Bathmate mod

picture a 2"-3" piece of clear PVC fitting over the top of the BM tip, then the VV pump just fits at the end of the PVC...pump to your desired pressure and release by using your finger pressing the BM valve
 
Big Schwanz Acht said:
the PVC tubing is only 2"-3" so I just leave it on the BM...my finger can reach the BM valve w/the PVC still attached
Click to expand...
Okey I understand it now. I had problems to understand, how you release the vaccum, last time you explained this concept to me, thanks.
This will be better then my solution.

Need to remove the tape now, since the self-vulcanising tape, can really be hard to remove if you let it be on for to long.
 
just make certain that you get the proper size of PVC tubing, IIRC it's 7/8" inside diameter but maybe pring the VV pump to the hardware store to double check. I also warmed-up the tubing a bit to make it slide over the BM tip
 
Big Schwanz Acht said:
just make certain that you get the proper size of PVC tubing, IIRC it's 7/8" inside diameter but maybe pring the VV pump to the hardware store to double check. I also warmed-up the tubing a bit to make it slide over the BM tip
Click to expand...
I think I need to order the PVC tubing from internet. That's why I tried out my method with tape.

There are no more hardware stores in my town locally, that have these big rolls of different stuff (tubes and cables). This existed when I was a child. But no more. I'm lucky if I can find it locally. One store may have it...I need to check there.
 
Bassman44 said:
We shall see brother ! The hydro max has been good to me and I have seen results. Ready for the next step. Looking forward to a year from now and see how we are both looking 🤙
Click to expand...

How much of girth gains have you made so far brother?
 
You must log in or register to reply here.
Back
Top