Progress thread Dave4139 D DIARY
- Thread starter Dave4139
- Start date
Congratulations and take your time learning the pump. It is extremely powerful.
You're going to be amazed at the intensity you have Uber hydro max.
squirt_inducer_man
(SIM)
Increase the pressure slowly and exponentially from session to session. Time is your biggest friend.
Abdiel Bull Berg
New member
I would say stay below 10hg in the beginning to get a feel for it. Personally I go a bit over 15hg, more like 17-18hg for a little while though it’s not reccommended nor considered safe going that high but my penis seems to handle it well.
I think it’s due to my penis being so conditioned from using the Bathmate HydroXtreme 9 which goes up to 16-20hg of pressure.
Anyways, best of luck with your MityVac, you won’t regret buying it that I can promise.
Good advice.
I’ve got the hydro extreme 7?Or hydro max 7. Whichever is a manual7” pump that you crank by hand until no more water comes out the valve . I’m definitely conditioned to the max pressure of a BM and have no real issue using it for 5x5x3 so I figured I can handle more than 3-5hg that is recommended for new pumpers.
guess I’ll play it by feel lol. Either way I won’t stay in there longer than 5 min at a time since that’s been successful for me so far.
Abdiel Bull Berg
New member
Yepp, it’s the HydroMax you’ve got then as the Xtreme comes with a hose and a hand held pump that you squeeze. The HydroMax I think goes up to about 15hg if I remember correct, read it somewhere, so you should be able to handle 10hg in the MityVac like a champ.
Going for 5 mins max is a good idea as it will be less fluid build-up and discoloration. Used to go for 15-20 mins straight with my first Bathmate, a HydroMax 7, and always got some serious doughnut dick, severe fluid build up and bad discoloration. What I do to prevent discoloration is to roll my penis back and forth between the palms of my hands. Almost massaging my penis.
And don't forget the 5x5x3
Alright fellas. MityVac showed up. (Took til 9pm to get here. I wish I could’ve just drove the half mile across town to USPS and walked in and got it.
However. This thing is so much better than a Bathmate. DLD the tube recommendation was spot on for length pumping. I could literally see it gaining length as I squeezed the handle.
One question I do have- as tonight was more of just a familiarization exercise.
Do y’all typically keep the pump connected to the MityVac? And keep adding pressure since it slowly fades down.
Or are you going to a max pressure- and disconnecting the valve/ hose set up to lock in the pressure?
Which is the intended way?
I stayed below 10hg the whole time tonight for safety and man did it still get real red.
The length I was able to see as I started pumping was great. It’s just what I need. The BM will be great maybe 1-2x a week just for a pump up in girth. But this will definitely be part of the rotation now. I’m excited.
However. This thing is so much better than a Bathmate. DLD the tube recommendation was spot on for length pumping. I could literally see it gaining length as I squeezed the handle.
One question I do have- as tonight was more of just a familiarization exercise.
Do y’all typically keep the pump connected to the MityVac? And keep adding pressure since it slowly fades down.
Or are you going to a max pressure- and disconnecting the valve/ hose set up to lock in the pressure?
Which is the intended way?
I stayed below 10hg the whole time tonight for safety and man did it still get real red.
The length I was able to see as I started pumping was great. It’s just what I need. The BM will be great maybe 1-2x a week just for a pump up in girth. But this will definitely be part of the rotation now. I’m excited.
Also. Tips on type of lube you use for length pumping and how to clean inside the tube afterwards lol.
Alright. 5x5x3 with Mity Vac today. Kept it around 10hg pressure.
Still getting used to the pump- I kept it attached to the valve today bc when I released I would notice I’d lose length. Keeping it attached I was able to pump up to 6.75 or so and hold that from my normal 6.5 or so length.
During the SSJ portion I was doing SSJ and some deep jelq type stuff just to expose more inner penis for extra length.
Already a huge fan of the MV and think I enjoy it more than the LM3 even. Pumping just seems to work best for me- but the pros swear by LM3 as the premier tool so I won’t abandon it.
Def excited about the MV purchase and it’s potential.
Of note. Air pumping definitely gets me discolored more than hydro pumping.
Still getting used to the pump- I kept it attached to the valve today bc when I released I would notice I’d lose length. Keeping it attached I was able to pump up to 6.75 or so and hold that from my normal 6.5 or so length.
During the SSJ portion I was doing SSJ and some deep jelq type stuff just to expose more inner penis for extra length.
Already a huge fan of the MV and think I enjoy it more than the LM3 even. Pumping just seems to work best for me- but the pros swear by LM3 as the premier tool so I won’t abandon it.
Def excited about the MV purchase and it’s potential.
Of note. Air pumping definitely gets me discolored more than hydro pumping.
2 5x5x3 pump session today in MVac. Mostly just to gain experience with it
Although the second round I shortened it to 4 min.
Still dry pumping. I don’t use sleeves or cap etc. I guess we will see tomorrow if I get fluid retention or how red etc. it just seems like a lot of extra work to lube up the sleeve enough to get it in. Already having enough trouble getting the erection through the end cap sleeve that thing is tight. I’m sure it will loosen with use though.
Love the precise ruler in the MVac where you can see .1 increases.
Although the second round I shortened it to 4 min.
Still dry pumping. I don’t use sleeves or cap etc. I guess we will see tomorrow if I get fluid retention or how red etc. it just seems like a lot of extra work to lube up the sleeve enough to get it in. Already having enough trouble getting the erection through the end cap sleeve that thing is tight. I’m sure it will loosen with use though.
Love the precise ruler in the MVac where you can see .1 increases.
Abdiel Bull Berg
New member
I just use some water or coconut based lube and all I need to do to clean it is to properly rinse it off in the shower and then just wipe it dry with a hand towel. Real easy to do.
And yes, always keep the hose/hand-pump attatched to the valve.
Abdiel Bull Berg
New member
When it comes to discoloration just massage/roll your penis back and forth between the palms of your hands after every pumping set.
I do it everytime myself and get way less discoloration from doing so.