Mushroom Head and Glans Using PeniMaster Pro

[8branchtt]

Hi - I've been using the PeniMaster Pro for about a week now after giving up on RestoreX.

After removing the device, the head of my penis is enlarged by a factor of 1.5-2x, and the frenelum is swollen. Additionally, there was a visible ring around the bottom of the head of the penis; sometimes it is purple-ish. It's similar to a mushroom head you'd get after pumping but more localized.

See attached Photo #1 for a photo of the penis immediately after it was removed from the device and the purple ring. Approximately 1 hour after the device was removed, the head had shrunk but was still swollen. Additionally, there is a large, very unsightly bulge on frenelum/ glans (see Photos 2,3, and 4). I've also attached a photo of the device in use in case that helps.

Is this normal, or am I doing something wrong? Will ordering a larger sluice make a difference? Not sure I want to continue with this side effect.

HELP APPRECAITED. THANK YOU!

 

[squirt_inducer_man]

That seems to be horrible, do you have to use an extender to treat, Peyronie’s disease?
The only suction/vacuum extender, I have used was the Phallosan forte. It didn't work since the pressure was to high, I could not use their small glans caps and also the condoms was not comfortable. Some people it works for, I was not one of them.

For me it looks like the bell/cup, or what they are calling the part you have your glans inside, is to small and the glands expanded into the bell/cup=> The purple ring.

The water retention in your foreskin suggests that the pressure was high. How long did you wear this setup?

I hope someone with experience of this device could help here. I'm just trying to help with what I know from my experience with the Phallosan forte. I got bad water retention from that device.

 

[DLD]

Sounds and looks like fluid retention. Be sure to squeeze all blood out when you attach

 

[8branchtt]

Sounds and looks like fluid retention. Be sure to squeeze all blood out when you attach

Thank you! Will give that a shot.

That seems to be horrible, do you have to use an extender to treat, Peyronie’s disease?
The only suction/vacuum extender, I have used was the Phallosan forte. It didn't work since the pressure was to high, I could not use their small glans caps and also the condoms was not comfortable. Some people it works for, I was not one of them.

For me it looks like the bell/cup, or what they are calling the part you have your glans inside, is to small and the glands expanded into the bell/cup=> The purple ring.

The water retention in your foreskin suggests that the pressure was high. How long did you wear this setup?

I hope someone with experience of this device could help here. I'm just trying to help with what I know from my experience with the Phallosan forte. I got bad water retention from that device.

Thanks! I wore this for 4-5 hours for three days. I take it off every 60-90 minutes to pee and for a 5 minute break.

I may try a larger size for the latex piece they call the "sluice" that attaches to the bell/cup. The purple ring is not always there - I think it may depend on how much of the glans I suck into the sluice and cup so I may experiment with that.

However, the head is always enlarged and the frenelum swollen. I think that's always going to happen with these devices given how they work - your head will naturally expand inside the bell/cup to create the suction, right? Does anyone use a PeniMaster Pro and NOT have an enlarged head after each use?

I will try squeezing blood out before attaching as DLD suggested.

 

[DLD]

Let me know how that goes

 

[Roman851]

I had similar when using plallosan but with penimaster I noticed that head slips out when using their gel I spit and have no problem now. Try get out all air when attaching glans inside first make little bit air in so there is ass little air as possible and pull skin when attaching head inside.

 

[DLD]

I had similar when using plallosan but with penimaster I noticed that head slips out when using their gel I spit and have no problem now. Try get out all air when attaching glans inside first make little bit air in so there is ass little air as possible and pull skin when attaching head inside.

Nice work