x20 x30

Beertaxi;763870 said:

What worked for me with the Vacu-vin mod was using a skin cone. I didn't have to fiddle with the valve at all.

https://tlctugger.com/product/bathmate-conversion-cone/

Click to expand...

Never heard of this being used, very cool, what gave you the idea?

arkailija when pumping using the "o" ring method what is starting postion of the pump fully open or closed? I have tried pumping with pump closed outwards and get i get suction but when trying to release its stuck unless i pump inwards then the water bubbles up inside the bathmate any tips you can give me? ill have to make a video and upload it.....

I fill the pump with water, put it on, the pip being closed and also the valve being totally closed. (Not being able to push it down.) Then I flick the pip and start pulling the Vacu-Vin, creating a suction. Then take it off to release the water inside the Vacu-Vin and pull again. When I'm good and done, I'll open the valve and slowly push it, to release pressure gradually.
I've noticed during the years that the gradual release of pressure really fights against any fluid buildup or blisters.

how do you close the valve on the x30 ?

The pip can be pushed to the side and will click when closed

thanks i know about pip but arkailija makes a distinction between the pip and valve!

Maybe it's the Extreme only, where you can turn the valve so it can either be pushed or not be pushed down. But if it doesn't turn, the just flick the pip. Middle is open, either sides are closed, at least in my Extreme.

arkailija;764157 said:

Maybe it's the Extreme only, where you can turn the valve so it can either be pushed or not be pushed down. But if it doesn't turn, the just flick the pip. Middle is open, either sides are closed, at least in my Extreme.

Click to expand...

Thanks for that insight Ark!