My PE Journey

@Hiaslayer
respect to you sharing your experience with others with details
if you don’t mind:
how old are you ?
you didn’t used iR?
you didn’t used sleeves?
you didn’t used paba dmso?
you didn’t wear stretch device all the day?
you didn’t used testosterone cream or gel?
are sure you will keep the gains?
about the pressure pump how many minutes you are pumping every time?
about the pills there is regular pills in your protocol?
you doing it every day not day after day?

regards to you
and regards to mr dld
and regards to all admins here

I pump in the morning for 10min at -8inHg. During the day I try to get about 10min of jelquing and SSJ in. In the evening I do about 20-30min lengthmaster DBS (540) and a little bit of BTC. Afterwards I pump again for about 15min either Mityvac or bathmate. In combination with SSJ.

No ADS or any of the other stuff you mentioned. I only take 5mg tadalafil per day. I do about 4 days on 1 off. On my off days I do 1x10min recovery pumping at -5inhg.

I’m 38.
 
Just a quick update. I reached 22.5cm in the bathmate without much effort. As long as I go in errect, this seems to be my baseline measurement. I bought the vacuvin so I can get myself consistently to 23.5cm over the next 5 weeks until I measure again.

My lengthmaster sessions are getting better too. I bundle for 540 degrees now. I’m still not doing BTC stretches regularly and will only start with them after the summer once I can bundle for 720 degrees.

I also started to do the 5x5x3 more regularly in the morning.

Morning: 2x5min at -8inHg entering with full erection and after each set SSJ for about 3x30s

Before lunch: 10min dry jelq

Afternoon: DBS with lengthmaster for 15min (actual stretch time). Afterwards BM at full pressure

Recovery pumping to -5inhg for about 5min
 
When you first started bundling, what was the degrees of twist?
 
Is this set up correct? When I pump up to max pressure manually and then want to get more water out with the wine pump, it doesn’t work. The tube collapses but no water gets sucked out of the BM

Edit: I cut the tube so the black close lever of the BM is entering the valve of the vacuvin. When I’m at max manual pumping pressure, I then create a seal between BM and vacuvin and give it two pumps and that sucks some more water out. I need to keep the piston of the vacuvin pulled out as otherwise the safety valve of the BM lets air go back into the BM. Through the whole trial and error I pulled lots of edema today but tomorrow I’m sure it will be a more effective session.
 

Attachments

  • IMG_0102.webp
    IMG_0102.webp
    198.9 KB · Views: 5
  • IMG_0106.webp
    IMG_0106.webp
    153.6 KB · Views: 5
  • IMG_0105.webp
    IMG_0105.webp
    132.9 KB · Views: 5
Last edited:
Yes. More or less on the setup. Our brother SIM, and prior brothers that used the vacuvin method, had shorter tubing.
 
Help Users

You haven't joined any rooms.

    You haven't joined any rooms.
    Back
    Top