Please advice - routine and progress
- Thread starter trustr1
- Start date
Sounds like that growth is permanent
In today's girth session i had to stop early.
Weird thing.. with one small pump the gauge went high up (like when the valve is closed and there is no real suction). Suddenly the gauge went maybe 2-3inhg higher with small pump ended up at 10.5.
I find it hard to believe it was true since i didn't felt or saw my penis reacting accordinly. I was wow since i reached that inhg lets stay here for 20sec.
Anyway.. after that on my c jelqs. Something started to feel off.
I had internal cold feeling inside my dick. Some weird dull pain but almost not felt. Just off feeling.
I said to myself ok.. im not taking any chances here. Im gonna stop now.
I tempted to do one more pump at low pressure and felt some minor uncomfortable. And then i stopped.
Immedietly did MOSRED. And skipped the ring. After few hours i felt better.
Bottom line. Safety first. If i wasn't injured in my past i might have not notice today the early warning signs.
Weird thing.. with one small pump the gauge went high up (like when the valve is closed and there is no real suction). Suddenly the gauge went maybe 2-3inhg higher with small pump ended up at 10.5.
I find it hard to believe it was true since i didn't felt or saw my penis reacting accordinly. I was wow since i reached that inhg lets stay here for 20sec.
Anyway.. after that on my c jelqs. Something started to feel off.
I had internal cold feeling inside my dick. Some weird dull pain but almost not felt. Just off feeling.
I said to myself ok.. im not taking any chances here. Im gonna stop now.
I tempted to do one more pump at low pressure and felt some minor uncomfortable. And then i stopped.
Immedietly did MOSRED. And skipped the ring. After few hours i felt better.
Bottom line. Safety first. If i wasn't injured in my past i might have not notice today the early warning signs.
Yep, this is the primary issues for most cheap pumps out there with improper suction or improper measuring. Luckily you discover early on before any worst case scenario kicked in.
Good man. This is crucial that we do not engage any further activities when you know something didn't go right. The cold feeling is the indicator that the nerve branches went too far in either tearing for pushed by the internal tissues to the point where the nerve cannot detect the neuro connection at the nerve endings.
For now, you can do light downward jelqs for the next few days. Consider it as rest days to recover. Use MOSRED for the next feel days as well. However, you can provide passive stretching during this healing period using loose sleeves or loose wraps. The continuous warmth and elongation will force the penis to receive the blood flow it needs for healing.
Sudden surge in a Bathmate pressure between the hose and the pressure gauge, I can only suspect either the quick connector didn't snap on tightly OR, the sudden dislodged of something in the pressure valve at the top of the unit while under pressure caused it. It could be dead skin, old lube, mineral build up, or even lose hair. Always good to perform quick light maintenance after every month, use or unused of the BathMate.
Yeah i actually jelq with soap and then enter my penis to the pump with soap remaining.. and to be honest i sometime don't wash the unit throughly aftee use. So maybe that.
Clean after every session. Using soap can lead to dry skin i suggest another water based lubricant
Hi
I had today my first girth work since "the incident".
Went ok. Took it lightly and with caution.
Before the workout i measured 11.8cm which is good and im happy about my gains. Wonder if that is only from girth work or also little by the ADS since i use maximum vaccum or almost max.
after expantion 12.3 which is not so great.
My new short term goal is to be above 12.0cm before girth work. And reach to 13.0cm expansion
By the way about after ring.
I use the smallest sili rings. I out it while im 80-90% erect and it fell to 30% within 2-3 minutes. And to 15% maybe after 10min. Not sure it suppose to be like that.
I had today my first girth work since "the incident".
Went ok. Took it lightly and with caution.
Before the workout i measured 11.8cm which is good and im happy about my gains. Wonder if that is only from girth work or also little by the ADS since i use maximum vaccum or almost max.
after expantion 12.3 which is not so great.
My new short term goal is to be above 12.0cm before girth work. And reach to 13.0cm expansion
By the way about after ring.
I use the smallest sili rings. I out it while im 80-90% erect and it fell to 30% within 2-3 minutes. And to 15% maybe after 10min. Not sure it suppose to be like that.
Don't worry so much about it. There is expansion and that's what you want. You are easing back in. Allow the tissues to ease back in as well. The key is progressive expansion. As long as you have expansion, you are good.
Hm, that sounds like 70% restrictive flow. Use a light layer of wrap at the base to add some thickness compress on both sides of the penis. That will increase the restrictive flow up to 80% or even 90%.
I can't believe the forum is back.
It was very difficult to be without it.
Just updating my status:
Decided to take some decon break for two weeks or so.
Reasons: no length gains since april 2024.
Felt pain near my base in last pumping session.
My glans needed to heal from vaccum of ADS.
Moving on - I plan to use new extender with high intensity under infra red heat of around 40-42c - 1 hour a day. And use ADS for the rest of the day.
For girth same 553. I consider introducing bit soft clamping.
P.s measured girth today after a week break. Doesn't seem i lost gains.
Thanks and welcome back!
It was very difficult to be without it.
Just updating my status:
Decided to take some decon break for two weeks or so.
Reasons: no length gains since april 2024.
Felt pain near my base in last pumping session.
My glans needed to heal from vaccum of ADS.
Moving on - I plan to use new extender with high intensity under infra red heat of around 40-42c - 1 hour a day. And use ADS for the rest of the day.
For girth same 553. I consider introducing bit soft clamping.
P.s measured girth today after a week break. Doesn't seem i lost gains.
Thanks and welcome back!
Just updating my status:
Decided to take some decon break for two weeks or so.
Reasons: no length gains since april 2024.
Felt pain near my base in last pumping session.
My glans needed to heal from vaccum of ADS.
Moving on - I plan to use new extender with high intensity under infra red heat of around 40-42c - 1 hour a day. And use ADS for the rest of the day.
For girth same 553. I consider introducing bit soft clamping.
P.s measured girth today after a week break. Doesn't seem i lost gains.
Thanks and welcome back!
A decon break is sometimes just what we need. Not only physically but also mentally as it allows us to think on exactly what we need and what we should change to make our routine bettter. Sometimes it means you need to up the intensity to get things jump started. Take this break but also consider what I said.
Missed you and the rest of the Brotherhood. The wait took the patience of JOB. But in the end I was rewarded like JOB. So happy to be back!That's exactly how i felt
Missed you guys.
I wonder if i should add a little bit of clamping to my girth routine.
To my understanding there is hard clamping with a plastic or soft clamping with a silicone rings or sleeves. While soft seems less aggressive i also read that with hard you have quick release bottun while with soft it takes time to start removing all the sleeves.
To my understanding putting one sili ring for example not considered soft clamping as it doesn't keep all the blood inside and maintain an erection by itself.
Maybe you have some idea of safest way for soft clamping ? Silirings would actually be good because they have the ears to hold and remove tension fast. Maybe several of them?
P.s lately there some issues while clicking post it says we run into issues then i need to refresh the page and post again and it works.
To my understanding there is hard clamping with a plastic or soft clamping with a silicone rings or sleeves. While soft seems less aggressive i also read that with hard you have quick release bottun while with soft it takes time to start removing all the sleeves.
To my understanding putting one sili ring for example not considered soft clamping as it doesn't keep all the blood inside and maintain an erection by itself.
Maybe you have some idea of safest way for soft clamping ? Silirings would actually be good because they have the ears to hold and remove tension fast. Maybe several of them?
P.s lately there some issues while clicking post it says we run into issues then i need to refresh the page and post again and it works.
This is a life choice. I'll get into it, but approach with full of cautions.
Yes, this is true, but at the same time, the trigger can and will fail. 80%+ cases that came through the emergency rooms from penile injuries were due to hard clamping devices with quick release triggers that ultimately failed. This was why the campaigns from the device manufacturers for a few years warned males not to use the devices for hard clamping. However, if you can modify the hard clamps with safety measures, go for it. I have, and still have them for references.
SiliRings is meant to assist with stronger penile blood constriction on top of the natural venous blood constriction. If you have weak venous blood constriction, then additional needs is needed. Example, a combo of a tighter sleeve and SiliRing, or as for me, I also use TheraBand and SiliRings or TheraBand and sleeve. Cutouts.
Ultimately, it's to only slow down the blood from leaving through restrictive means and not fully cut off the blood flow through constrictive means. Venous constriction doesn't mean it shuts off all blood flow. It merely acts as a temporary flood gate valve to shut off and release immediately when unfavorable conditions are detected. If you look under s microscope or an active medical scanner, the blood vessels close and release very quickly, allowing a micro level of blood exchange every second. We do not want to deviate away too far from that.
Yes. This is what we're reported across the entire internet world. We're working with developers and programmers to get it fixed. We're pretty annoyed by it. Imagine when you have to refresh a code page right in the middle of a live programming session and lose 30 lines of codes.
Damn Moses you are super smart. Can you part the Red Sea for me?
Thanks man
I think I can deal with a few bubblesI can part the bath water with the internal body bubbles. That's pretty much it
