Traction Use

Great to be here, and thank you for all the posts. I have scanned so many this month and they have been very helpful so far.
So I started with PE this month using the PF and QEP. Both have been going well.

Saturday I was able to use the PF for 8 hours between green and yellow with very little discomfort. I just flip side to side every few hours. Yesterday I used only the QEP and have been able to extend it to about my max the last few uses (learning curve). I have only used it for an hour a day in the past then the PF, but yesterday I went about 3.5 hours (not all at once) and was surprised that I was sore this morning. Not terrible, just sensitive and johnny feels a little worn out. When using the QEP yesterday I could elevate the attached device upward toward my belly button, but had to move it slowly since is it was such a tight stretch. I was curious if this is normal when starting out with traction devices or if I should go at a lower tension. Thank you guys for your advice.

I do like the PF app and I use it for time with both devices. I like that it tracks total time logged and average wear time. About 50 hours total in so far.

P.S. Before starting PE I decided to get a Brazilian... very painful, do not recommend. :-) Probably going back next month though. Haha!
 
Adjusting the extender in different ways will cause us to become more difficult to get into that position. But with constant trial-and-error you will get there.
 
Great to be here, and thank you for all the posts. I have scanned so many this month and they have been very helpful so far.
So I started with PE this month using the PF and QEP. Both have been going well.

Saturday I was able to use the PF for 8 hours between green and yellow with very little discomfort. I just flip side to side every few hours. Yesterday I used only the QEP and have been able to extend it to about my max the last few uses (learning curve). I have only used it for an hour a day in the past then the PF, but yesterday I went about 3.5 hours (not all at once) and was surprised that I was sore this morning. Not terrible, just sensitive and johnny feels a little worn out. When using the QEP yesterday I could elevate the attached device upward toward my belly button, but had to move it slowly since is it was such a tight stretch. I was curious if this is normal when starting out with traction devices or if I should go at a lower tension. Thank you guys for your advice.

I do like the PF app and I use it for time with both devices. I like that it tracks total time logged and average wear time. About 50 hours total in so far.

P.S. Before starting PE I decided to get a Brazilian... very painful, do not recommend. :) Probably going back next month though. Haha!
Do an update.
 
  • Like
Reactions: DLD
To update. I have switched to manuals once a day for 20 min, then a sili-sleeve. I have not used the QEP for a while but I still use the PF. I've found the most comfortable way to wear it is using a baby wipe folded in half between the ring and the shaft. I am not super consistent with the PF, mainly on the weekends when i do not have time for manuals. You can twist the PF once on and it tends to do a much better job stretching. I tend to retwist and extend after about 30 minutes. Then switch sides 2 hours each with a break in between.

I am up to about 7.25 from 6.75". In the pump I am hitting 7.75". I do not get much time to use it. Maybe once or twice a week if that. I have not measured Girth. That will be my project for 2025. I have the LM 3 but am still not super comfortable with it, that will be something for down the road.

I am not sure how much the PRP injection played into my benefits, but was already gaining before I had it a few months ago, I think in May. Flaccid is much better. Haven't measured but probably around 5. Worst shrivel is to 4 which was my previous longest starting point.
 
Back
Top