Well I did it. The Mark I has been done
I did not use the product I mentioned earlier because there was none in country and colour was odd as seen in reviews.
I used this one instead:
http://cloneboy.eu/?q=node/1
So let me fill you in on how was it.
In general it did what it was supposed to do: create copy of my cock.
If you plan to take this one up you really need some one to help out so get your lady in the groove.
I managed to pull it off solo but it was hard and with some fail.
First of let me tell you about the manual.
Sure the generic instructions are there but it does not take into account your size at all (unless you are under 6"x5").
Instructions tell to cut the
package cylinder plastic and tape it together to form 6" tube. That was problem for my 5,5 girth, the damn paste did not want to get past my head
I did manage to work it around myself by bending the plastic tube a little so it filled up.
Now this bit was my second fail.
Trying to stay hard, mix-pour-play in the paste + trying to hold the
cylinder so I would not hug the wall of it, resulted slightly mangled bottom part of the mould. I tried to correct it with strong tin wire so it would come out ok but I did not get it 100% round. On the top its bit oval not round like should be.
Never the less it did work out ok in the end.
The materials?
The mould powder was easy to mix but the ,,will harden within 3min'' was really short for me
So first mould ended up as block of rubbery stuff in the mixing bowl that you can bounce around.
This was my first fail
I waited too long to pour the stuff. If you mix it pour it right away!
The good thing about this stuff is that once hardened you can just peal it off. So the ,,use the wisp from kitchen'' idea is ok no need to worry that you ruin it.
Spills are also easy to clean up due the pealing factor.
The silicone rubber?
The container is not well sealed, some of it got out during the transportation. Mixed in the hardener in the cup it came with, without issues and poured into mould.
After pealing the thing out of mould the impression was better than expected. Wow didn't know my head was THAT big
The material is really stiff once hardened.
The stiffness is compared to those kids small rubber super well bouncing balls. Not dildo material in my opinion.
Sure it will work as my personal monument in time
Warnings:
Once the mould has been formed leave it standing for while and put plate under it or something.
Some of the water in the mix will come out (also some inside the mould).
There is hidden plastic glove in the
package (around the black rubber thing you use to make seal on the bottom of your
cylinder).
It did not seem as glove when I unwrapped it so do not discard it!
Summary.
The thing works, no irritation on skin.
Too stiff to be actually pleasurable for women (judging based on wife likes/dislikes).
Do not follow the instructions to the letter! Expand the
cylinder so you get atleast 0,5" space between you and
cylinder!
Get some one to help mixing and pouring the stuff! This is a must because concentrating on mixing and staying hard is frigen hard
Time is very short on hardening both mould and the rubber so be quick (use 1,5 minutes mixing for each).
The ,,Lasso'' it came with I will keep as it is most comfortable one I have tried yet thanks to the button adjuster.
Keep in mind, you will not get your BPenis EnlargementL in there, NBPenis EnlargementL at best.
Once measured it was shorter than my regular NBPenis EnlargementL due the hassle with staying hard during the process.
Maybe viagra or something would have helped.
I will add some pictures later, the ones taken today morning were crap quality.
K.
