HydroXtreme 9 or 11

BigDonnie

New member
Hi All,

new to forum. I once owned a Goliath, I found it too wide but probably the best length for me. I didn’t like the girth of the Goliath and feel that a smaller diameter would have been better. maxing out when i pumped regularly at 24 cm. i doubt it contributed but I had three hernias repaired a few years after not using the pump... all that pulling over a wide area just seems unnecessary and maybe bad for the abdominal wall.

unassisted erection is somewhere within 8.5 and 9 inches, girth 6.5”. I once bought a standard vacuum pump with 9 inch tube and topped it out with a couple pumps. The official bathmate site says that 7-9 inche men should go with the HydroXtreme9 and bigger than 9“ with the 11. I guess I am borderline.The size charts on this site are not on the official site. this forum shows that the 9 is suitable for men at 8” with an inch to grow? shouldn‘t bathmate list the hm9 as being for men no longer than 8? I guess I’m hoping to find that the hm9 can accommodate 9 inch with room to pump and grow

my size puts any 9-9.5“cylinder out of the question. Ideally I would have 10” cylinder and 2.25 diameter....

unfortunately my size seems to disqualify me from other brands I have found.

any advise?
 
Hi All,

new to forum. I once owned a Goliath, I found it too wide but probably the best length for me. I didn’t like the girth of the Goliath and feel that a smaller diameter would have been better. maxing out when i pumped regularly at 24 cm. i doubt it contributed but I had three hernias repaired a few years after not using the pump... all that pulling over a wide area just seems unnecessary and maybe bad for the abdominal wall.

unassisted erection is somewhere within 8.5 and 9 inches, girth 6.5”. I once bought a standard vacuum pump with 9 inch tube and topped it out with a couple pumps. The official bathmate site says that 7-9 inche men should go with the HydroXtreme9 and bigger than 9“ with the 11. I guess I am borderline.The size charts on this site are not on the official site. this forum shows that the 9 is suitable for men at 8” with an inch to grow? shouldn‘t bathmate list the hm9 as being for men no longer than 8? I guess I’m hoping to find that the hm9 can accommodate 9 inch with room to pump and grow

my size puts any 9-9.5“cylinder out of the question. Ideally I would have 10” cylinder and 2.25 diameter....

unfortunately my size seems to disqualify me from other brands I have found.

any advise?

The Hydromax 9 would be your best bet to go with, you will have an inch you can gain in that tube. There is also less negative space in the nine over the goliath. But you may also want to look at the Mityvac and see if there is a set up that can work for you there.
 
Thanks for your reply. It’s the answer I was looking for. I want a pump but not at the diameter of the goliath and I haven’t found any other option. The mityvac onky comes in 9.25 inch cylinders. Are you 100% that the 9 would have an inch to work with? I am very close to 9”. The only reason I have doubts in what you and the latest on the bathmate is the chart posted early on this thread clearly shows 8 inches with an inch to grow not 9. Perhaps older models were smaller? bathmate doesn’t seem to publish anything like it on their site... anymore at least.
 
With your size I would consider getting in touch with the MoS Sales sales@mattersofsize.com for a longer Provac tube. That you could get in a suitable diameter but with extra length. To my best recollection it should be possible to make a special cylinder.
Doesn't hurt to ask! :-)

What are your goals? Just curious ... ;)
 
Thanks for the reply. My goals arent to necessarily get bigger but rather erection health and strength. I have found that I could use more strength at the base.... doing Some research on that. My gf used to get a kick out of my pumped penis... sorta like having two boyfriends... lol
 
The Hydromax 9 would be your best bet to go with, you will have an inch you can gain in that tube. There is also less negative space in the nine over the goliath. But you may also want to look at the Mityvac and see if there is a set up that can work for you there.
Any feedback on why the charts posted (by you actually) show the hydromax9 being suitable only for 8”r and not 9” like you state here and as bathmate now states on their website? Perhaps size changes in later models?
 
Thanks for your reply. It’s the answer I was looking for. I want a pump but not at the diameter of the goliath and I haven’t found any other option. The mityvac onky comes in 9.25 inch cylinders. Are you 100% that the 9 would have an inch to work with? I am very close to 9”. The only reason I have doubts in what you and the latest on the bathmate is the chart posted early on this thread clearly shows 8 inches with an inch to grow not 9. Perhaps older models were smaller? bathmate doesn’t seem to publish anything like it on their site... anymore at least.

I actually think you should go with 11 now really thinking about it. The tube is practically the same width as the nine but it will give you more room to grow. A shark in a small tank will never get bigger than the tank but you put that shark in a bigger tank it will grow.
 
Long time update: Went with the 9. I will admit that I am 9+ when fully pumped. when i top it out it’s not really comfortable so I guess i might have a little room to grow... what I am looking for is a routine for erection health and strength.... my erection is weak at the base... would Like to change that.
 
I don’t need to be any bigger. I’ve been with at least 100 women and I have always been the biggest they've had. I‘m 46... who doesn’t want to get raging hard on’s pointing directly north like an 18 year old all the time. 8-)
 
Long time update: Went with the 9. I will admit that I am 9+ when fully pumped. when i top it out it’s not really comfortable so I guess i might have a little room to grow... what I am looking for is a routine for erection health and strength.... my erection is weak at the base... would Like to change that.

I do a 6 min using warm/hot water at high pressure starting flaccid and only start the timer once its max erection and vacuum.
I then go and release the pressure but I keep the bathmate in the same position and pull it off just enough to pour water that I melted ice in.. push the bathmate with my hands as tight as possible (how i lessen gator bite all over random spots) then use my hand pump to slowly get it to pressure and once i'm erect I lay down so when I release some pressure so its just like half max my penis is still submerged in cold water... I do two of these sets each 5 min and repeat the steps for the final set.
 
I do a 6 min using warm/hot water at high pressure starting flaccid and only start the timer once its max erection and vacuum.
I then go and release the pressure but I keep the bathmate in the same position and pull it off just enough to pour water that I melted ice in.. push the bathmate with my hands as tight as possible (how i lessen gator bite all over random spots) then use my hand pump to slowly get it to pressure and once i'm erect I lay down so when I release some pressure so its just like half max my penis is still submerged in cold water... I do two of these sets each 5 min and repeat the steps for the final set.

Very interesting way to go about it. Gator bites were such a big issue and I haven’t heard about it for so long. I’m glad that you’ve come out with a message that will help people. Do you find the difference between the cold water and the hot water as far as extension goes?
 
General chit-chat
Help Users
  • MoS Notifier MoS Notifier:
    Guest Sam hi has joined the room.
  • S (Guest) Sam hi:
    How's everyone
    Quote
  • oldandlively @ oldandlively:
    @sam hi, good to see you brother. Post in the forum and we'll chat more.
    Quote
  • MoS Notifier MoS Notifier:
    Akteon1 is our newest member. Welcome!
  • MoS Notifier MoS Notifier:
    Guest Jayson44 has joined the room.
  • J (Guest) Jayson44:
    hi
    Quote
  • J (Guest) Jayson44:
    Out of sheer curiosity, is anyone interested in having a premature O together while we watch videos?
    Quote
  • J (Guest) Jayson44:
    Anyone wanna cum to asians twerking or kpop vids
    Quote
  • Akteon1 @ Akteon1:
    Hi. Good to be here.
    Quote
  • oldandlively @ oldandlively:
    @Akteon1, good to see you here. Join us into the forum.
    Quote
  • Akteon1 @ Akteon1:
    Which forum? How do I get there?
    Quote
  • Quote
  • MoS Notifier MoS Notifier:
    McDong is our newest member. Welcome!
  • Akteon1 @ Akteon1:
    I was approached by a coach from a Nigerian phone number?
    Quote
  • MoS Notifier MoS Notifier:
    gabrieljones is our newest member. Welcome!
  • oldandlively @ oldandlively:
    @Akteon1, visit other sub forums to check out all the info in PE. Forum list
    Quote
  • oldandlively @ oldandlively:
    More importantly, see the first three posts in this sub forums to answer most of your doubts and questions: Ask questions
    Quote
  • MoS Notifier MoS Notifier:
    tbean750 is our newest member. Welcome!
  • MoS Notifier MoS Notifier:
    Guest pedguin has joined the room.
  • P (Guest) pedguin:
    Hello Im looking into getting an ADS and some stretcher what would you guys recommend
    Quote
  • H @ huge-girth:
    pedguin said:
    Hello Im looking into getting an ADS and some stretcher what would you guys recommend
    Sign-up on the forum. Buy the length master and the Silistretcher both from the MOS shop
    Quote
  • P (Guest) pedguin:
    ive been looking at the silistretcher for over half a year, and will look into the length master thank you.
    Quote
  • MoS Notifier MoS Notifier:
    silverberg is our newest member. Welcome!
  • MoS Notifier MoS Notifier:
    thescholarjt is our newest member. Welcome!
  • MoS Notifier MoS Notifier:
    mos is our newest member. Welcome!
      MoS Notifier MoS Notifier: mos is our newest member. Welcome!
      Back
      Top