DSD Progress log

DSD80 said:
6/10/24

New bundled technique: wrap in cloth. Take lead hand (direction of turn) and turn over so thumb is toward base and on top, turn over so palm down. Use other hand to lock it. Do once more so its full turn. Then gripping around the top half, do again, 1 more half turn. Can release the bottom hand just a little to even the pressure. This is 1.5 turns roughly and can do better at being even each side until getting LM.

Heatpad, bundled stretches. 1 turn up to 1.5 turns for 30 seconds. Total 12 holds. Different jelqs with alternating hand at base, trying to stop the skin around base from pulling away from body in a semi-web..

Interval air pumping with mityvac. 3-5+ mins per. Alternating with different jelqs, theme of foreskin restoration and not worsening turkey neck/webbing

1-4 1.875” cylinder – started 5Hg. Generally pulses up to 6Hg each minute. But I tended to follow the expansion more than strict time. If I felt great expansion, I rode it out. On the 2nd pump, I had a very large expansion where 6Hg had me pushing against end of tube. I kept that for a minute.

5-6 2.25” cylinder – started at 5Hg. Incrementing +1, aiming for 1 min. Waited for expansion trigger to raise pressure. Went up to 8Hg and held that for probably 30s. Was pushing to end of tube. On 6th pump, I tried same but I think my mind didn’t focus as well and it took closer to 5 mins to hit the point.

Cockring 30mins

Redlight

I am glad that my 2.125” cylinder on the way is 12” tube so I don’t need to be limited. However, I hope this does not cause more length. It does seem like it’s usually proportional. I wouldn’t die if I got longer as long as the girth comes too.
Click to expand...
Did you receive tracking?
 
6/11/24

Warmup-heatpad, bundled stretching 30s hold 1.5 turn then increase to 2 turn another 15s x 8. Variant jelqs. Put on oxball ball stretcher just to pull skin down and hinder skin migration.

So, I am starting to use my strategy of only increasing pressure under influence of a natural erection. Sort of worked. I ended up making individual pumps take way too long waiting for natural erection. I started at 4Hg and stayed there until I felt the yearning to expand.

1st pump – 5-6mins. Went from 4Hg to 5Hg in the last 2 mins and expansion was very good

2nd pump – 7-8mins. Wasn’t really feeling it. I went up to 5Hg toward end and expand wasn’t great so ended it.

3rd pump – 10mins. Started 4Hg and went to 5Hg then finally 6Hg and expansion was good.

4th pump – 11mins. Went up to 7Hg toward the end and pressing against end of tube.

All pumps using 1.875” cylinder. Alternated all pumps with SSJ.

Edema is not good. I clearly went too long in these pumps even if most of it was at 4Hg. I think my idea is fairly sound, I just need to be able to get natural erection better. I think I am getting bored of looking at the same stuff. Hard to really focus.

Right now wearing cockring and using redlight. But I am not going to edge with cockring on. Just getting some blood back in and putting ring back on.
 
  • Like
Reactions: DLD
DSD80 said:
6/11/24

Warmup-heatpad, bundled stretching 30s hold 1.5 turn then increase to 2 turn another 15s x 8. Variant jelqs. Put on oxball ball stretcher just to pull skin down and hinder skin migration.

So, I am starting to use my strategy of only increasing pressure under influence of a natural erection. Sort of worked. I ended up making individual pumps take way too long waiting for natural erection. I started at 4Hg and stayed there until I felt the yearning to expand.

1st pump – 5-6mins. Went from 4Hg to 5Hg in the last 2 mins and expansion was very good

2nd pump – 7-8mins. Wasn’t really feeling it. I went up to 5Hg toward end and expand wasn’t great so ended it.

3rd pump – 10mins. Started 4Hg and went to 5Hg then finally 6Hg and expansion was good.

4th pump – 11mins. Went up to 7Hg toward the end and pressing against end of tube.

All pumps using 1.875” cylinder. Alternated all pumps with SSJ.

Edema is not good. I clearly went too long in these pumps even if most of it was at 4Hg. I think my idea is fairly sound, I just need to be able to get natural erection better. I think I am getting bored of looking at the same stuff. Hard to really focus.

Right now wearing cockring and using redlight. But I am not going to edge with cockring on. Just getting some blood back in and putting ring back on.
Click to expand...
Sounds like you are mastering this. Keep up the work!
 
6/12/24

Warmup-heatpad. bundled stretching 30s hold 1.5 turn then increase to 2 turn another 15s x 8. After 4 and 8, did 10 gua each side. Variant jelqs. Put on oxball ball stretcher just to pull skin down and hinder skin migration. I noticed that I felt rather squishy..

5-6x2x4 lol (5-6mins, 2min SSJ, 4 pumps) Once again, only increasing pressure when my natural erection indicates. All pumps with 1.875” cylinder.

1st pump 5 mins start 4Hg. Went to 5Hg after only a minute and fairly long expansion

2nd pump 5mins start 4Hg. Wnt to 5Hg at like 1 min. went to 6Hg at 3mins.

3rd pump 6min start 4Hg to 5 then 6 then 7. Amazing expansion. Filled tube.

4th pump 6min start 4Hg. Then to 5 at 4mins and 6 at 5mins. Still expanding.

30mins cockring total with edging

30mins cockring total with redlight no edging

There is some edema on the underside of foreskin. Nothing crazy.

EQ was amazing this time.
 
6/13/24

Warmup-heatpad. bundled stretching 30s hold 1.5 turn then increase to 2 turn another 15s x 8. After 4 and 8, did 10 gua each side. Variant jelqs. Put on oxball ball stretcher just to pull skin down and hinder skin migration.

Mityvac air 1.875” cylinder alternating with SSJ (2-3mins)

1st – 6mins just 4hg
2nd – 5 mins 4 to 5hg at ~3mins
3rd – 6 mins 4 to 5 to 6 for 2mins. Great expansion
4th – 6 mins 4Hg to 5,6,7. Great expansion.

Cockring 40mins. Alternating 10min cycles with SSJ, Bends, ICS.
Redlight 30mins
Little to no edema.
 
6/14/24

Warmup-heatpad. bundled stretching 30s hold 1.5 turn then increase to 2 turn another 15s x 8. After 4 and 8, did 10 gua each side. Variant jelqs. Put on oxball ball stretcher just to pull skin down and hinder skin migration.

Mityvac air alternating with SSJ (2 mins). Pump 1-2 with 1.875” cylinder. 3-4 with 2.125” cylinder

1st 5mins @4Hg to 5Hg
2nd 6mins @4Hg to 5 to 6Hg
3rd 6min @4Hg work up to 7Hg
4th 7mins @4Hg work up to 8Hg

Cockring ~30mins

Using new 2.125 x 12” tube. Better fit than 2.25”. I needed the extra length a bit, especially for doing water pumps this weekend. Hoping to do 2 a days on weekend.

noting that after several hours there is no edema even though I went up to 8Hg. I wonder if using wider and longer tube helped.
 
Last edited:
DSD80 said:
noting that after several hours there is no edema even though I went up to 8Hg. I wonder if using wider and longer tube helped.
Click to expand...
Yep. Remember how we discussed about elongated and buffering space? It's very applicable to water usage, and semi-applicable to air.
 
6/15/2024
Warmup-heatpad. bundled stretching 30s hold 1.5 turn then increase to 2 turn another 15s x 4. After 4 did 10 gua each side. Variant jelqs. Put on oxball ball stretcher just to pull skin down and hinder skin migration. Also did a bit of firegoat rolls as they call it periodically throughout session.

Mityvac air alternating with SSJ (2 mins). Pump 1-2 with 1.875” cylinder. 3-4 with 2.125” cylinder. I wrapped my heatpad on high around the tube while pumping.

1st 6 mins @4Hg to 5Hg
2nd 6 mins @4Hg to 5 to 6Hg
3rd 6 min @4Hg work up to 7Hg
4th 6 mins @4Hg work up to 8Hg

DLD bends
Cockring
Redlight

No edema but quite a bit of tiny red dots in top half and some darker spots underside foreskin. Not sure when these are developing.

Did not do 2 sessions as I thought I might. Ran out of time so made the 1 count. Not sure I'll have time tomorrow but we'll see.
 
I'm suspecting the red dots are the pronounced abrasion from the gua sha. Reduce the pressure from 1.5lbs down to 1.25lbs or 1lb. When gua sha is used without any additional pressures, such as accu pressure cups or deep tissue massages, no bumps will be visible as the abrasion is too small to see. However, adding high vacuum pressure to reveal the hidden abrasions, on top of frictions during the bending and flexing of tissues, the micro manifestations come out more pronounced.

Give the gua a lighter pressure and see if that resolve the issues.
 
I don't know.. I'm pushing pretty light on the gua sha. The tiny red dots clear up pretty fast. And I actually don't gua sha the part of the foreskin that is darker. I wonder if its chafing during bundles.
 
Possibly. Ease up on the tension either and deduce the cause. Either way way, if there isn't any harm, there's no alarm. It's just signs of frictions and abrasion.
 
6/16/24

Warmup-heatpad. bundled stretching 30s hold 1.5 turn then increase to 2 turn another 15s x 8. After 4 and 8, did 10 gua each side. Variant jelqs. Put on oxball ball stretcher just to pull skin down and hinder skin migration. Firegoat rolls here and there throughout session.

Mityvac alternating with SSJ (20x 3-5s squashes) and misc jelq. Pump 1-2 AIR with 1.875”cylinder (note: wrapping cylinder in heatpad on high). Pump 3 WATER with 2.125x12” cylinder.

#1 10 mins @4Hg mostly then up to 5Hg in last couple mins. Surprised at how good expansion was.
#2 10 mins @4Hg then 5Hg at ~6mins and 6Hg in last 2 mins. Great expansion.
#3 10 mins @5Hg then 6Hg at 7mins and 7Hg for last minute. Great expansion. Was tempted to do more but I was over the 9 inch mark and seemed close to filling sides.

DLD bends for a bit, some SSJ, and various jelqs.

Edged for 10-15 mins, wrapping in heatpad for like 3 on 1 off. I wanted to use heat for a bit before putting on cockring because I think when I develop edema, cockring might be contributing.

Cockring 10mins.. was tempted to measure because I was feeling massive. EQ was amazing.

Redlight 30mins

I was definitely feeling good about the 10 mins low/mid pressure pumps. If I get natural erection, even 4 or 5Hg can make me balloon over time. I was wrapped in heatpad so actually couldn’t see until at the end and was surprised that I was almost filling the 1.875” cylinder on just the first pump. The sides up to probably 6+ inches were stuffed good.

(one last check for edema.. and none)
 
Forgive me for subjecting you to a closeup lol.. But awhile back I noticed this circular spot on the underside of shaft that looked like the topmost layer of skin split. And lately I've noticed 2-3 of these spots. You can see one of them in this picture. If I spread the skin, these circles open up. I don't believe there is any pain. This is post-pump, so things look a bit rough..
 

Attachments

  • 20240617_012345.jpg
    20240617_012345.jpg
    1.7 MB · Views: 9
They are visual abrasion manifested from skin stretches through pumping. I get them from time to time. When I go a bit too roughly with the Length Master or SSJ with dynamic bundled twisting without lubrication, they show up after three to four pumping sessions past 7inHg. They don't normally show up around 5inHg. No worries.

You can heal them faster with a both of warm compression (warm towel) for 15 minutes and use liquid Vit E or virgin coconut oil.
 
  • Like
Reactions: DLD
Can someone red circle the areas in the picture above (post #297), I don't see anything.

*Edit, I think I see it now.
The penis is very tough. When we progress in our penis enlargement we will know that these marks are nothing to worry about.
 
You must log in or register to reply here.
Back
Top