DSD Progress log

5/19
Was an offday. I think I was turtling. I decided to do some work but no pumping
heatpad/red light
5-10mins of bundled stretching
10 mins directional jelqs
5-10mins of SSJ
After this, I was measuring MSEG a little bit over 5.5" with soft tape measure.

New pump sleeves are on the way. I went with ones that didn't have a flange. Will see how those hold up.
 
5/20
used heatpad quite a bit to hang low

warmup 10mins bundled stretches
5 mins directional jelqs
3 rounds SSJ alternating with 2 round mityvac air pump with mitysleeve up to 7Hg. Some variable pressure used
2 rounds SSJ alternating with 2 round bathmate water with insert up to full compression of bellows
cockring 1+ hrs
heatpad, redlight
Some edging trying to balloon erection as much as possible
Expansion: I think was only up to 5 7/8 MSEG

woke up 5/21 with hard morning wood
did typical 120 short pulse kegels and 5-10s hold x 60 kegels
did directional jelqs in morning to get a jump start on hanging low during day

I see new pump sleeves without flange were delivered.. will try out tonight....
 
Funny how the body responses to the PE routines by reinvigorating the penis, thinking the penis is still trying to impregnate the world even at the age of being half dead.
 
  • Like
Reactions: DLD
How do I get a replacement part sent to me? I finally found out what was wrong with my mityvac. There is a bad seal in the water trap. I noticed that the pump gun was in fact getting suction through the hole in the water trap lid. But if the trap has water in it, if I turn it upside down, the water leaks out through parts of the lid. I'm not sure if the trap itself is bad or the lid is bad.
 
5/22

Got new pump sleeves from Leluv. Mixed feelings. Cheap. No padding. Has a 1.5 inch hole and is not very stretchy so I couldn't slide in. Had to use fingers to stretch around then attach tube. Despite it being listed as fitting 2.0 to 2.5 inch tubes, it barely fit over the 2.25. So by the time I got it all situated, lost most of erection. I went up to 3Hg and stayed there until I reached natural erection then went up to 5-7Hg. It wasn't horrible...

So I mentioned this above already.. In morning..
did typical 120 short pulse kegels and 5-10s hold x 60 kegels
did directional jelqs in morning to get a jump start on hanging low during day

Later in day..
warmup
heatpad
4 bundled stretches 2-3 mins each hold.
5 mins directional jelqs
Alternate SSJ and mityvac air pump x 2.
Used the leluv 1st pump and the mitysleeve on 2nd.

Jumped in shower
bathmate x 2
Felt a pull inward, keeping me from fully expanding.

Thoughts: I wonder if I am overtraining which is causing this pull inward. I wonder if I should just do a daily 2 pumps with bathmate for a few days and see what happens.
 
It may just be your pelvic floor muscles play a pulling game under tension. Once you experiment with the pumps, switch to a few days without kegels.
 
5/22

Attempted to do a faster but effective workout. Still ended up taking significant time..

Started in shower
bundled stretches 4x30-60sec holds
directional jelqs ~5mins
bathmate water pump up to full bellow compression x 2
cockring, red light, heatpad, edging/ballooning for 1+hrs
SSJ for about 5-10mins

I felt like I got a ton of expansion during bathmate pump. Always difficult to see the true size because of the water but it sure seemed like I was getting close to sides of the tube. I was breathing in deeply through nose which seems to help me expand. I was doing slow gyration/thrusts of hips with an outward pull on tube. Achieved a zen-like state and felt like I was completely filled but wasn't uncomfortable.

Maybe I can do just 2 pumps with bathmate a day and get good results. I didn't feel any inward pull resisting full erection. Everything felt pretty loose.
 
So crazy thing. Thanks to another member, I found out that I was missing the O-ring in the water trap part of my mityvac. I went to request a replacement thinking I never got one since my water pump never worked since I got it. But then I was in bathroom and moving around some stuff and see this little black circle on ground and there it is. No idea how it fell out and was just lying on floor for like 2 months.

I tried the mityvac water pump and I have to say it worked really well. Again, always hard to tell with water but it sure looked like I was filling the sides up almost the entire length of 2.25" tube. I wonder how much of that was real. I can't say that I felt an undeniable fullness. It was very comfortable though. I went up to 5-6Hg. Maybe I will alternate with bathmate. I am sure each has their advantages.
 
DSD80 said:
So crazy thing. Thanks to another member, I found out that I was missing the O-ring in the water trap part of my mityvac. I went to request a replacement thinking I never got one since my water pump never worked since I got it. But then I was in bathroom and moving around some stuff and see this little black circle on ground and there it is. No idea how it fell out and was just lying on floor for like 2 months.
Click to expand...
Awesome! Glad you found the O-ring, I think with a little more practice you are going to really enjoy the mityvac.
 
I realized I don't need to run the shower to water pump. I'm going to do warmups at desk then have large spaceheater going toward the shower for the water pumps. Would be good to uncouple showering and pumping. Will be easier after pump routine since I won't have to dry off and take care of my beard. Mityvac, with the water trap is actually almost doable at desk if I put down something to collect a bit of water. Bathmate definitely needs full on bath/shower though.
 
I used to do water pumping in the shower in the first month. I do water pumping on the bed, sofas, and chairs now. It takes a bit of adaptation to learn how to do things outside of the bath/shower. Too bad BM and cylinder using water doesn't have an input valve to add water outside of shower/bath areas. Looks like I have to create a cylinder that allows this.
 
Yesterday I tried mityvac water pump and it worked well. Today, my EQ just wasn't good enough until I ran into water trap being too small to continue pumping. Why did they make it so small? I can't even properly release the pressure with the pump gun when its so full.
 
You must log in or register to reply here.
Back
Top