Silistretcher and uncut

Hazardous169

0
Registered
Joined
Jul 12, 2011
Messages
4
Hey guys after some advice after trying other devices over the years before I buy my silistretcher, I'm uncut and have quite a but of excess skin, I'm worried as per previous ones my roll back is just going to slide forward which is going to cause everything to roll forward and cause the device not to work or cause issues, is there anyone else in the same boat that has success or can give me some advice,
 
I know what you mean, being uncut myself.

However, you can still use these types of things without folding the skin back.

I've used the silistretcher that way.

You will feel more restriction near the underneath at the base due to some skin stretch, which actually isn't bad.

What I suggest, is once you've got setup in the equipment, the head inside, you grip around the scrotum, and pull that towards the ground, while with the other hand gripping the shaft about one inch beneath the SS and pull in the opposite direction.

This worked for me using anything that attached to my penis when performing a stretch, and what it does is release the tension, so you aren't stretching too much skin.
 
I know what you mean, being uncut myself.

However, you can still use these types of things without folding the skin back.

I've used the silistretcher that way.

You will feel more restriction near the underneath at the base due to some skin stretch, which actually isn't bad.

What I suggest, is once you've got setup in the equipment, the head inside, you grip around the scrotum, and pull that towards the ground, while with the other hand gripping the shaft about one inch beneath the SS and pull in the opposite direction.

This worked for me using anything that attached to my penis when performing a stretch, and what it does is release the tension, so you aren't stretching too much skin.

Excellent response!
 
I know what you mean, being uncut myself.

However, you can still use these types of things without folding the skin back.

I've used the silistretcher that way.

You will feel more restriction near the underneath at the base due to some skin stretch, which actually isn't bad.

What I suggest, is once you've got setup in the equipment, the head inside, you grip around the scrotum, and pull that towards the ground, while with the other hand gripping the shaft about one inch beneath the SS and pull in the opposite direction.

This worked for me using anything that attached to my penis when performing a stretch, and what it does is release the tension, so you aren't stretching too much skin.
Thanks, however I don't fully understand, I can't do this all day if wearing as a ads or when hanging for a hour,
 
Thanks, however I don't fully understand, I can't do this all day if wearing as a ads or when hanging for a hour,

I do not understand the question can you rephrase it?
 
I'm uncut myself and have had no problems using the Phallosan Forte, which is identical in application to the silistretcher. Simply pull back the foreskin, put on the silicap and then when you roll the sleeve down, just pull the foreskin gently back as you unroll. Don't pull the skin back too much though, as you need to allow for the stretch as you apply tension. No problem at all. And it prevents elongation of the foreskin which I certainly did not want and it sounds like you probably don't want either.
 
Last edited:
Sorry I didn't understand what ykh mean in regards to pulling down the scrotum etc as to when do I do it when ads, I can't have my hands down there all day

You wouldn't have your hands down there all day ? that is done at the start before you cover up, and only needs to last a few minutes.

It's done to release trapped skin, to ensure that once the device does it's job, excessive skin is not being pulled, as now you will have adjusted that by the stretch.
 
I’m glad everything was worked out perfectly
 
@Hazardous169 I am also uncut and have been using the Silisctretcher for about 120 hours in 1 to 2 hour increments for about 4 to 5 months and it is just a small learning curve once you get started.

I have not tried the skin forward method, but what I usually do is pull for skin back like mentioned above and then put on the Silistretcher.

This link below might help, look for the pictures and description on how to put on the Silistretcher.

There may be other methods for putting it on, but this is how I put it on since I have foreskin and it is not bad at all.
The members here are very helpful and will always have an answer for you.

I have gained about 1/2 an inch since starting Jan 2019 at the MOS website with the brotherhood and using manual stretching and Silistretcher for healing.

I think you will like the Silistretcher.
By the way I had a noose type extender before and the Silistretcher is way more comfortable in case you are wondering.
Start slow and then increase tension as you go.
Good luck brother.

 
@Hazardous169 I am also uncut and have been using the Silisctretcher for about 120 hours in 1 to 2 hour increments for about 4 to 5 months and it is just a small learning curve once you get started.

I have not tried the skin forward method, but what I usually do is pull for skin back like mentioned above and then put on the Silistretcher.

This link below might help, look for the pictures and description on how to put on the Silistretcher.

There may be other methods for putting it on, but this is how I put it on since I have foreskin and it is not bad at all.
The members here are very helpful and will always have an answer for you.

I have gained about 1/2 an inch since starting Jan 2019 at the MOS website with the brotherhood and using manual stretching and Silistretcher for healing.

I think you will like the Silistretcher.
By the way I had a noose type extender before and the Silistretcher is way more comfortable in case you are wondering.
Start slow and then increase tension as you go.
Good luck brother.


Awesome response my brother thank you so much for helping out, your altruism does not go unnoticed. ❤️
 
Back
Top Bottom