ROP producing 0.00 volts? This is odd...

Joined
Jun 25, 2004
Messages
37
Before the ROP, my sex drive was beggining to lag and die drastically due to lot's of masturbation which surpassed the amount of sex activities I did. My erections weren't full and it looked as if I were loosing gains. I panicked but I remembered that tha Ball Zinger or ROP helped many people out!

I built one with some zinc and copper that I cut unevenly and cruedly and the latex pieces that I used I cut unevenly as well. I put the ROP on and after a few hours, I felt the effects kicking in. I was so horny that I masturbated and my sex drive went back to it's original shitty state. My sex drive rose, I went to sleep and woke up with an extremely hard morning wood. I had reawakened as a twelve year old and I was happy. I masturbated that morning though... heh.

I wouldn't wear the ROP all the time. It would come off at night and while I sat or walked so I could never really have it 24/7 and I only had it on one complete night which was my first night with the ROP. From then on, I would wear it at times and I applied two new latex pieces and it stood on one night. I also applied a new zinc and copper rod and I bought some steel wool. The cycle repeated itself and I couldn't have it on exactly all the time.

After having not worn it for about a week, I found some extremely sharp high quality scissors and I cut two even latex pieces at 2.75"which I connected to the rodsn which I had previously used for about two weeks. I created an ROP which would stay on at night and would never fall off. I've worn this ROP half of the day for about a week but I've had one extreme problem that has been bothering me... It seems as if it is no longer producing any voltage. I don't feel any hornier, I feel like my old self and I'm not waking up with a morning wood. I no longer have the steel erections I used to have... why?..

It's probably because I haven't really been sweating down there too much. I've been drinking lots of water and I have a decent diet.

Does anyone have any tips on starting this thing again?

If I can get it to start again, I'll have an ROP which will stay on me all night and send it's maximum benefits to me and I'll be extremely happy.

Thanks!
 
Your RoP is always on. Simple as that. Whether or not you are feeling it. The zinc, copper and your bodys humidity complete the "circuit" and it is "on" now.

Your early strong reactions were likely due to the excitement of having it strapped onto your cock, like when you started Penis Enlargementing and your cock wouldnt stop going erect.

Make sure your rods are high quality (see my sig link for faq if need info on this) and make sure a decent amount of the rods are coming in contact with your skin.

Then apply the final ingredient...time. Give your RoP fairly frequent use for a few weeks before deciding whether or not you have got benefits from it.
 
Sith Master
One more thing besides what levista told you. Make sure you give the metal rods a good brushing with some steel wool. Over time you lose voltage if you don't keep the rods polished up.
turtlechan
 
I also experimented with lemon juice and found that I could boost the voltage by applying a little lemon juice to the skin where it contacts the rods. It is normal for the voltage to vary though. For instance, if you shower you lower the natural ph (acidity) of your skin which will lower the voltage. I have gotten variations from .02 volts all the way up to 1.5 volts.

At least one person repoted that the lemon juice irritated his skin so don't get too carried away, it only takes a little. Also try experimenting, anything that is either acidic or basic will improve conductivity through the skin.

Hope this helps...
 
What kind of voltmeter do you need to measure the voltage? I have a small cheap VM that has a milli-volt setting but I can never get a reading of any volts.
 
SizeItUp said:
What kind of voltmeter do you need to measure the voltage? I have a small cheap VM that has a milli-volt setting but I can never get a reading of any volts.

Remember 700 milli-volts is the same thing as .7 volts. As long as your getting readings in the 500 + range, then your ROP is doing what it is supposed to.
turtlechan
 
I get a reading of zero, the needle does not move. While wearing the rop, I put one lead on the zinc and the other on the copper. I set the VM on DC milli volts but do not register anything. The VM works as I can measure the output of a power supply or battery.
 
Weird i have had similar exeriences. I wore my ROP for a while and it worked wonders. Than i saw little results and i stopped wearing it. I wore it again and i got great results. Do u guys think shaving the area has anything to do with it. Last time i cant remember but i think i wasn't shaven but this time i was and it worked. I used wool to clean it and everything iwas suppossed to. Do u guys think wearing the zinc or copper on a specific side or top or bottom has any effect?
 
Jareth said:
Weird i have had similar exeriences. I wore my ROP for a while and it worked wonders. Than i saw little results and i stopped wearing it. I wore it again and i got great results. Do u guys think shaving the area has anything to do with it. Last time i cant remember but i think i wasn't shaven but this time i was and it worked. I used wool to clean it and everything iwas suppossed to. Do u guys think wearing the zinc or copper on a specific side or top or bottom has any effect?

Be fairly close shaven, the more contact it has with the skin the better.

There is a small argument for keeping the zinc on the bottom under your testes as much as possible, but comfort is more important at all times :)
 
how do you test the volt with a voltmeter? where you put the needles that measures?,one in the ground and one in your %&! ?
 
Back
Top Bottom