How to maximize stretching without forcing blood into head

holosolo

Member
Registered
Joined
Apr 28, 2023
Messages
10
I've tried wrapping a few different ways. I'm currently doing a pre-wrap athletic tape around the shaft, then using the bandage that came with the LM. No matter how tight I wrap or how tight I get the LM bolts with the shaft in the middle, when I pull on the LM, it always moves towards the head, then stops before the head. The issue I'm having, I can't stretch too hard without blood coming out of the meatus. Is there a way to get the LM to not move towards the head? It has to be a wrapping technique I'm not picking up, no matter how tight it goes, I still have the same issue.

I want to maximize the stretch and need some assistance.

Suggestions?
 
I've tried wrapping a few different ways. I'm currently doing a pre-wrap athletic tape around the shaft, then using the bandage that came with the LM. No matter how tight I wrap or how tight I get the LM bolts with the shaft in the middle, when I pull on the LM, it always moves towards the head, then stops before the head. The issue I'm having, I can't stretch too hard without blood coming out of the meatus. Is there a way to get the LM to not move towards the head? It has to be a wrapping technique I'm not picking up, no matter how tight it goes, I still have the same issue.

I want to maximize the stretch and need some assistance.

Suggestions?
Simply wrap around the area that the length master will be touching. This should eliminate all of your issues.
 
Another tidbit that helped me- I was getting distended veins or soreness on the veins- bc I wasn’t clamping correctly. I was clamping without squeezing the gland of my dick down with the other hand if that makes sense

you want to force fluid out of your head- before you tighten it down. That way the fluid isn’t trapped between the LM and the last inch of your head etc
 
Another tidbit that helped me- I was getting distended veins or soreness on the veins- bc I wasn’t clamping correctly. I was clamping without squeezing the gland of my dick down with the other hand if that makes sense

you want to force fluid out of your head- before you tighten it down. That way the fluid isn’t trapped between the LM and the last inch of your head etc

Yes, I've tried this and it helps some, but the main issue still remains.
 
I'm not expert on wrapping for the Lengthmaster ³, but from what writings I read about clamping with the Lengthmaste ³. The objective is to get a bite on the CC chambers, otherwise the sheathing of the penis will slide in the direction of force, which is towards the Glans. If I recall correctly the @squirt_man may have the solution to your problem.
 
I've tried wrapping a few different ways. I'm currently doing a pre-wrap athletic tape around the shaft, then using the bandage that came with the LM. No matter how tight I wrap or how tight I get the LM bolts with the shaft in the middle, when I pull on the LM, it always moves towards the head, then stops before the head. The issue I'm having, I can't stretch too hard without blood coming out of the meatus. Is there a way to get the LM to not move towards the head? It has to be a wrapping technique I'm not picking up, no matter how tight it goes, I still have the same issue.

I want to maximize the stretch and need some assistance.

Suggestions?
Just keep practicing you’ll get the hang of it! Its probably more about how you tighten than your wrap.
 
Last edited:
Following up - I did take the advise of squeezing the head while clamping down, which provided a huge improvement in being able to apply more power to the stretch. I also clamped down a little harder than I normally have in the past, which also helped. I'll continue to fine tune what I'm doing, but so far an improvement. Thank you to everyone for the suggestions and @squirt_inducer_man for putting together a TON of valuable content on the site!
 
Back
Top Bottom