Testah

0
Registered
Joined
Dec 4, 2014
Messages
8
Hey all. I have run into a little issue with a couple things. I'll start with number 1; I am uncircumcised and when I am starting out with the Bathmate I was using it flaccid, or barely erect (maybe 5%) but as soon as I place myself into the Bathmate my foreskin stops being retracted and covered the head again. This ends up in reducing the effects the pump would normally have on the head, as I increase pressure the skin retracts - But not enough; Only half way and when I finish and take the pump off there is a ring where you can see where the foreskin was sitting and the head is more raised above the line than below it. Any thoughts on how to tackle this without going in medium/highly erect?

My second problem is my penis is angled. Not bent or curved but it's as if the ligament on one side is tighter then the other because my penis "rests" towards one side and if I try to push it towards the opposite side it will spring back towards the other side. It is perfectly straight but leans to one side annoyingly. So when I use the bathmate my penis always ends up touching one side (the left side it leans to) and I have tried readjusting the pump on different angles and trying to enter into the bathmate holding myself pushing more towards the opposite side but it does nothing to fix the problem...


Anyone got any tips? <:(

Sorry for the long posts.
Thank you for reading.

TL;DR: #1 I am uncircumsized and foreskin doesn't fully retract when using bathmate causing less efficient use. #2 My penis is angled/leaning towards the left side (not bent or curved) and tends to push up against the left side of the pump and nothing I've done counteracts it. Any help?
 
Well if i did read correctly what you need is a good erection while you are using the bathmate everytime you use it you have to get your penis hard,you can visulize sexx scenes and things that would get you hard.

If your penis is leaning towards to the left maybe jelquins can help you out...
 
Try going into the tube 100% erect you will get much better expansion. Also stop worrying about your foreskin and erection angle! I promise you those two things will have zero effect on your pumping session. It is clearly a mental thing that may be unattractive, but it won't change the quality of your bm sessions. Good luck
 
shortdick;636012 said:
Well if i did read correctly what you need is a good erection while you are using the bathmate everytime you use it you have to get your penis hard,you can visulize sexx scenes and things that would get you hard.

If your penis is leaning towards to the left maybe jelquins can help you out...

I was following a beginner routine which says when you first ever use the Bathmate for the very first time you should start flaccid for the first week and a half and then move up to 50% for a week, then 70% the next week and finally 100% the week after that.

Thanks for the tip about jelqs. I'll see if it makes a difference.
 
acromegaly;636015 said:
Try going into the tube 100% erect you will get much better expansion. Also stop worrying about your foreskin and erection angle! I promise you those two things will have zero effect on your pumping session. It is clearly a mental thing that may be unattractive, but it won't change the quality of your bm sessions. Good luck

The issue wasn't not getting enough expansion.

And my foreskin being over my head does have an effect as hours after using the pump I can still see a defined line where the head is raised where it was exposed(above the foreskin) and everything underneath the foreskin half way on the head is not raised at all; Because of the foreskin not being retracted.

Thanks.
 
well i just started using it whit my penis erect,but maybe starting flaccid would be to get the penis use to the device..
 
I'm getting extremely frustrated with this. So I tried going in both near full and fully erect and I still have the same issues. Foreskin gets pulled over the head so the head has basically no expansion; Only rarely can I get the skin to stay back but this is where the next problem comes in. My penis pushes starts to push up against the side of the pump so my glands are actually pressed right up against it on the left side.

When my penis is pushing up against the side of the pump and as I increase the pressure it just pushes harder and harder against the side causing PAIN where it is pushing against the side of the pump. I can't seem to make myself go in and stay straight. This sucks and is upsetting because I can really see how this pump would work great yet I can't even pump to a good pressure because it pushes against the side causing pain and when the skin doesn't retract the head has zero expansion AND is in pain.
 
Wish I could help. I had a bad lean and curve and the bathmate has made it worse so I'm stopping for now. Other people have corrected theirs with pumping so YMMV. I always used a splash of baby oil to not stick to the sides so that might help you.
 
I would still go in fully erect, but cut down your time to 5 min in the pump sets with jelqing in between. Eventually your penis will get conditioned and it will not hurt. Hot water should protect your skin but if your glans still stick to the tube use lube like ma999 suggested. I wish you luck, the bathmate is a very enjoyable experience. You might even learn to enjoy having your foreskin big and pumped.
 
acromegaly;636465 said:
I would still go in fully erect, but cut down your time to 5 min in the pump sets with jelqing in between. Eventually your penis will get conditioned and it will not hurt. Hot water should protect your skin but if your glans still stick to the tube use lube like ma999 suggested. I wish you luck, the bathmate is a very enjoyable experience. You might even learn to enjoy having your foreskin big and pumped.

Excellent advice!
 
Back
Top Bottom