Not sure how to title this but regards to middle shaft.

So Sometimes when flaccid, the middle of my shaft somewhat looks like I’ve had a tight C ring on for too long. if I just massage it a little bit and do some keggles it goes away. Anyways I thought a while back I remember reading somebody had the same issue and there was a couple possible reasons why this happens from time to time..
 
Long hours of wear time kinked tissues, and as the tissues healed, the retained that odd shape until the tissues warmed up, expanded, and matched the remaining surrounding tissues. Using a cylinder to pump will restore the shape back in a few months.
 
Upvote 0
Long hours of wear time kinked tissues, and as the tissues healed, the retained that odd shape until the tissues warmed up, expanded, and matched the remaining surrounding tissues. Using a cylinder to pump will restore the shape back in a few months.
I totally understand what you’re saying, but I’m not sure that’s what the issue is as I don’t do any type of c-rings/restricting in the center of the shaft only.
I feel like it been like this a long time. It only does it once in a blue moon though..
I should snap a picture one time.
 
Upvote 0
I totally understand what you’re saying, but I’m not sure that’s what the issue is as I don’t do any type of c-rings/restricting in the center of the shaft only.
I feel like it been like this a long time. It only does it once in a blue moon though..
I should snap a picture one time.
A picture is worth a 1000 words. Let us know latter.
 
Upvote 0
So Sometimes when flaccid, the middle of my shaft somewhat looks like I’ve had a tight C ring on for too long. if I just massage it a little bit and do some keggles it goes away. Anyways I thought a while back I remember reading somebody had the same issue and there was a couple possible reasons why this happens from time to time..

When I was focusing exclusively on length work and wrapping with the ace bandage, I had this same issue. The mid shaft of my penis looked thinner.

Have no worries, by the time you switch to girth work, you won't notice it again. I think it happens because some gains are made from that mid shaft area.
 
Upvote 0
Back
Top