tell me what you guys think. I took half a euro-door hinge and screwed it to my desk. As you can tell I got to long of screws and didn't finish.
- What's new
- Forums
- Male Enhancement Forums by Matters of Size
- Members Section Forums
- Picture Proof: Penis Enlargement Pictures Forum
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
10 lbs Hanging SO setup
- Thread starter BiggerThanBefor
- Start date
Dashdeming
New member
Would be even better if you would use a one wheel pulley about 3" in diameter. With no pulley you get inconsistent pull due to the resistance.
BiggerThanBefor said:tell me what you guys think. I took half a euro-door hinge and screwed it to my desk. As you can tell I got to long of screws and didn't finish.
I don't know where to get a pulley from. Just let me know and i'll get one.
I tried the depot of home with no luck
Dashdeming
New member
Go to a marine supply store or order through the internet from westmarine.com or another.
BiggerThanBefor said:I tried the depot of home with no luck
thnx a lot bro reps for youDashdeming said:Go to a marine supply store or order through the internet from westmarine.com or another.
could you possibly find me a link? I looked with no luck
German Stallion
Super Moderator
http://www.homedepot.com/prel80/HDU...ID=ccdfaddgkfgmgkfcgelceffdfgidgnj.0&MID=9876
Here is a link to HOme Depot for a pulley. Go to their home site and type in Pulley and do a search. Works for me. GS
Here is a link to HOme Depot for a pulley. Go to their home site and type in Pulley and do a search. Works for me. GS
Last edited:
damn I was there too lol
how would you go about attaching that to a desk?
German Stallion
Super Moderator
BiggerThanBefor said:how would you go about attaching that to a desk?
Get and eye hook and open it a little and put the loop of the pulley in it. Get one big enough that you can fit it into the eye. You might need to pilot the wood on your desk to be able to screw the eye into the wood. GS
wtf did you just say?German Stallion said:Get and eye hook and open it a little and put the loop of the pulley in it. Get one big enough that you can fit it into the eye. You might need to pilot the wood on your desk to be able to screw the eye into the wood. GS
BTB this is the setup i use with a pulley wheel.
http://www.mattersofsize.com/forum/showthread.php?t=20523
http://www.mattersofsize.com/forum/showthread.php?t=20523
BiggerThanBefor said:wtf did you just say?
By pilot, he means to drill a small hole to put the screws in.
The hole you drill should be smaller than the screw in width, probably half as wide is good. When you have a pilot hole, the screw will go in straight, and not damage the wood as much. If you don't use a pilot hole, the screw could split the wood, or go in crooked.
Get some shorter screws too, those look dangerous. :O
lol yeah I know bro I got new screws this morning.