Went too hard too soon from young tissues healing I assume. How bad is the blister?
Please advice - routine and progress
- Thread starter trustr1
- Start date
Pretty bad
Attachments
Yep. That's bad. Purchase some 30g or 32g medical injection needles. You will need this for future as well. I'll teach you how to lance it.
That looks like a 16g size. The 30g or 32g is a lot smaller. Do have those on standby.
For now, if you want to use that, go for it. The remaining lance puncture may be larger than I want.
When lancing using a medical needle, the smaller puncture is always better. The fluid will seal the puncture site back up in 10 minutes. When you lance the blister, lance close to the base of the blister as much as possible without puncturing your glans, and the lanced location around the edge should be far away from the urethra where the most bacteria tend to accumulate. With that large needle, only lance a very tiny bit to allow fluid to start the flow out. Do not lance it so much that the fluid gushes out. That hole will become too wide.
When the fluid starts to trickle out, do not squeeze the blister. Rather, use a dressing, toilet paper ply, or cotton pad to put over the blister. Gently, so gently, roll you finger from the opposite side of the punctured side towards the lanced site. You don't have to worry about removing all the fluid. Just enough to relief the blister from causing any more expanding.
Last edited:
I know how you feel.
How do I stop getting alerts?Done succesfully. Thank you!
P.S kudos for restoring gmail mail alerts.
Thanks!
Yes. The lanced site should be closed up if you do it correctly. That's the trick to prevent air from getting in and creating secondary air blister. When you gently release the fluid the first time around, the pressure is reduced, and the skin that made up the upper blister layer will come into contact with the underlying new skin. This flag the body to produce new skin layer within the first 24 hours.
Girth work today
6x6min soft clamping sets + Uli/mod jelq you name it applying grip on top of the silicon on the base and streching it upwards. with some edging. Great expension during.
Massage and NIR between sets.
2 rings at the end.
Post session was 12.25 at first, but then seems to reduced to 12.1
6x6min soft clamping sets + Uli/mod jelq you name it applying grip on top of the silicon on the base and streching it upwards. with some edging. Great expension during.
Massage and NIR between sets.
2 rings at the end.
Post session was 12.25 at first, but then seems to reduced to 12.1
A couple of things that will help you keep the post workout. Erect stretches for about 5 minutes. This will keep your erect size intact with no reduction in size. Also keeping a wrap on after every session for as long as possible. this will help you heal in an elongated state. Also remember you will always lose some length or girth for that matter after an intense session and this is due to fatigue. I hope this helps my brother. God bless you for all your doing.
Well your always going to see temporary growth when doing girth work so it is important that you use a cock ring to keep that temporary girth as long as possible as this will cement your girth in the fastest way.
God bless you my brother
