Hi everyone, first post but been a member for a while.
I decided that i was going to construct my own type of stretcher as i cannot afford some of the stretchers advertised on this and other sites. I have been using it for 2 weeks now for about 3 to 4 times a week. Too early to tell if any gains can be made from it.
The device is simple, easy and cheap to make. I have used two pieces of plastic drain pipe, a gutter runner outlet ( like a T piece) some kind of wrap and two cable clamps.
The most important thing are that you pick pipe that you can get your penis and a wrap at the top through. You then need another piece that will slide over with a good fit. Small holes ( 3 to 4 mm) are drilled straight up and down the inner pipe with gaps approximately 1 cm, at the N,S,E & W positions with the N,S being offset with the E,W by 5 mm. This forms the main part of the stretcher in that the inner pipe is pushed up and held in place by placing a stopper in the holes. The gutter runner outlet ( T piece) forms the base. Boil the kettle and put about 1 inch of water in a flat sink. Place the T piece in the water and push down gently, it should flatten out. You can now cut to shape. This will help to spread the pressure of the base of the pipes.
I find the best way to put this all on is to put the wrap on first just below the head of the penis and then secure with an elastic band. I then slide the base on then the inner pipe, outer pipe and finally push them down and put on a cable clamp over the wrap. I then put another cable clamp below the first, this may take some practice but 2 clamps hold far better than one.
I will try to get some pics up of the pieces and i hope it will make more sense.
I have had some good sessions with it so far with the clamps holding fine.
I decided that i was going to construct my own type of stretcher as i cannot afford some of the stretchers advertised on this and other sites. I have been using it for 2 weeks now for about 3 to 4 times a week. Too early to tell if any gains can be made from it.
The device is simple, easy and cheap to make. I have used two pieces of plastic drain pipe, a gutter runner outlet ( like a T piece) some kind of wrap and two cable clamps.
The most important thing are that you pick pipe that you can get your penis and a wrap at the top through. You then need another piece that will slide over with a good fit. Small holes ( 3 to 4 mm) are drilled straight up and down the inner pipe with gaps approximately 1 cm, at the N,S,E & W positions with the N,S being offset with the E,W by 5 mm. This forms the main part of the stretcher in that the inner pipe is pushed up and held in place by placing a stopper in the holes. The gutter runner outlet ( T piece) forms the base. Boil the kettle and put about 1 inch of water in a flat sink. Place the T piece in the water and push down gently, it should flatten out. You can now cut to shape. This will help to spread the pressure of the base of the pipes.
I find the best way to put this all on is to put the wrap on first just below the head of the penis and then secure with an elastic band. I then slide the base on then the inner pipe, outer pipe and finally push them down and put on a cable clamp over the wrap. I then put another cable clamp below the first, this may take some practice but 2 clamps hold far better than one.
I will try to get some pics up of the pieces and i hope it will make more sense.
I have had some good sessions with it so far with the clamps holding fine.
