PLYOMERICS Question

channel7

Member
Joined
Jun 13, 2003
Messages
388
So basically the Plyomerics is based on push-ups. So basically I perform the DLD Blaster and then in order to do the Plyomerics. I start pulling the stretch in jerk movements over my arm at 1 second reps over and over again.

Is this correct? I just want to be sure.
 

DLD

doublelongdaddy
Joined
Jun 3, 2003
Messages
116,422
channel7 said:
So basically the Plyomerics is based on push-ups. So basically I perform the DLD Blaster and then in order to do the Plyomerics. I start pulling the stretch in jerk movements over my arm at 1 second reps over and over again.

Is this correct? I just want to be sure.
PLYOMETRICS are best done pre-stretch . Also, you can use any stretch position not just A-Stretches . I actually prefer to do the straight down.
 

Godsize

Active member
Joined
Jun 18, 2003
Messages
1,201
Isn't any kind of "jerking" motion during stretching bad?

By the way, I was doing those "Pulse 110" stretches just now and I got a lig pop I think. This one hurt a little bit, though. No harm done.
 

DLD

doublelongdaddy
Joined
Jun 3, 2003
Messages
116,422
Godsize said:
Isn't any kind of "jerking" motion during stretching bad?
It is dangerous by most theory out there on Penis Enlargement and this is why I gave a explicit warning on the dangers of PLYOMETRICS. I have been doing these 3 times a week for close to 1.5 months with no injury.

Godsize said:
By the way, I was doing those "Pulse 110" stretches just now and I got a lig pop I think. This one hurt a little bit, though. No harm done.
A POP that hurt...does it still hurt?
 

Godsize

Active member
Joined
Jun 18, 2003
Messages
1,201
No. It hurt for like a second, but not anything major like an injury. The pop came from the top side of my dick at the base. Other pops I've gotten were painless and seemed to come from within the base of my cock and off to the side a little bit.

I'm fine though, I continued with my stretching after that with no problems. Thanks.
 

channel7

Member
Joined
Jun 13, 2003
Messages
388
Thanks for the post fellows
 
Top Bottom