I bought them on your website, all three sizes because I didn’t realize which one I would need.
Try to identify the three types of sleeves. You can go by feel as well. So, sort them out like this.
SiliSleev #2. Very soft, very flexible, great to use as the first layer in multiple layers of sleeves. I tend to use an old
SiliSleev #2 for softness and comforts. It can stretch out very well as an older
sleeve after using it for a while. Don't discard it if it happens to age, cinched, or break.
SiliSleev #5. Slightly thicker, but very flexible, soft, and easy to put on like #2. It's great as a first layer to use with the
SiliStretcher. The stiffer body can work with your needs to prevent overstretching. I tend to use it as the first layer to prevent slippage during hot days and on days I move a lot. If I need more traction, I use the
SiliSleev #5 as the first layer,
SiliSleev #2 as the upper layer because it's more flexible. These two combined will pull your penis enough to cause blister at 15lbs of pure traction.
DuroSleev. This is the thickest of the
sleeve. It doesn't yield much. It doesn't expand much. You need to be a freaking Hulk to stretch this out. BUT, it's great to use as an elongation
sleeve. If you purchased a loose
DuroSleev, don't roll it up and then roll it out. Try to slide your penis into it instead. Use a bit of lubricate of your choice to get it on. Once you have it on, fold the
sleeve back a bit and wipe off each end to create friction zones All you need is 1 to 1.5in on each end to have traction on your skin. I use a combo of
TheraBand and
DuroSleev to create the traction I need since I'm uncircumcised. Too much foreskin causes the
DuroSleev to slide and slip off my penis during flaccid state. Again,
DuroSleev is only used for elongation purposes, not for
SiliStretcher.
Once you know which sleeves you have, use them according to the needs.