Glans pain using Silistretcher

[DLD]

No pumping or jelqing for a week ? I guess I'll have to stretch like a maniac.
And you've had success with the pin holes, @huge-girth right?

I’m sorry my brother but blisters do happen from time to time. I love your attitude that it’s time to get to work on length while you heal your blisters. Do not pop or prod the blister, allow it to drain itself. You can use hot compresses to speed the process but don’t do anything else as it will leave scars.

 

[JustGrow]

@jpgm1 Click the link below and scroll up or down until you see the pics.

I have been using this method for a while and it is working good for me. Sometimes I remove the white padding and just use tape and Silipad2 but the Silipad3 is going to really help when it’s out.

I also tend to use the Silicap but have tried with and without.

If I am going to use more tension then I don’t twist Silistretcher piston as much because the pull itself will create more suction.

Wearing for more than 1.5 hours is probably going to cause some fluid, so I tend to remove it at this mark and massage quickly for about 5 minutes and if glans is cold use MOSRed for additional 5 minutes then reapply if wearing longer. Doing this reduces amount of fluid for me.

Hope this helps

https://mattersofsize.com/threads/silistretcher-not-giving-me-soreness.1819007/page-2

 

[JustGrow]

Just got my Silistretcher2 over the weekend, and I am very happy with it LOL. But the only issue is the ALOT of water retention and I did experience some peeling skin and a blister. Im going to have to take a few days off. One thing that I did notice was that the durosleeve the was sucked into the strecher, so I guess their was too much suction.

@mil309 check the link out below. Scroll up or down until you see pics. This method might help you with fluid retention. I would try various options and see what works best for you. Silicap, no Silicap, Silipad, tape etc.

https://mattersofsize.com/threads/silistretcher-not-giving-me-soreness.1819007/page-2

 

[Dapper-Fapper]

if this is the case...why not have the silicap with a pinhole from the start if this is considered best practice???

 

[DLD]

if this is the case...why not have the silicap with a pinhole from the start if this is considered best practice???

Yes that is a smart way to progress and some of the sleeves are incorporating pin holes for the release of air in certain situations. @Lightning is the sleeve master, he should chime in.

 

[Lightning]

if this is the case...why not have the silicap with a pinhole from the start if this is considered best practice???

The SiliCap2 comes with a hole.