Complete newbie looking for advise

If you don’t have the MOS-RED take a hot bath or shower to warm up with this will also loosen your balls.
 
And then suppose we finish girth exercise. Use mosred again for heal ? What if you have to do LM work ? Can u give me more details please ? I have mosred
 
And then suppose we finish girth exercise. Use mosred again for heal ? What if you have to do LM work ? Can u give me more details please ? I have mosred

Warmup with the MOSRED before starting any session for the day. You can even warm up with only warm water before starting your session. This thing is super easy.

Once you finish your length or girth session for the day, you can warm down with the MOSRED.
 
Newbie answer

Useb10 minutes for warmup
Use throughout work put
Use 10 minutes after
 
And then suppose we finish girth exercise. Use mosred again for heal ? What if you have to do LM work ? Can u give me more details please ? I have mosred
You are complicating something that do not need to be complicated.

I use MOSRED for healing only (after session) at 15 minutes. You can also use it as warmup tool.

I have 2 heating fans and MOS-RED to optimize this process. It's important to keep your tissue really warm before and during session.
 
And then suppose we finish girth exercise. Use mosred again for heal ? What if you have to do LM work ? Can u give me more details please ? I have mosred
use a note pad to write down all the little tips your getting so you can run through a checklist every session.
I wish I had, I would have progressed faster!

It’s very easy to forget the little things at first but it’s the little things put together that make everything work.

This applies to stretching but the advice is the same.

if had a check list:
mos red + lig and ball stretches.
Tie scrottum
Apply chalk
Retract foreskin
Green theraband
Pull back any loose skin/ remove wrinkles.
Bandage
Theraband

write down how you tighten in the chamber so you don’t Pinch.
Tighten with a thumb press on glans, pull back a little, tighten more, (still pressing on glans)
Do some cranks, tighten, stretch all directions, tighten more and so on



I went through a faze when I could not clamp because I started doing something differently and didn’t I realise.

Heater fan on,
Set timer 5 mins.

I read @squirt_inducer_man advice to do things like use chalk a thousand times before I actually started doing it.
 
You are complicating something that do not need to be complicated.

I use MOSRED for healing only (after session) at 15 minutes. You can also use it as warmup tool.

I have 2 heating fans and MOS-RED to optimize this process. It's important to keep your tissue really warm before and during session.
do you sell heating fans
 
do you sell heating fans
No I don't. Also it's not allowed to advertise your own products on the forums, but I add a picure here.

View media item 1432I have hidden the logo of the heating fan. As I said you are not allowed to advertise your own products here (I have no products).


But i suggest MOS RED as well for the healing aspect of it. Do you have it?


 
Yes I bought MOSRED Ok i will think my plan and let you know
Wonderful.

I realised heating my tissue was so important, in order to get s good stretch. I have used this old car interior heater since my broomstick routine.

For me it wasn't sufficient with a warm soaked towel. It's not that hot inside and I can't regulate my indoor temperature. Also having a stream of hot air into your tissue is more efficient then jusy keeping your indoor temperature warm.
 
Something I learned from @DLD and @squirt_inducer_man you need to warm the tissue in between stretching sets to pull harder. If you are using the LM.

10-15 minute warm up before girth and after girth. The same with stretching just make sure you apply heat to the penis in between LM sets.

I hope this helps!
 
Something I learned from @DLD and @squirt_inducer_man you need to warm the tissue in between stretching sets to pull harder. If you are using the LM.

10-15 minute warm up before girth and after girth. The same with stretching just make sure you apply heat to the penis in between LM sets.

I hope this helps!
Wonderful advice.
🔥Heat is so important for fast growth.
The penis should never be cold when doing penis enlargement. That includes the inner penis as well. Warm the inner penis up as well.
 
Wonderful advice.
🔥Heat is so important for fast growth.
The penis should never be cold when doing penis enlargement. That includes the inner penis as well. Warm the inner penis up as well.

Yes sir! Honestly I couldn’t tell if I was sore yesterday from all heat it wasn’t until the next day I could feel the soreness.
 
Yes sir! Honestly I couldn’t tell if I was sore yesterday from all heat it wasn’t until the next day I could feel the soreness.
Just make sure you are not burning yourself...but I do not believe you are.

Yes the soreness is the wonderful feeling of gains to come. Throughout my journey I made sure I always felt soreness in my inner penis.
 
use a note pad to write down all the little tips your getting so you can run through a checklist every session.
I wish I had, I would have progressed faster!

It’s very easy to forget the little things at first but it’s the little things put together that make everything work.

This applies to stretching but the advice is the same.

if had a check list:
mos red + lig and ball stretches.
Tie scrottum
Apply chalk
Retract foreskin
Green theraband
Pull back any loose skin/ remove wrinkles.
Bandage
Theraband

write down how you tighten in the chamber so you don’t Pinch.
Tighten with a thumb press on glans, pull back a little, tighten more, (still pressing on glans)
Do some cranks, tighten, stretch all directions, tighten more and so on



I went through a faze when I could not clamp because I started doing something differently and didn’t I realise.

Heater fan on,
Set timer 5 mins.

I read @squirt_inducer_man advice to do things like use chalk a thousand times before I actually started doing it.

Excellent post
 
Back
Top Bottom