

My issue comes with as I pump and fill up tube, notice there is a section that will never engorge or fill up (stitched area from circumcision) which leaves my shaft looking like an hourglass.

I can't seem to get over this and it's a bit bothersome. Anyone have ideas?

I stretch in all directions in fact this stitched skin I've spent ours stretching it I'm shocked my unit is still attached.

So apart from jelqs, and the like. It's a 3 10 min set at around 3-5 inHg

I have a pic and will try to post once figure out how to off my device.

- pic
View attachment 30285
View attachment 30286
 
Last edited:
Really packing that tube, what is your size?
 
Well, I have rad about air pumps and their disadvantages when compared to Hydropumps.

One of their biggest disadvantages was that the air pumps focus most of the pressure at a single point of the penis and do not spread the stress (and therefore expansion) evenly like hydropumps do (which basically leads to overintensified pumping session as the stress a part of your penis gets is times larger than the rest, which basically gives you even more FR- Fluid Retention). Do you have a [words=https://officialhydromaxpump.com/?uid=6&oid=2&affid=98]Hydropump[/words]?

Now this might not be what's going on, but honestly- this is the only way I can explain it.

P.S- I second DLD's question- your size looks really impressive! :)
 
Thanks you guys for the input. I will do my best to reply to all in order.

DLD... appreciate the compliment its been a very long time since I've measured. On a usual my measurements stand at a solid L 6.5 X 5.25 at thickest area of shaft but at best when very active in PE looking at 7 or so with girth minimally increasing at end and tip never mid-shaft.

Never really considered myself to be big but am working at it. As explained the tube is a 2x9 which was bought by following VT's measurement table which seems to have suggested a size too big for me.

I do have a [words=https://officialhydromaxpump.com/?uid=6&oid=2&affid=98]bathmate[/words] however the experience with the gator and its [words=https://officialhydromaxpump.com/?uid=6&oid=2&affid=98]comfort pad[/words] coming off after couple uses really put me off. I've used the [words=https://officialhydromaxpump.com/?uid=6&oid=2&affid=98]bathmate[/words] and just bare with the bite etc however I have to admit I never ever get a decent pump as I do with this VT. [words=https://officialhydromaxpump.com/?uid=6&oid=2&affid=98]Bathmate[/words] progress has never been as good for me as using the dry pump so I think I will continue with it for now.

Zambrodrom, I think your explanation makes a lot of sense however in my situation, it looks as if though the stitching from circumcision is just too tight in that area and won't allow for expansion as in similar to wearing a condom when pumping? I have been trying to see if I can fill up the tube hoping that once it gets to that point the stitching will snap or what not, but sadly it never happens and or I just can't take the pressure anymore (as in length of time in tube etc it just gets uncomfy).

Anyways thanks for the input and would be great to get past this.
 
Last edited:
Demon7;638510 said:
Thanks you guys for the input. I will do my best to reply to all in order.

DLD... appreciate the compliment its been a very long time since I've measured. On a usual my measurements stand at a solid L 6.5 X 5.25 at thickest area of shaft but at best when very active in PE looking at 7 or so with girth minimally increasing at end and tip never mid-shaft.

Never really considered myself to be big but am working at it. As explained the tube is a 2x9 which was bought by following VT's measurement table which seems to have suggested a size too big for me.

I do have a [words=https://officialhydromaxpump.com/?uid=6&oid=2&affid=98]bathmate[/words] however the experience with the gator and its [words=https://officialhydromaxpump.com/?uid=6&oid=2&affid=98]comfort pad[/words] coming off after couple uses really put me off. I've used the [words=https://officialhydromaxpump.com/?uid=6&oid=2&affid=98]bathmate[/words] and just bare with the bite etc however I have to admit I never ever get a decent pump as I do with this VT. [words=https://officialhydromaxpump.com/?uid=6&oid=2&affid=98]Bathmate[/words] progress has never been as good for me as using the dry pump so I think I will continue with it for now.

Zambrodrom, I think your explanation makes a lot of sense however in my situation, it looks as if though the stitching from circumcision is just too tight in that area and won't allow for expansion as in similar to wearing a condom when pumping? I have been trying to see if I can fill up the tube hoping that once it gets to that point the stitching will snap or what not, but sadly it never happens and or I just can't take the pressure anymore (as in length of time in tube etc it just gets uncomfy).

Anyways thanks for the input and would be great to get past this.
Click to expand...


It looked to be 6.5-7" to me:) Well there is something to shoot for:)
 
Demon7;638510 said:
Thanks you guys for the input. I will do my best to reply to all in order.

DLD... appreciate the compliment its been a very long time since I've measured. On a usual my measurements stand at a solid L 6.5 X 5.25 at thickest area of shaft but at best when very active in PE looking at 7 or so with girth minimally increasing at end and tip never mid-shaft.

Never really considered myself to be big but am working at it. As explained the tube is a 2x9 which was bought by following VT's measurement table which seems to have suggested a size too big for me.

I do have a [words=https://officialhydromaxpump.com/?uid=6&oid=2&affid=98]bathmate[/words] however the experience with the gator and its [words=https://officialhydromaxpump.com/?uid=6&oid=2&affid=98]comfort pad[/words] coming off after couple uses really put me off. I've used the [words=https://officialhydromaxpump.com/?uid=6&oid=2&affid=98]bathmate[/words] and just bare with the bite etc however I have to admit I never ever get a decent pump as I do with this VT. [words=https://officialhydromaxpump.com/?uid=6&oid=2&affid=98]Bathmate[/words] progress has never been as good for me as using the dry pump so I think I will continue with it for now.

Zambrodrom, I think your explanation makes a lot of sense however in my situation, it looks as if though the stitching from circumcision is just too tight in that area and won't allow for expansion as in similar to wearing a condom when pumping? I have been trying to see if I can fill up the tube hoping that once it gets to that point the stitching will snap or what not, but sadly it never happens and or I just can't take the pressure anymore (as in length of time in tube etc it just gets uncomfy).

Anyways thanks for the input and would be great to get past this.
Click to expand...

Check out my thread on the ironman [words=https://officialhydromaxpump.com/?uid=6&oid=2&affid=98]bathmate[/words] armor. It's just a couple of cockrings, but helps avoid the bite. There's also a couple responses by dudes with their own ideas.
 
I think the issue is likely: Tube is too big for my size. 2x9 therefore it requires A LOT of work to fill up tube. So far am making progress... but I think Zombro was correct about the focus of dry pumps.... I do notice the focus seems to be on either tip or end of shaft. Also too much of my balls get sucked in so I can't get the even pressure to mid-shaft.

As for [words=https://officialhydromaxpump.com/?uid=6&oid=2&affid=98]bathmate[/words] using.... I owned it 2 months and [words=https://officialhydromaxpump.com/?uid=6&oid=2&affid=98]comfort pad[/words] came off... I do get better pumps with little or no discolouration with [words=https://officialhydromaxpump.com/?uid=6&oid=2&affid=98]bathmate[/words] but the pumps don't last as long as they do dry VT pumping.... I've been complimented and actually asked not to grow more due to the pain I caused going in to my partner... I was super stoked... I never considered myself big... but then again women here are rather small figured and not so used to huge cocks...

Anyways... I would have to buy a new [words=https://officialhydromaxpump.com/?uid=6&oid=2&affid=98]bathmate[/words] and tbh its not worth the cost here.... so I appreciate the advise on how to avoid the gator bites but will have to work on that when time comes...

I thought my condition would be something someone by now would have experienced but guess not. Thanks lots for input.
 
Last edited:
Demon7;638672 said:
I think the issue is likely: Tube is too big for my size. 2x9 therefore it requires A LOT of work to fill up tube. So far am making progress... but I think Zombro was correct about the focus of dry pumps.... I do notice the focus seems to be on either tip or end of shaft. Also too much of my balls get sucked in so I can't get the even pressure to mid-shaft.
Click to expand...

It would take a lot more work but once that tube is filled you are going to be so proud of yourself!
 
BornInFigi;638812 said:
Filling a tube is a great feeling. We would all be proud.
Click to expand...

No shit! Those first pictures made me jealous!
 
You must log in or register to reply here.
Back
Top