Silisleeve and Cap thoughts
- Thread starter bluetard117
- Start date
Not sure if the 2 inch is just wider and not actually longer, so would it benefit you if it is not longer.
@Lightning are there any plans for a Silistretcher cup that is longer, so that it would cover the entire glans.
I’m thinking that this would also cause some expansion in the glans if one were able to put the entire glans inside the Silistretcher as opposed to just say half or three quarters of the glans.
@Lightning are there any plans for a Silistretcher cup that is longer, so that it would cover the entire glans.
I’m thinking that this would also cause some expansion in the glans if one were able to put the entire glans inside the Silistretcher as opposed to just say half or three quarters of the glans.
- Joined
- Jun 3, 2003
- Messages
- 4,176
Fully retracted, the depth of the SiliStretcher2 cup is 1.5" from the SiliPad2 to the edge of the SiliStretcher. Unless your glans is longer than 1.5", your glans should be fully inside the SIliStretcher if you are using it correctly. The depth of all three size SiliStretchers are the same.
- Joined
- Aug 16, 2009
- Messages
- 673
So the width of the chamber on the 2” one is 2”?
- Joined
- Jun 3, 2003
- Messages
- 20,066
When I used to use it, I preferred the glans entirely inside.
- Joined
- May 31, 2013
- Messages
- 859
- Joined
- Aug 16, 2009
- Messages
- 673
I'm trying to figure out exact placement of the silisleeve after rolling it on. Do I want the thicker end on the glans, or just under the ridge? If it's on the glans, I can't really get the entire glans inside the chamber. If it's on the ridge, then I can with a little finagling. I still want the tip of my glans pressed to the gel pad for comfort, but I'm curious how it was intended to be used for this specific bit.
- Joined
- Jun 3, 2003
- Messages
- 124,476
Well if that’s the case I would try this too. I hope you have a great success with this. Remember to have patience with yourself.
Similar threads
