So there seems to be quite a few guys out there who want to correct the curve of their penis. I'm well aware that both penis enlargement exercises (jelq and stretch) and the stretching devices can help straighten out a curve, but what if I want to make it curve?
After researching female anatomy (for science), I came to learn that a woman's g-spot is usually located on the 'ceiling' of the vagina. Since most sexual positions have the partners facing each other, it stands to reason that if the penis curved upwards, then it would cause more stimulation of the g-spot (keep your woman happy and she'll keep you happy).
I know that the vertical jelq can be used to instill an upwards curve, but I'm lazy, and while doing it I get the feeling that the curve will be formed at the base of the shaft, not near the head where I want it to be. I'm thinking about building a device to wear around the house (I live alone) and when I sleep, since during REM sleep the penis usually becomes erect. The design will be along the lines of a tube of PVC with a curve at the end. This will be attached to a base (about 2.5" in diameter) which I will attach to a harness of some kind to keep it facing the right direction. I'm thinking that the tube will be just slightly thinner than my erect width to apply a bit of pressure.
Any thoughts, comments, ideas?
After researching female anatomy (for science), I came to learn that a woman's g-spot is usually located on the 'ceiling' of the vagina. Since most sexual positions have the partners facing each other, it stands to reason that if the penis curved upwards, then it would cause more stimulation of the g-spot (keep your woman happy and she'll keep you happy).
I know that the vertical jelq can be used to instill an upwards curve, but I'm lazy, and while doing it I get the feeling that the curve will be formed at the base of the shaft, not near the head where I want it to be. I'm thinking about building a device to wear around the house (I live alone) and when I sleep, since during REM sleep the penis usually becomes erect. The design will be along the lines of a tube of PVC with a curve at the end. This will be attached to a base (about 2.5" in diameter) which I will attach to a harness of some kind to keep it facing the right direction. I'm thinking that the tube will be just slightly thinner than my erect width to apply a bit of pressure.
Any thoughts, comments, ideas?