Introduction

jayjaylo

Member
Registered
Joined
Nov 7, 2023
Messages
2
Sup everyone,

Found this website couple weeks ago when looking for tips/whatever on using bathmate while having a curved junk. Nice to see people sharing their experiences on this stuff.

I'm 23 yo. My dick is shaped the left about 30 degrees like a banana. That might be because of masturbation, but I think mine was already curved before that. It's just how my dick is shaped, so it has to be possible to shape it more straight.

BPL erect is about 18.5 cm / 7.28 inches, with a straight ruler.
BPL erect following exactly the right side of my dick (longest side, measuring with a tailor's ruler) is about 21.5~22cm / 8.46~8.66 inches.
Girth is about 13~13.5 cm / 5.12~5.31 inches.
BPL flaccid is about 12.5 cm / 4.92 inches.

My goals for now are
- girth to be 16.5+ cm / 6.50 inches.
- angle to be 10- degrees.
- BPL erect of 20.32 / 8.00 inches (with straight ruler).
- flaccid size BPL to be 17 cm / ... inches.
(maybe in the future try to create an upwards curve, idk; and maybe find some way to only increase the size a bit of the tip of my dick)

Basically increasing the girth as MUCH as possible, while straightening the dick.

I've been doing kegels and reverse kegels for about 13 weeks now, following a routine.

Been using bathmate for about 6 weeks now. While using the pump, the right side of midshaft and left side of the tip of my dick are getting squashed against the walls of the pump, causing pain. I'm using some lubricant, but I'm looking for a much better oilier slippery something to use, to avoid any friction inside the pump. This waterbased lubricant does not do that job. I'm going to try to turn the bathmate (while pumped/pumping) to the left, so the bathmate follows the curve. I'll have to apply force the whole time, but this might work so I can actually pump up my dick. I don't feel like I'm really pumping up my dick; the difference of dicksize after using bathmate is not that noticeable. I can't put a lot of pressure because of that pain.
The pain is primarily in the left side of the tip of my dick, kind of between the corona and neck of the penis.

I also have the Penimaster Pro, the full set. I was following a routine past June for the PMP. Last two weeks I used it for 50 hours, but after I had really bad stingy pains in the same area of the tip of my dick. While using the stretching device, the tip of my junk twists a bit and that area on the left side tip of dick seems all force to be applied on that. The shaft and the right side of my dick do not seem to get stretched. I did not warmup my junk before using the PMP. I'm going to try to have the vacuum part of the device not twist and just held in the same angle of both axis, so the applied force is distributed more equally.

I'll be posting what routines I'll be doing. Probably going to post later this week when I have put more time into researching the different topics on this website.

Any tips / advice / whatever is greatly appreciated! I'm looking to put around one hour a day into PE (not including stretching from PMP).


- jay
 
Sup everyone,

Found this website couple weeks ago when looking for tips/whatever on using bathmate while having a curved junk. Nice to see people sharing their experiences on this stuff.

I'm 23 yo. My dick is shaped the left about 30 degrees like a banana. That might be because of masturbation, but I think mine was already curved before that. It's just how my dick is shaped, so it has to be possible to shape it more straight.

BPL erect is about 18.5 cm / 7.28 inches, with a straight ruler.
BPL erect following exactly the right side of my dick (longest side, measuring with a tailor's ruler) is about 21.5~22cm / 8.46~8.66 inches.
Girth is about 13~13.5 cm / 5.12~5.31 inches.
BPL flaccid is about 12.5 cm / 4.92 inches.

My goals for now are
- girth to be 16.5+ cm / 6.50 inches.
- angle to be 10- degrees.
- BPL erect of 20.32 / 8.00 inches (with straight ruler).
- flaccid size BPL to be 17 cm / ... inches.
(maybe in the future try to create an upwards curve, idk; and maybe find some way to only increase the size a bit of the tip of my dick)

Basically increasing the girth as MUCH as possible, while straightening the dick.

I've been doing kegels and reverse kegels for about 13 weeks now, following a routine.

Been using bathmate for about 6 weeks now. While using the pump, the right side of midshaft and left side of the tip of my dick are getting squashed against the walls of the pump, causing pain. I'm using some lubricant, but I'm looking for a much better oilier slippery something to use, to avoid any friction inside the pump. This waterbased lubricant does not do that job. I'm going to try to turn the bathmate (while pumped/pumping) to the left, so the bathmate follows the curve. I'll have to apply force the whole time, but this might work so I can actually pump up my dick. I don't feel like I'm really pumping up my dick; the difference of dicksize after using bathmate is not that noticeable. I can't put a lot of pressure because of that pain.
The pain is primarily in the left side of the tip of my dick, kind of between the corona and neck of the penis.

I also have the Penimaster Pro, the full set. I was following a routine past June for the PMP. Last two weeks I used it for 50 hours, but after I had really bad stingy pains in the same area of the tip of my dick. While using the stretching device, the tip of my junk twists a bit and that area on the left side tip of dick seems all force to be applied on that. The shaft and the right side of my dick do not seem to get stretched. I did not warmup my junk before using the PMP. I'm going to try to have the vacuum part of the device not twist and just held in the same angle of both axis, so the applied force is distributed more equally.

I'll be posting what routines I'll be doing. Probably going to post later this week when I have put more time into researching the different topics on this website.

Any tips / advice / whatever is greatly appreciated! I'm looking to put around one hour a day into PE (not including stretching from PMP).


- jay
welcome to MOS jayjaylo
 
Thanks a lot for the replies, you guys immediately directed me to the good stuff

What do you guys think of my plan?

I've looked at quite a few things in the forums, including SRT, MOS DVD, FAQ with DLD, routines for length / girth / peyronies / bend etc, and other stuff. I also more observed my own dick to see what my situation is.

Upon further inspection, I consider the nonstraightness of my phallus to be more towards 40 degrees. There seems to be a bend and a curve. The bend is around after the first 1/3 of the shaft, after that it more or less curves at the same angle towards the left like a banana.

Another problem is tight frenulum. What might be a factor in why the shape is as it as. I remember it being so tight that I had never pulled my foreskin back (fully seeing the glans) till I was 16, maybe 17. I was actually scared to pull back my skin. I thought the tip of my dick would fell out. When I was like 3 years old, I pulled back the foreskin and I just remember the tip of my dick sort of falling out but being held by a thin thread of something and it hurt so fucking bad. My foreskin does not stay back on its own. Because of the bend/curve, the frenulum is twisted even more towards the left. So it's pulling the glans under an angle. When pulling back the foreskin, the frenulum pulls on my glans more in a twist downwards. So maybe this coupled with masturbation might have been (partly) the cause of the curve/bend.

I think it's best to focus on one thing at a time.


So here's roughly the plan:

Buy the loose underwear.

First I tie my own frenulum. Till I can pull back the foreskin all the way, without any discomfort. I think this will be essential in the future for girth gains. This frees the erection of my dick. I don't want a doctor to do it because I've seen some nasty shit of people getting a more barbaric/cruel quick frenuloplasty, not looking that aesthetic. From what I've read, tying the frenulum is a relatively easy thing to do on your own. My frenulum is not sensitive at all.

Secondly, I'll start a routine for making the turkey neck go away and make my ballsack hang lower. It's such a big difference visually when I pull the skin back at the base, my dick then actually looks big. The turkey neck might also be partly because of the tight frenulum I think. I'll start the routine during frenulum tying if possible, otherwise after. The routine will probably be everyday Testicle Health Massage and Stretch with wrapping the scrotum during the day, maybe also at night depending how it goes. Also when masturbating, I'll hold back the skin at the base, so I'm not stretching that out any further. I can't find Supra's or REDZULU's logs about these topics so if anyone has tips whatever about this, all is very much appreciated.

After tying frenulum, I want to focus mainly on correcting the angle. I'm thinking of using the same vacuumlike attachment like the SiliStretcher - All Day Penis Vacuum Stretcher and Weight Hanger, so that the tension is applied over the shaft, not the glans. The PenimasterPro vacuumthing sucks, but not in a good way. I can't wear that thing. I think buying something similar to that of the silistretcher and creating some sort of fulcrum of a certain diameter, might work with this. I could use the fulcrum in certain positions and use different fulcrum of different diameters maybe to see what gets the "right" stretch. More slow and steady constant tension many hours a day, instead of using LengthMaster - Penis Bundle Stretcher & Weight Hanging, I think I would get injuries with the LM for correcting the angle. I don't care that much about gaining length, but I think something like this would be the way to go about it.

And after that, just focus on girth mainly. Use bathmate + SSJ + cockring. RN I can't use Bathmate because of the angle. It's not comfortable at all, just causes pain.

Any feedback / ideas / thoughts about this is much appreciated. The routines themselves aren't that thought out yet, because I'll focus first on frenulum tying, but you get the big picture
 
Concentrate on the SRT routine. There is no routine that compares to SRT
 
Back
Top Bottom